7
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Unite®System - Corner Transaction Countertop
Assembly Instructions
top caps as illustrated� Spacing
of buttons is approximate, and
buttons prevent the countertop from
incidental contact with the top cap
(Figure 5)�
2� Reference the Figure 5 illustration
on this page, then locate from the
parts bag and identify the different
support brackets required� The
6” design cantilever brackets are
right- or left-hand in design, so one
style of bracket will install to the far
left-hand side, and the other style
will install on the far right-hand side
of the corner panel unit, to support
a corner transaction countertop�
All brackets must be installed to
the inside (workstation side) of the
panels� Additionally, an edge-style
support bracket must be installed at
the center, inside corner of the corner
transaction countertop (Figure 5)�
3� To install a right- or left-hand
cantilever design bracket, first
identify the top slot of the panel
vertical post and insert the top tooth
of the appropriate design bracket
into that top slot� Engage all teeth
into slots in the vertical post, then
press down firmly to engage all teeth
into the slots� The horizontal top
of the bracket should be about 1/8”
above the top of the panel top cap�
Check bracket for full engagement
by pulling straight back firmly in a
horizontal motion
(Figure 5 & Detail D)�
4� Repeat step 3 above for the cantilever
design bracket at the other side�
Next locate the “edge-style support
bracket (left-hand)” to be installed at
the inside corner location (Detail E)�
Position the edge bracket as
illustrated, identify the top slot of
the panel vertical post and insert the
top tooth of the bracket into the top
slot� Engage all teeth into slots in the
vertical post, then press down firmly
to engage teeth into the slots� The
horizontal top of the bracket should
be about 1/8” above the top of the
panel top cap (Figure 5 & Detail E)�
Corner Transaction Countertop -
Standard 40” High Assembly
Overview: Installation below is
for a two-piece corner transaction
countertop (assembled previous
page) which installs to a corner pair
of 40” high Unite Panels� Assure that
the corner transaction countertop
widths match the width of the Unite
Panels it installs onto�
1� Unite Panel top caps must be
installed, then adhere two self-stick
rubber buttons to the top of both
panel top
cap
Detail D
panel top
cap
5
rubber
button rubber
button
edge-style
support bracket
(left-hand)
edge-style
support bracket
(left-hand)
rubber
button
Detail E
6” design
cantilever bracket
(left-hand)
6” design
cantilever bracket
(right-hand)
6” design
cantilever bracket
(left-hand)
