Rohnson R-434 User manual
R-434 Rohnson
Instruction Manual
Please read all instructions carefully before using
Diagram of name and position of main components
1. Pushing bar
2.Transparent cover
3. Juicing net
4. Middle ring
5. Handle
6. Residue barrel
7. Main machine
8. Juicer jug
Performances
1.For the juicer with large diameter , entire apple or pear can be put
in for juicing, no cutting apart needed, easy and quick.
2.Design is fine, simple, and beautiful, with combined structure,
easy to operate and clean.
3.High speed electric motor with overheating protection is adopted,
high efficiency , time saving, energy saving, high service life of
the motor .
4.Safety lock unit for switching is specially designed, in order to
make sure safety and reliability in use.
At t e n t i o n b e f o r e u s i n g
1.This machine is set with safety unit, when the handle does not
fasten the cover or the cutter seat is not fastened, the motor cannot
turn, so as to ensure safety for the user .
2.When disassembling or assembling the juicer, press the upper
of feed port of the cover with your hand, then force the handle
to slide in or out of cover slot.
3.When disassembling juicing net, first remove the cover and residue
barrel , then turn the middle ring up to 30 degrees by holding juicing
nozzle with your hand, and take up, t he juicing
net will automatically
leave the rotor .
4.In order to avoid damage, before using, first check power supply
for compliance with rated voltage .
5.Clean all parts able to disassemble (refer to the section of
"maintenance and cleaning").
6.When assembling, please carefully read the diagram of "name
and position of main components".
7.Please carefully read the "attentions" before using.
J u i c i n g
1.Before using, please confirm the button switch of the main machine
in stop state, in this way , in case assembly is not completed,
starting the main machine can be avoided, so unnecessary
damage for persons or property avoided.
2.Before juicing, first confirm juicing net and rotor clutched in position,
and no hard contact between juicing net cutter and transparent
cover . Put the transparent cover on, put the handle into the cover
slot, then turn on the machine.
3.For using, assemble according to the diagram of "name and
position of main components". Turn on power supply , press
switch to let the machine run no-load for 5 sec. Put prepared
vegetable or fruit into feed port of the juicer, press with the
pushing bar, evenly , hard and slowly , juice of the vegetable or
fruit can be found, original, fresh, good for health.
4. Note: when pressing food with the pushing bar, force shall be
even or indirect, pressing force shall not be more than 1 kg, no
too sudden force, otherwise, juicing effect will be reduced.
Op e r a t i n g t i me
This machine is designed with button switches of O grading, I
grading, II grading (O for stop, I for weak grading, II for strong
grading). For juicing, select strong grading, for operating time,
after operating for 1min, stop for 1min, then use again. After the
above operation is performed for three times, stop for 15 min, do
not operate until the motor is cooled, in this way , service life of
this machine will be prolonged, the machine will serve you more
efficiently .
At t e n t i o n s
1.This machine is unavailble for the weakness, unresponsive or
psychopathic person(including children), unless under the direction
or help from the person who have the responsibility for security .
Children should be overseen, so it can be testified that they are
not playing with it.
2.Before using, put this machine on a stable and even table
board,
operate according to the above methods.
3.Before juicing, first confirm juicing net and rotor clutched i n position,
and no hard contact between juicing net cutter and transparent
cover . Put the transparent cover on, fasten tight the handle, then
turn on the machine.
4.Before being used, the motor works in running-in phase, there
may be slight peculiar smell and spark, this is normal, after the
mot or works for some period, the above phenomenon will
disappear .
5.During juicing, make sure there is not too full juice and residue
in the middle seat and residue cup, if too full, please cut off power
supply , clean up, then use again.
6.During using, do not open the cup cover. In case power supply
is on, do not put hand or any ware into the mixing cup or feed
port, otherwise, harmful accident may occur or this machine may
be damaged.
7.In order to prolong service life of this machine, over-temperature
protective device is mounted in the motor. If the motor works for
a long time or overloaded, when over warning temperature,power
supply will automatically cut off. After the motor stops, pull out
plug of power supply , wait for the motor to cool (about for 30
min), use again.
8.During operating, please do not leave, never let children operate
this machine.
At t e n t i o n s
9.When this machine works in mixing, mincing or grinding conditions,
no-loaded or over loaded work is strictly prohibited.
10.After operation, do not pour the food out until pull out the plug
of power supply .
1 1.Cutters are very sharp, in order to avoid danger , when cleaning
a cutter, please put the cutter under water tap for washing, do
not wash it with hand.
12.This machine must not be used for others beyond regulated
purposes.
13.In case of damaged power supply cord, in order to avoid
danger, replacement must be performed by the manufacturer
or its service department or similar professional persons.
Ma i n t e n a n c e a n d c l e a n i n g
1.This machine shall be often used, so as to keep the motor dry
and clean.
2.If not using for a long time, please store this machine at a dry
and well-ventilated place so as to prevent the motor from being
damped and going moldy .
3.No washing the main machine. When cleaning, only wipe with
wet cloth. Other components may be washed directly with
water,such as pushing bar , cover , middle seat, residue cup, juice
nozzle cover.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH
EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or to a dealer
providing this service.
Disposing of a household appliance separately avoids possible negative consequences for the
environment and health, deriving form inappropriate disposal and enables the constituent
materials to be recovered to obtain significant savings in energy and resources. As a reminder of
the need to dispose of household appliances separately, the product is marked with a
crossed-out wheeled dustbin.
Table of contents
Other Rohnson Kitchen Appliance manuals
Popular Kitchen Appliance manuals by other brands
Tayama
Tayama TYG-35AF instruction manual
AEG
AEG 43172V-MN user manual
REBER
REBER Professional 40 Use and maintenance
North American
North American BB12482G / TR-F-04-B-NCT-1 Assembly and operating instructions
Presto
Presto fountain popper instruction manual
Westmark
Westmark 1035 2260 operating instructions
