Komatsu PC2000 User manual
Komatsu PC2000 SNM940 Installation Guide
1. Mount the Wi-Fi and Cell/GPS antenna on the ront le t corner o the operator’s top catwalk.
Run the antenna cables under the catwalk and in through the existing grommet into the room
under the operator’s station.
2. Mount the SNM940 on the le t wall o the room located under the operator’s station.
3. Ground the SNM940 to any o the weld boss located near the SNM940. Be sure to remove any
paint that may be on the ace o the weld boss.
4. Run both the battery and key switch power leads into the electrical panel located to the le t o
the SNM940.
5. Locate the breaker panel pictured below. I utilizing the SNM940 power cable (part #85939-45)
the ring terminals on both the battery and key switch power leads will need to be replaced with
a smaller ring terminal. Hook the key switch power lead to the breaker labeled Head Light Right
and the battery to the breaker labeled Key VHMS Controller (Battery).
Key Switch (Yellow)
Battery (Red)
6.
Connect Loadrite harness to SNM940 harness. The Deustch wedge will need changed on the
SNM940 side.
This manual suits for next models
1
Other Komatsu Construction Equipment manuals
Komatsu
Komatsu D65EX-12 Manual
Komatsu
Komatsu D85EX-15 Manual
Komatsu
Komatsu D155AX-5 Manual
Komatsu
Komatsu WB140-2N Install guide
Komatsu
Komatsu ecot 3 Manual
Komatsu
Komatsu D85EX-18 Manual
Komatsu
Komatsu D61EXi-24 Manual
Komatsu
Komatsu WA320-6 Install guide
Komatsu
Komatsu D475A-3 Manual
Komatsu
Komatsu WA95-3 Manual
Komatsu
Komatsu GD755-5R User manual
Komatsu
Komatsu PC58UU-3 Install guide
Komatsu
Komatsu D31EX-21 Manual
Komatsu
Komatsu PC3000-6 Manual
Komatsu
Komatsu GD555-5 Manual
Komatsu
Komatsu D51EX-24 Manual
Komatsu
Komatsu GALEO D65EX-15 Manual
Komatsu
Komatsu Avance Loader WA900-3 Manual
Komatsu
Komatsu Super D155AX-3 Manual
Komatsu
Komatsu XT430-2 Manual
