HT 6550200200
KC-326B HUMIDITY AND ENVIRONMENTAL PRESSURE METER
Page - 9
◦◦ The "DATA" symbol shows year/month/day and the "TIME" symbol shows hour/minute. Press the UNIT/
or STORE/ENTER/ button to change "DATA"/"TIME".
◦Push the button /HOLD for go out of this mode.
•- Parameter settings for automatic recording.
Los parámetros sobre la grabación automática incluye el reloj del sistema “TM”, intervalos de tiempo de
grabación “INT” y duración “TML”.
1. . System Clock Settings
◦◦ Press the <DN or UP> button to move the arrow from left to right to "TM".
◦◦ Press the LOG/SET button to enter the setting mode. If the "DATA" symbol is displayed, two digits of the
year will flash first. Pressing the LOG/SET button each time will save the current flashing values and switch
to the month, day, hour and minute digits. "DATA" and "TIME" can change automatically and start from 0
after the seconds have been set.
◦◦ Press the UNIT/ or STORE/ENTER/ button to change the flashing time.
◦◦ Press the <DN or UP> button to exit these settings and enter new ones. The data will not be saved.
◦◦ Press the /HOLD button to exit this mode and return to normal mode. The data will not be saved.
2. Autoconfiguration adjustment of time intervals
◦◦ Enter revision mode to move the arrow to "INT".
◦◦ Press LOG/SET to confirm and enter the settings and the last two digits under the display will flash.
◦◦ Press the UNIT/ or STORE/ENTER/ button to change the value, "S", "M", "H" indicates second, minute
and hour respectively.
◦◦ Press the LOG/SET button to save the current flashing digits.
◦◦ Press the <DN or UP> button to exit this setting without saving and enter other environments.
◦◦ Press the /HOLD button to exit this setting without saving and enter normal mode.
3. Setting the duration
4.
◦◦ Enter the time duration recording mode, move the arrow to "TML".
◦◦ Press the LOG/SET button to confirm and enter settings and the last two lower digits will flash.
◦◦ Press UNIT/ or STORE/ENTER/ button to change "S", "M", "H" (second, minute and hour
respectively).
◦◦ Press the LOG/SET button to save the current flashing values.
◦◦ Press the <DN or UP> button to exit this setting without saving any data.
◦◦ Press the /HOLD button to exit this setting without saving and enter normal mode.
Note: The time duration recording mode "TML" must be greater than the recording of the time intervals "INT". If not, a
"beep" will sound on the device and the data cannot be saved. The factory setting of "INT" is 15 seconds (minimum is 15
seconds and maximum is 24 hours). The factory value "TML" is 15 minutes (the minimum is 1 minute and the maximum is
30 days). When setting long duration periods, connect the USB to ensure the duration of the device.
