Speco O2B2 User manual
O2B2
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 2
Note
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules These limits are designed to provide
reasonable protection against harmful interference in a residential installation This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications However, there is no guarantee that interference will not occur in a
particular installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into and outlet on a circuit different from that to which
the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Directions
DirectionsDirections
Directions
Be careful not to cause any physical damage by dropping or throwing the camera Especially
keep the device out of reach from children
Do not disassemble the camera No after service is assumed when disassembled
Use only power adapters compatible with the unit
Be careful to prevent moisture or water penetration into the unit Particular attention is
needed when installing the unit The screw holes for the installation screws and pipe should
be maintained water tight during the whole life time of the product
All the electrical connection wires running into the unit should be prepared so that water from
the outside cannot flow into the unit through the surface of the wires Penetration of the
moisture through the wire for extended period can cause malfunction of the unit or
deteriorated image
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 3
Revision History
Date Revision Details
Oct 25
th
, 2013 1.0 First manual revision creation.
Nov 7
th
, 2013 1.1 Text revisions
Mar 7
th
, 2014 1.11 Minor revision
Caution
Any changes or modifications in construction of this device which are not explicitly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 4
Contents
1.
Introduction .................................................................................................................................................... 5
1.1. Overview ................................................................................................................................................... 5
1.2. Specifications............................................................................................................................................ 6
1.3. Applications of O2B2 ................................................................................................................................ 7
2.
Product Description ...................................................................................................................................... 8
2.1. Contents ................................................................................................................................................... 8
2.2. Product Preview........................................................................................................................................ 8
2.3. Physical description .................................................................................................................................. 9
2 3 1 External View 9
2 3 2 Dimensions 9
2 3 3 Connector Information 10
2.4. Functional Description ............................................................................................................................ 11
3.
On Site Installation ...................................................................................................................................... 14
3.1. Ceiling or Wall Installation ...................................................................................................................... 14
4.
Getting Started ............................................................................................................................................. 15
4.1. PC Requirement ..................................................................................................................................... 15
4.2. Quick Installation Guide.......................................................................................................................... 16
4 2 1 Connect PC and O2B2 to network 16
4 2 2 Install Speco-NVR 16
4 2 3 Remote video connection to O2B2 19
4 2 4 Additional settings through connection to the Admin Page 21
5.
Troubleshooting........................................................................................................................................... 22
5.1. No power is applied ................................................................................................................................ 22
5.2. Cannot connect to the Video ..................................................................................................................23
5.3. Windows Vista or Windows 7 .................................................................................................................24
5.4. Technical Assistance............................................................................................................................... 27
Appendix A– Important Notice in Exchanging SD Card (Micro SD).........................................................................28
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 5
1. Introduction
1.1. Overview
The O2B2 is multi-codec (H.264, MJPEG) professional bullet IP camera built with embedded software and
hardware technology. It enables real time transmission of synchronized video of up to 1080p and audio data.
Remote clients can connect to O2B2 for the real time video/audio data through various client solutions running
on PC or smart device. Real time 2-way communication is available through bidirectional audio communication
feature.
Designed to be a stand-alone streaming audio & video transmission device, O2B2 can be applied to various
application area such as video security, remote video monitoring, distance education, video conference or
internet broadcasting system.
Vandal resistant and weather proof housing will extend the application area to harsh environment
of wide temperature range
Integrated PoE (Power over Ethernet, IEEE 802 3af) will enable the owner to reduce the total cost
of ownership by reducing on-site wiring for the installation
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 6
1.2. Specifications
Category Sub-Category Details
Video Compression H 264 / MJPEG
Resolution 1920 x 1080
Audio
(Bi-directional)
Up 32 Kbps G 726
Down 64 Kbps PCM
Network
Interface RJ-45, 10/100 Mbps
Access network Static, DHCP, PPP/PPPoE
Application RTP, RTSP, SMTP, FTP, HTTP, SDP, NTP, DNS
I/O
Sensor In 1 NC, NO Selectable
Relay Output 1
RS-232C N/A
Mic/Line In Selectable in Admin page
Line Out 1 V p-p output for amplified speaker
Power Supply
PoE Power over Ethernet (IEEE 802 3af)
DC Adapter 12V DC adapter (1 Amp)
Housing IP66 compliant
Motion Detection 3 zones Arbitrary shape with independent sensitivity
Upgrade Firmware upgrade over IP network
Administration Remote administration over IP network
Client & Viewer
Web Viewer Internet Explorer 8 and up
VMS Speco NVR (Windows)
Dynamic IP
support DDNS support Speco DDNS (free of charge)
Security
Video/Audio stream encryption
ID and Password protection
IP filtering for restricting administrative
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 7
Time management
Sync to PC Synchronize to PC
Manual Manual time setting
Internet Time
Server Synchronize to Time Server
SDK support
Active-X
Supported
HTTP
Supported
1.3. Applications of O2B2
Security surveillance (buildings, stores, manufacturing facilities, parking lots, banks, government facilities,
military, etc.)
Remote monitoring (hospitals, kindergartens, traffic, public areas, etc.)
eleconference (Bi-directional audio conference). Remote Learning, Internet broadcasting
Weather and environmental observation
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 8
2. Product Description
2.1. Contents
The product package contains followings :
Contents Description Remarks
Main Unit O2B2
Accessories
CVBS Cable 1EA
Screws (3 pieces of 1 type)
Anchors (3 pieces of 1 type)
L-type wrench with six angles 1EA
CD Software & User’s Guide
Quick Reference Guide Quick installation guide
2.2. Product Preview
O2B2 IP Installer VMS Software
(Speco NVR)
Main Unit PC software to allocate an IP
address to the IP Camera
PC software to view and record the
A/V streaming data transmitted from
IP camera.
(Simultaneous support of up to 64
IP cameras@D1)
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 9
2.3. Physical description
2.3.1. External View
Figure 2-1. External view of O2B2
2.3.2. Dimensions
Unit : mm
Figure 2-2. Dimensions
O
O2
2B
B2
2
U
Us
se
er
r’
’s
s
G
Gu
ui
id
de
e
Rev.1.11 (Mar. 2014) 10
2.3.3. Connector Information
Figure 2-3. Connector information
Network (LAN)
Power
Sensor Input (white(+), Red(-))
Relay Output ( lack(+), Yellow(-))
Mic/Line Input
Line Output
Table of contents
Other Speco IP Camera manuals
Speco
Speco O2FD4M User manual
Speco
Speco O2BFR User manual
Speco
Speco Intensifier OiMD1 User manual
Speco
Speco O2DP9 User manual
Speco
Speco Intensifier O2iTC23 User manual
Speco
Speco O2P4X User manual
Speco
Speco O2VLB2 User manual
Speco
Speco O2VLB2 User manual
Speco
Speco VLDT3WM User manual
Speco
Speco O2D60M User manual
