Abus TVIP71501 User manual
59
IR HD 720p Outdoor
Network Dome Camera
Ŝ
User manual
Version 05/2012
60
Ŝ
Introduction
Dear Customer,
Thank you for purchasing this product.
This product meets the requirements of the applicable European and national guidelines.
The corresponding declarations and documents can be obtained from the manufacturer
(www.abus-sc.com).
To maintain this condition and to ensure risk-free operation, you as the user must observe these
operation instructions!
Before initial start-up, read through the complete operating instructions observing operating and
safety instructions.
All company and product names mentioned in this document are registered trademarks.
All rights reserved.
If you have any questions, please contact your installer or your local dealer!
Disclaimer
This user manual was prepared with greatest care. If you should notice omissions or inaccuracies,
please inform us about these on the back of this manual given address.
The ABUS Security-Center GmbH & Co. KG assumes no liability for technical and typographical
faults and reserves the right to make at any time modifications to the product or user manual
without a previous announcement.
The company is not liable or responsible for direct and indirect subsequent damages which are
caused in connection with the equipment, the performance and the use of this product.
No guarantee for the content of this document is taken.
61
Important safety instructions
The warranty will expire for damage due to non-compliance with these operating
instructions. We shall not be liable for any consequential loss!
We do not accept liability for damage to property or personal injury caused by incorrect
handling or non-compliance with the safety-instructions. In such cases the warranty will
expire.
Dear customer,
The following safety instructions are intended not only for the protection of your health, but also for
the protection of the device. Please read through the following points carefully:
xThere are no parts on the inside of the product which need to be serviced. Apart from this, the license
(CE) and the guarantee/warranty will lapse if you open/take the product apart.
xThe product will be damaged even it falls from a low height.
xThis device can be used in inside as well as outside.
xDuring the installation of the camera please take care that direct sunlight cannot fall onto the image
sensor of the device. Please follow the installation instructions in the corresponding chapter of this
user manual.
Avoid using the device under the following unfavorable ambient conditions:
xwetness or excessive air humidity
xextreme cold or heat
xdirect sunlight
xdust or combustible gases, vapors or solvents
xstrong vibration
xstrong magnetic fields, such as those found in the vicinity of machinery or loudspeakers
xthe camera should not positioned with opened iris towards the sun - this can lead to the
destruction of the sensor.
xthe camera may not be installed on unstable surfaces
General safety instructions:
xDo not leave packaging material lying around carelessly. Plastic/ foil/bags and polystyrene parts etc.
could become dangerous toys for children.
xFor safety reasons don’t give the camera into child hands due to them being able to swallow small
parts.
xPlease do not insert objects through the openings into the device.
xUse only accessories which are specified by the manufacturer.
Please do not connect incompatible parts to the device.
xPlease pay attention to the safety instructions and user manuals of the other connected devices.
xCheck the device for damages before installation. If this should be the case please do not use it.
xPlease adhere to the operational voltage limitations listed in the technical data. High voltage could
destroy the device and pose a health hazard (electric shock).
During the installation into an existing video surveillance system make sure that all devices are
disconnected from the low and supply voltage circuit.
If in doubt allow a professional electrician to mount, install and wire-up your device. Improper or
make-do electrical connection to the mains does only represent at threat to you but also to other
persons.
Wire-up the entire system making sure that the mains and low voltage circuit remain separated
and cannot come into contact with each other in normal use or due to any malfunctioning.
62
Contents
1. Usage in accordance with regulations...............................................................................................64
2. Scope of delivery..................................................................................................................................64
3. Installation.............................................................................................................................................65
3.1 Power supply........................................................................................................................................65
3.2 Cable layout..........................................................................................................................................65
3.3 Installing the camera............................................................................................................................66
4. Camera description..............................................................................................................................67
4.1 Exterior view.........................................................................................................................................67
4.2 Opening the camera.............................................................................................................................67
4.3 Interior view ..........................................................................................................................................67
4.4 Alarm input and output........................................................................................................................68
4.5 Setting the zoom and focus ................................................................................................................68
4.6 Using the microSD slot........................................................................................................................69
4.7 Status displays.....................................................................................................................................69
4.8 Restoring the factory settings ............................................................................................................69
4.9 Using the analogue video output........................................................................................................70
4.10 Putting into operation..........................................................................................................................71
4.11 Accessing the network camera for the first time..............................................................................72
4.12 Accessing the network camera over a web browser........................................................................73
4.13 Installing the ActiveX plug-in..............................................................................................................73
4.14 Adjusting the security settings...........................................................................................................73
4.15 Password prompt.................................................................................................................................74
4.16 Accessing the network camera over an RTSP player ......................................................................74
4.17 Accessing the network camera over a mobile phone ......................................................................75
4.18 Accessing the network camera over ABUS VMS..............................................................................76
5. User functions ......................................................................................................................................77
6. Camera settings (configuration).........................................................................................................81
6.1 System...................................................................................................................................................82
6.2 Camera ..................................................................................................................................................85
6.3 Network .................................................................................................................................................91
6.4 Security .................................................................................................................................................99
6.5 Event....................................................................................................................................................102
6.5.1 Event server........................................................................................................................102
6.5.1.1 Event server list...................................................................................................................102
6.5.1.2 SD card...............................................................................................................................104
6.5.2 Event list..............................................................................................................................105
6.5.2.1 Event list..............................................................................................................................105
6.5.2.2 Scheduled recording...........................................................................................................107
6.5.3 Switching input and switching output..................................................................................108
6.5.4 Motion detection..................................................................................................................108
63
6.5.5 Schedule.............................................................................................................................109
6.6 System log ..........................................................................................................................................110
7. Maintenance and cleaning.................................................................................................................110
7.1 Function test.......................................................................................................................................110
7.2 Cleaning ..............................................................................................................................................111
8. Disposal...............................................................................................................................................111
9. Technical data.....................................................................................................................................112
10. GPL license information....................................................................................................................113
64
1. Usage in accordance with regulations
Use of this product for other than the described purpose may lead to damage to the product
and other dangers. All other uses are not in accordance with regulations, and result in the
invalidation of the product guarantee and warranty. No liability can be accepted as a result.
