930i Operating & Maintenance Manual
SAFETY PRECAUTIONS
The following general safety precautions must be observed during all phases
of operation, service and repair of this instrument. Failure to comply with
these precautions or with specific warnings elsewhere in this manual violates
safety standards of design, manufacture and intended use of the instrument.
Vitrek Corporation assumes no liability for the customer's failure to comply
with these requirements.
GROUND THE INSTRUMENT
To minimize shock hazard, the instrument must be connected to an electrical
ground. This should be accomplished through the earth ground pin of the
instrument's power connector and power cord.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Operation of any electrical instrument in the presence of flammable gases,
fumes or particles constitutes a definite safety hazard.
DO NOT REMOVE COVERS
Operating personnel must not attempt component replacement or internal
adjustment. Dangerous voltages may exist internally even when the power is
switched off. Because of the dangers of introducing additional hazards, do
not install substitute parts or perform any unauthorized modifications to the
instrument. Refer the unit to qualified maintenance personnel or to your
nearest Vitrek Service Center.
DANGER! HIGH CURRENT!
Use extreme caution! High currents can weld conductive jewelry such as
rings and watches, causing severe burns. Never handle, insert or remove test
leads from the 930i or the load while high current is present. Use only test
lead materials that have an adequate current rating. Inspect test leads
regularly for signs of wear and abrasion.
READ AND UNDERSTAND THE MANUAL
Prior to operating this instrument, the user must be familiar with the
operating procedures, controls and precautions.
2
