LK Systems PAL 16 User manual
1
Figure 2 shows how the correct distance is obtai-
ned between the end of the pipe and the centre
of the bend with a 90° bend.
y
y
LK Systems
Fig 2.
These instructions are for LK Bending tool PAL
for dimensions 16 , 20, 25, 32 and 40. Each tool
is clearly marked with the pipe dimension it is
intended for. The bending tools for dimension 32
and 40 also have a lug so you can easily attach
them in a screw vise.
NOTE! The tools are only intended for work on
LK PAL pipes.
Art no 187 81 75 LK Bending tool PAL 16
Art no 187 81 76 LK Bending tool PAL 20
Art no 187 81 77 LK Bending tool PAL 25
Art no 188 10 68 LK Bending tool PAL 32
Art no 188 10 69 LK Bending tool PAL 40
90° bend
Figure 1 shows how the correct distance is obtai-
ned between the end of the pipe and the centre of
the bend with a 90° bend.
x
x
LK Systems
Fig 1.
LK Bending tool PAL 16, 20, 25, 32 and 40
EN.29.C.21.1401
Assembly Instructions | LK Bending tool PAL 16, 20, 25, 32 and 40
2
EN.29.C.21.1401
Assembly Instructions | LK Bending tool PAL 16, 20, 25, 32 and 40
Saddle bends
1. The rst bend is made at, for example, 45°.
2. Turn the pipe through a half turn and make a
90° bend.
3. Turn the pipe through a half turn again and
make a 45° bend. When the nal 45° bend is
made, the centre line of the pipe must align with
the outside diameter of the segment.
NOTE! The largest saddle bend is obtained if the
rst bend is made at 45°. The size of the saddle
bend is reduced if the angle of the rst bend is
reduced.
Bends one and three must have the same angle.
The angle of bend two must always be twice as
large as the angle of bends one and three.
LK Systems
Fig 4.
Figure 4 shows a saddle bend of 45°.
S bends
The rst 90° bend is made as in gure 1 or gure
2. The centre position of the second 90° bend is
based on its distance from the rst 90° bend.
S bends that are close together
Firstly, a 45° bend is made. Turn the pipe through
a half turn, as in gure 3, and make a 45° bend.
The dimension between the bend centres X is ob-
tained on the basis of the segment’s outside dia-
meter and by moving the pipe back and forth in
the tool. NOTE! The dimension X decreases if the
bend is less than 45°.
x
x
LK Systems
Fig 3.
This manual suits for next models
9
Other LK Systems Construction Equipment manuals
