Bloomfield 7895T User manual

10 Sunnen Drive

St. Louis, MO 63143

telephone: 314-678-6336

fax: 314-781-2714

www.wellsbloomfield.com

MODEL 7895T

Stainless Steel Thermal Carafe

732

p/n SK2646 Rev. - 732 130423

1 of 1

INSTRUCTIONS

Disassemble and clean with warm water and mild detergent prior to

use. DO NOT allow the LED sensor to get wet, damage may occur.

Installation

An insulator (white tape) in place to prevent the battery from draining

prematurely. Remove the tape and attach the cover seal as shown

here.

CAUTION

DO NOT use with insulator in place, failure to remove it will prevent

the sensor from working properly.

The cover seal MUST completely cover the hole, without the seal or

if the hole is not completely covered, coffee/water etc, will enter the

hole and cause damage to the decanter.

1. Remove Inner Lid form Body

As in the following, turn the inner lid 90° counter-

clockwise to remove lid.

2. Make sure the sensor is attached, PRE-HEAT the decanter.

Preheat the decanter before its initial use by pouring in some boiling water and letting it sit for 3 minutes.

Dispose of the hot water, before setting under the brewer to receive coffee.

DO NOT place decanter on a HOT warmer, doing so can

damage the unit.

CAUTION

Keep the amount of coffee below the gridline. The sensor detects

the content and the result appears on the LED display a little after

the content is poured in.

3. Close the lid

Match the marks on the lid and the decanter and turn the lid 90°

clockwise to close.

CAUTION

If the lid is not fully closed, coffee may spill. Make sure the lid is

rmly closed.

4. Pouring coffee from the decanter

Pressing the lever, slowly tilt the decanter to pour from the

spout. After pouring, stop pressing the lever and tilt the body

back up.

CAUTION

Steam coming from the decanter is hot and can cause burns,

care must be taken when pressing the lever.

Do not tilt this product abruptly. It may cause the content to

spurt, spill out from gaps between the inner lid and sensor.

5. LCD

The top shows content (ml), and the bottom temperature (°F).

The LCD is switched ON/OFF through temperature detection.

The LCD switches off when the temperature is below 138°F

even if there is over 200 ml liquid remaining, which is not a malfunction.

CAUTION

The sensor / LCD work best when used with coffee.

In situations the LCD will remain on after emptying the entire contents, as the sensor is detecting the

inner temperature of the decanter. The LCD will switch off as the internal temperature cools down.

www.wellsbloomeld.com, Phone: (314) 678-6363

Table of contents

Other Bloomfield Kitchen Appliance manuals

Bloomfield

Bloomfield 8742 Series User manual

Bloomfield

Bloomfield 8740 User manual

Bloomfield

Bloomfield 8740 User manual

Bloomfield

Bloomfield PW-106 User manual

Bloomfield

Bloomfield Integrity 8746 User manual

Bloomfield

Bloomfield PW-106 User manual

Bloomfield

Bloomfield H-115 User manual

Bloomfield

Bloomfield Reily 8740LZ User manual

Bloomfield

Bloomfield 2030 User manual

Bloomfield

Bloomfield 8748 Series Guide

Bloomfield

Bloomfield 8740 User manual

Popular Kitchen Appliance manuals by other brands

Tayama

Tayama TYG-35AF instruction manual

AEG

AEG 43172V-MN user manual

REBER

REBER Professional 40 Use and maintenance

North American

North American BB12482G / TR-F-04-B-NCT-1 Assembly and operating instructions

Presto

Presto fountain popper instruction manual

Westmark

Westmark 1035 2260 operating instructions

Zanussi

Zanussi ZCG64396XA user manual

HOFFEN

HOFFEN SM-9302M instruction manual

Philips

Philips HD3133 user manual

Ronco

Ronco Beef Jerky User guide and recipes

Hendi

Hendi 470411 user manual

Livoo

Livoo MEN386 user manual

Vogue

Vogue D446 instruction manual

croydon

croydon WR-10313-700 instruction manual

ADE

ADE AUTOMATIC-L operating instructions

Chefman

Chefman RJ43-SQ Series user guide

Vacmaster

Vacmaster VP680 user guide

Jetmaster

Jetmaster 900HG operating instructions