This also applies to any alterations or modifications made to the product.
Read the entire operating manual carefully before putting the product into operation. The
operating manual contains important information on installation and operation.
2. Scope of delivery
ABUS network camera
TVIP71501/TVIP71551
Power supply unit
Network cable (1 metre)
Software CD
(including operating manual)
Antenna
(TVIP71551)
Quick guide
65
3. Installation
Make sure that all accessories and parts listed above are present in the scope of delivery. An Ethernet cable
is required for camera operation. This Ethernet cable must meet UTP Category 5 (CAT 5) specifications and
must not be longer than 100 metres.
3.1 Power supply
Before starting installation, ensure that the mains voltage and the rated voltage on the power supply unit are
identical.
A two-pin plug connection is used for supplying the
camera with power. The power supply unit is delivered
without the two-pin plug as standard. The plug is
already attached to the power supply socket of the
camera.
The positive terminal on the power supply unit is
marked accordingly. Connect the two wires from the
power supply unit (secondary side, 12 VDC) to the
power supply plug in the camera.
The plug can be removed from the socket to do this.
3.2Cable layout
Cables can be laid at the side (visible) or through the bottom (hidden). A cable connection is attached to the
housing to protect against moisture. Screw this cable connection fully into the opening on the side or bottom of
the housing. The second opening is sealed using the pre-installed plug on the bottom.
66
3.3Installing the camera
Firstly, remove the white dome ring by turning it
anti-clockwise.
Loosen the three fastening screws on the dome,
then remove it.
Three through bores for fastening are found on the
outside of the camera base plate.
Hold the base plate as a template on the probable
installation site, mark the three fastening holes on
the surface, then drill the holes. Use the screws
provided to fasten the base plate in place. Cables
can be laid at the side or hidden in the ceiling or
wall.
The camera module can be tilted and rotated along
three axes.
Pan: Rotation of the complete
camera module
Tilt: Tilt of the camera module
Rotation: Rotation of the lens with image sensor
and IR PCB (third axis)
IMPORTANT!
The camera must be disconnected from the mains power during installation.
67
4. Camera description
4.1Exterior view
1– Cable feed (at side)
2– Cable feed (hidden in base plate)
3– Antenna (TVIP71551 only)
4.2Opening the camera
The camera must be opened to set the angle of view and access the
connections inside the camera. Firstly, remove the white dome ring by
turning it anti-clockwise. The dome can then be detached after removing
the three fastening screws.
4.3Interior view
Power supply, polarity
4– Network connection (Ethernet), RJ45
5– Power supply, 12 VDC
6– Analogue video output for service purposes
7– Alarm input / alarm output
8– WPS button (for activating the
WPS function)
9– PAL/NTSC switch for analogue video
output (4)
10 – Reset button
11 – microSD slot
1 3
2
7
6
5
4
10
11
9
8
68
4.4Alarm input and output
Adhere to the following connections and maximum loads for the digital
alarm input and output.
Connection Description Max. load (V/A)
12 VDC Voltage output 12 VDC, max. 100 mA
GND Ground connection -
DI – Alarm input Activation of the digital input
by connecting the DI and
GND connections
-
DO – Alarm
output Connection of a transistor or relay:
Transistor: NPN with emitter
against ground (GND)
Relay: 12 VDC “and”
connection, plus
DO with diode
(see example below)
24 VDC, 100 mA
Connection example:
Please carefully observe the connection instructions and power specifications!
4.5Setting the zoom and focus
The TVIP71501 and TVIP71551 camera models are
equipped with a variofocal lens. One setting screw for
the zoom and one for the focus are found on the bottom
of the variofocal lens. These screws are also used for
fixing the lens.
Turn the screws carefully anti-clockwise to loosen them.
Make the required settings, then fasten both screws
again.
Other manuals for TVIP71501
1
This manual suits for next models
2
Table of contents
Other Abus IP Camera manuals
Abus
Abus TVHD50000 User manual
Abus
Abus PPIC90000 User manual
Abus
Abus eyseo TV7144 User manual
Abus
Abus PPIC90000 User manual
Abus
Abus TVIP51500 User manual
Abus
Abus TVIP11561 User manual
Abus
Abus IPCB42500 User manual
Abus
Abus TVIP52502 User manual
Abus
Abus TVIP41560 User manual
Abus
Abus TVIP62000 User manual
Abus
Abus TVAC15000 User manual
Abus
Abus TVIP21502 User manual
Abus
Abus TVAC16010C User manual
Abus
Abus TVIP21502 User manual
Abus
Abus TVVR11000 User manual
Abus
Abus TVAC16010B User manual
Abus
Abus TVIP70000 User manual
Abus
Abus TVHD60000 User manual
Abus
Abus TVAC19100A User manual
Abus
Abus TVAC19000A User manual
