6
5. Setting up the device
Menu level Parameterisation level
Selection of the input signal,
Default:
Available are 9 types of thermocouple as input options (L, J, K, B, S, N, E, T, R).
Confirm the selection with [P] and the display switches back to menu level.
Type of temperature metering,
Default:
The temperature can be displayed in °C or in °F. Confirm the selection with [P] and the
display switches back to menu level.
Setting the decimal point, :
Default:
The decimal point on the display and the physical unit can be changed with [▲] [▼]. If
e.g. temperature measurement in °C is selected, then select between 0°C and 0.0°C in
the parameterisation level. Confirm with [P], the display then switches back to the
menu level again.
Setting the measuring range start/offset value, :
Default:
The value for the sensor calibration is selectable from the smallest to the highest digit
with [▲][▼] and confirmed with [P]. After the last digit the display switches back to the
menu level again. The value calibration for a temperature measurement in °C can be
adjusted between -20.0 and +20.0 and in °F between -36.0 and +36.0. If the type of
the measurement is changed later, then the value is rounded.
5.1. Switching on
Once the installation is complete, start the device by applying the voltage supply. Before, check once again
that all electrical connections are correct.
Starting sequence
For 1 second during the switching-on process, the segment test ( ) is displayed followed by an
indication of the software type and, after that, also for 1 second the software version. After the starting
sequence, the device switches to operation/display mode.
5.2. Standard parameterisation: (Flat operation level)
To parameterise the display, press the [P]-key in operating mode for 1 second. The display then changes to
the menu level with the first menu item .
5. Setting up the device
