- 4 -
English
1.3 Product Notes and Precautions
The LI-180 Spectrometer is a high-precision instrument.
Please unpack with care. Any vibraon or collision may cause
instrument damage. If the product doesn’t work normally or
needs repair, don’t aempt any repairs. All repairs must be
performed by authorized technicians.
Most LCD screens have a very small and inconsequenal
defecve pixel rate (usually less than 0.1%). This results in
occasional pinpoints of white or other colors but will not
affect the accuracy of measurements.
1.
2.
Precautions / Warnings
Please read the following precauons to avoid fire, excessive
heat, chemical leakage, and explosion:
Do not disassemble or modify the baery.
Do not expose the baery to heat (fire) or water/moisture.
When disposing of used/old baeries, wrap with insulaon
tape to shield the baery from electrical contact with
metallic objects, which might ignite a fire or explosion.
If the unit is plugged into the power adapter and the baery
seems to be overheang, or if there is smoke or peculiar
odors emanang from the unit, unplug immediately to avoid
the possibility of fire.
Do not touch the cables if there is heat emanang from or
near the cables as melted or deformed cables could expose
wiring and result in burns or electric shock.
Do not use cloth or anything to wrap or cover the equipment
while charging – this could cause the unit to overheat,
melng the casing or causing fire.
If the unit is accidently immersed in water, or if moisture has
seeped inside, or metal objects have dropped into the
casing, immediately remove the baery to avoid fire or
electric shock.
Do not operate or store the baery in high-temperature
environments. This will cause baery leakage and/or
shorten the life of the baery.
Do not use paint thinner, benzene, or other organic solvents
to clean the equipment. This may damage the exterior finish
or touch screen and may even ignite a fire.
■
■
■
■
■
■
■
■
■
- 5 -
2.1 Preparing Before Use
Baery installaon：
Step 1. Hold the LI-180 Spectrometer and press the baery cover.
Step 2. Press the baery cover down to remove it.
Step 3. Install the baery aer removing baery cover.
3
2
1
※ Press baery cover down to unlock it from the
cover latch before pushing it out from the body
of the spectrometer.
1.
2.
3.
4.
Charge the baery for 6 hours before using it for the first me.
To prevent power outage during use, check whether the red light
has turned off (fully charged) according to the instrucons given
on the next page (Item1). Once the spectrometer is turned on,
keep an eye on the baery charge indicator at the upper right
corner of screen.
If your baery drains quickly aer being fully charged, it needs to
be replaced. Please contact LI-COR to order a replacement baery.
Baery life varies with baery age and usage. A new baery
typically lasts about 5 hours aer a full charge.
