Racing RAC30HM Setup guide

Hand push lawn mower

RAC30HM

Translation of Original Instructions

Read carefully this manual before any use. This manual contains important

recommendations concerning the safety.

32 rue aristide Bergès - ZI 31270 Cugnaux –France

SAFETY RULES

1. Read all instructions in this manual before using mower.

2. Inspect your lawn for any debris or foreign objects and remove them before mowing.

3. Never place your hands, fingers or feet inside the reel. Although not powered by a motor, when

the wheels turn, the reel cuts.

4. Don’t place your hands or feet near a mowing part of the mower.

5. Don’t operate the mower while barefoot or wearing sandals.

6. Walk slowly, never run. Don’t mow excessively steep slopes. Always be sure of your footing

when operating the mower.

7. Never mow when the grass is wet enough to be slippery.

8. Never intentionally strike or ram trees, fences, etc. This can cause injuries or severely damage

to the mower.

9. Make sure your mower is in safe operating conditions. Don’t attempt to operate the mower if it

is damaged, have it repaired first.

SPECIFICATION:

30 cm cutting width,

3 cutting height positions 17-43MM

G.W./N.W.:8.5/7. 5KGS

HOW TO ASSEMBLY

Components and Controls

1. Mower body

2. Cylinder blade

3. Lower handle

4. Upper handle

5. Handle extensions

6. Cutting height roller

7. Cutting height adjustment screws

8. Fixed blade setting screw

ASSEMBLY (PICS.2, 3 & 4)

Attach the lower handle to the mower body by locating the two holes over the two legs on either

side of the mower body(pic 2).

Attach the handle extensions to the lower handle using the nuts and screws provided(pic 3).

Attach the upper handle to the handle extensions using the nuts and screws provided(pic 4).

FIXED BLADE SETTING (PICS. 5 & 6)

Warning! This operation will have to be done while carefully turning the cylinder blade. We

strongly recommend that thick gardening gloves are worn. In order for the mower to work

efficiently, the fixed blade must be set correctly. Using the two adjusting screws(pic 5) carefully

turn each adjusting knob in turn a small amount in a clockwise direction until the fixed blade just

makes contact with the cylinder blade(pic 6). When this is done, back off each adjusting knob in

turn until the rotating blade is just clear of the fixed blade.

CUTTING HEIGHTADJUSTMENT (PICS. 7 & 8)

The cutting height can be adjusted by raising or lowering the cutting height roller. Slacken the two

knobs one on each side of the cutting height roller(pic 7) and set the height of the roller to give the

required height of cut(pic 8). It is important that when adjusting the cutting height that each end of

the roller is adjusted by the same amount to keep the roller level. If this is not done, an uneven cut

will result.

CLEANING(WEAR GLOVES)AND MAINTAIN

It is important that you keep your cylinder mower in a clean condition. After each use, remove all

grass cuttings that have collected in and around the wheels, roller and blades. We suggest a routine

application of oil or lubricant(i.e. WD-40). This should be applied to all cutting surfaces, the

cutting reel axle shaft and wheels.

LIMITED WARRANTY

There are no warranties that extend beyond the product description except that the lawn mower

sold thereunder is warranted as follows: One year limited warranty. For one year from purchase,

we will replace free of charge to the original buyer, any part(s) found defective in material and/or

workmanship upon examination by our factory or a factory authorized service center. Parts sent to

the factory for replacement must be shipped prepaid by the buyer. There is no other express

warranty. All implied warranties, including those of merchantability and fitness for a particular

purpose are imited to one year from the purchase and to the extent permitted by law, any and all

implied warranties are excluded. This is the exclusive remedy and liability for consequential

damages under any and all warranties.

Warranty is limited to manual push walk behind applications and specifically excludes any

non-manual powered propulsion of any kind or any commercial/non-residential applications.

Any non-residential use of this product voids all warranty.

GRASS CATCHER INSTALL

1. Attach the tube to the plastic hook

2. Insert tubes into the fabric hole

3. Fit both tubes into the connector in the middle

4. Fix both tube end with screws

5. Attach metal hook into the connector hole

DECLARATION OF CONFORMITY

RACING

ZI, 32 rue aristide Bergès –31270 Cugnaux - France

Tel : +33 (0)5.34.502.502 Fax : +33 (0)5.34.502.503

declares that the machines:

Hand push lawn mower

RAC30HM

Serial No.:

have been designed in compliance with the following standards:

And in accordance with the following directives:

Directive Machine 2006/42/EC

Philippe MARIE / PDG

26-11-2018

Table of contents

Other Racing Lawn Mower manuals

Racing

Racing RAC62PR-1-UK User manual

Racing

Racing RAC5175SPM User manual

Racing

Racing RAC4000T-A3 User manual

Racing

Racing RAC4661PL User manual

Racing

Racing RAC4000T-2 User manual

Racing

Racing RAC5176SPM User manual

Racing

Racing RAC4001T User manual

Racing

Racing RAC4640PL-1 User manual

Racing

Racing RACTDT4660 User manual

Racing

Racing RACTDT5070-A User manual

Racing

Racing RAC4000T-A1 User manual

Racing

Racing RAC5073T-A User manual

Racing

Racing RAC5174F User manual

Racing

Racing RAC62PR-3 User manual

Racing

Racing RAC5675ES-1 User manual

Racing

Racing RAC4IN1E-1-UK User manual

Racing

Racing RAC5614F-A User manual

Racing

Racing RAC5073T-1 User manual

Racing

Racing RACTDT5070-1 User manual

Racing

Racing RAC5675ES-A User manual

Racing

Racing RAC5096-AC-1 User manual

Racing

Racing RAC1030ELA User manual

Racing

Racing RAC62PRRS User manual

Racing

Racing RAC1200EM-UK User manual

Popular Lawn Mower manuals by other brands

RHINO

RHINO 1958 parts manual

Wolf Garten

Wolf Garten Compact plus 40 B instruction manual

Cub Cadet

Cub Cadet LTX 1045 brochure

Craftsman

Craftsman 917.378461 owner's manual

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Operator's manual

Challenge

Challenge CH18V2 Original manual

TALEN TOOLS

TALEN TOOLS AVR HGM30 manual

DEWEZE

DEWEZE ATM-725 Operation and service manual

Weed Eater

Weed Eater 180083 owner's manual

Husqvarna

Husqvarna Poulan Pro PP185A42 Operator's manual

Better Outdoor Products

Better Outdoor Products Quick Series Operator's manual

Cub Cadet

Cub Cadet 23HP Z-Force 60 Operator's and service manual

MTD

MTD 795, 792, 791, 790 Operator's manual

Toro

Toro Groundsmaster 3505-D Service manual

Dennis

Dennis FT 610 instruction manual

AIRFORCE

AIRFORCE F-15 Gen 3 owner's manual

MTD

MTD 126-220-000 owner's guide

Toro

Toro 74806 Operator's manual