Denver MCA-171 User manual

INSTRUCTION MANUAL

BEDIENUNGSANLEITUNG

BETJENINGSVEJLEDNING

BRUKSANVISNING

SUOMALAISET KAYTTOOHJEET

MANUALE DI INSTRUZIONE

MANUAL DE INSTRUCÕES

MANUAL DE INSTRUCCIONES

MCA-171

www.denver-electronics.com

LOCATION OF CONTROLS

1. CD DOOR

2. FUNCTION SWITCH (CD/RADIO)

3. BAND SWITCH (FM/FM ST.)

4. LCD DISPLAY

5. POWER BUTTON (ON/OFF)

6. BASS BOOST BUTTON

7. STANDBY LED INDICATOR

8. TUNING KNOB

9. REMOTE SENSOR

10. CD PROGRAM BUTTON

11. CD REPEAT BUTTON

12. CD STOP BUTTON 

13. CD PLAY/PAUSE BUTTON 

14. VOLUME CONTROL (UP/DOWN)

15. STEREO HEADPHONE JACK

16. CD SKIP/SEARCH FORWARD

BUTTON 

17. CD SKIP/SEARCH BACKWARD

BUTTON 

18. SPEAKER LEFT

19. SPEAKER RIGHT

20. AC POWER CORD

21. FM ANTENNA

22. SPEAKER TERMINAL (L/R)

English - 1

SPEAKER BOX CONNECTION

Connect speaker wires of SPEAKER BOXES to SPEAKER TERMINAL on the

rear of unit properly.

Note: Ensure polarities of speaker wire, RED (+) and BLACK (-) connected

to the SPEAKER TERMINAL properly.

AC OPERATION

Before operating, please check carefully that voltage indicated on your set

corresponds to voltage of your local area.

1. Plug the AC POWER CORD into a standard AC outlet. The STANDBY LED

INDICATOR will light up.

2. Press POWER BUTTON to start the unit.

The LCD DISPLAY will light up while STANDBY LED INDICATOR will go

“off”.

Remarks:

a. In case of malfunction due to electrostatic discharge (ESD), reset the unit

by reconnecting the AC CORD again to resume to normal operation.

b. When not in use – Unplug the AC power cord completely from the AC

power cord. Where the mains plug or an appliance coupler is used as the

disconnect device, the disconnect device shall remain operable.

Warning:

The power cable/disconnect device shall remain easy to operate/disconnect.

RADIO OPERATION

1. Slide FUNCTION SWITCH to “RADIO” position.

2. Slide BAND SWITCH to your desired waveband (FM or FM ST.).

3. Turn TUNING KNOB to your desired radio station; radio frequency will

appear on the LCD DISPLAY.

4. Adjust sound level by pressing VOLUME CONTROL knob (Up or Down).

5. To turn off radio, press POWER BUTTON once. The backlight of LCD

DISPLAY will go “off” while STANDBY LED INDICATOR will light up.

FM STEREO INDICATOR

Slide BAND SWITCH to FM ST. position;

FM stereo indicator “ ” will light up

when listening to a strong station that is

broadcasting in “stereo”.

When FM stereo reception is weak, slide BAND SWITCH to FM position. In

this case FM reception will be monaural.

English - 2

ANTENNAS

For best reception, fully extend FM ANTENNA to receive FM station.

BASS BOOST

At all volume levels, press BASS BOOST BUTTON to “ON” position to enhance

the low frequency sound.

To release super bass press this button once again.

STEREO HEADPHONE JACK (Headphone is not included)

For private listening, insert the plug of a Stereo Headphone into STEREO

HEADPHONE JACK and adjust VOLUME CONTROL KNOB accordingly. Be sure

that your headphone has 3.5mm diameter stereo plug with an impedance of

32 ohms. During the use of a headphone, speakers are disconnected

automatically.

CD OPERATION (CD-R-RW PLAYBACK COMPATIBLE)

Playing Compact Disc

Getting Started

NOTE: Should skipping of track occur during CD playing, try turning the

volume down.

When CD is playing, do not open the CD Door.

1. Open the CD DOOR by pressing the right-bottom corner of the CD DOOR.

Put a CD into the CD COMPARTMENT and close the CD DOOR. Set the

FUNCTION SWITCH to “CD” position.

2. When the CD DOOR is closed with a CD inside, the total number of tracks

on the disc will be shown on the LCD DISPLAY and the unit will go to stop

mode.

3. If the CD DOOR is not closed or there is no disc inside, the LCD DISPLAY

will show “00” and go to stop mode.

Play/Pause Mode

1. When the PLAY/PAUSE BUTTON is

pressed during CD stop mode, the first

track will be played. The “PLAY”

Indicator will be lighted; LCD DISPLAY

will show the specific track being played.

English - 3

2. To pause CD playing, press the CD

PLAY/PAUSE BUTTON once. The

“PLAY” Indicator will flash

continuously.

3. Although the sound stops, the disc will continue to spin. To re-start

playback, press the CD PLAY/PAUSE BUTTON once again. The music will

start from the exact position where it was interrupted.

4. To stop the CD, press the CD STOP BUTTON once whether the CD is in

Play or Pause mode.

5. To turn off the unit, press POWER BUTTON once. The backlight of the

LCD DISPLAY light will go “off” while the STANDBY LED INDICATOR will

light-up.

Repeat Mode

1. Repeat 1:

When the REPEAT BUTTON is pressed

once, the “REPEAT” Indicator will light

and flash continuously. This single CD

track will be repeated.

2. Repeat all:

When the REPEAT BUTTON is pressed

twice, the “REPEAT” Indicator will stay

lit. The whole disc will be played

continuously.

3. Cancelling Repeat Function

Press the REPEAT BUTTON until the lighted REPEAT Indicator is turned

off.

Skip and Search Mode

1. During play or pause mode, when the CD SKIP/SEARCH FORWARD or

BACKWARD BUTTON is pressed once, it will go to the next track or

back to the beginning of the track.

2. During play or pause mode, when the CD SKIP/SEARCH FORWARD or

BACKWARD BUTTON is pressed and held, it will search the track with

audible high speed forward or backward playback.

Program Mode

1. During the CD stop mode, press the

PROGRAM BUTTON once, the

PROGRAM Indicator will light up and

blink continuously together with the

English - 4

number of Program to be memorized

starts from the first program “01”.

Press the CD SKIP/SEARCH FORWARD

or BACKWARD 

BUTTON to select your desired musical track, LCD DISPLAY will show the

appropriate track number. Press the PROGRAM BUTTON again to store

this desired track in memory. (Ex. Track no. 7)

2. Repeat above procedure until all desired tracks have been programmed.

A total of 30 tracks can be stored into memory. After complete

programming, LCD DISPLAY will show “01” again and flash continuously.

3. To start the Programmed playback, press the CD PLAY/PAUSE BUTTON

once.

Note: While PROGRAM INDICATOR is flashing, never press the CD STOP

BUTTON otherwise all programmed memory will be cancelled

automatically.

4. To cancel the Programmed memory, simply open the CD DOOR or press

the CD STOP BUTTON during CD stop mode. The PROGRAM INDICATOR

will disappear from the LCD DISPLAY.

REMOTE CONTROL OPERATION

INSTALLING BATTERIES

Slide open the BATTERY DOOR, install two “AAA” size or UM-4 batteries

according to the polarity diagram inside the battery compartment of the

Remote Controller.

BATTERY REPLACEMENT

When batteries become weak, the operating distance of the Remote

Controller is greatly reduced and you will need to replace batteries.

USING THE REMOTE CONTROLLER CORRECTLY

•Point the Remote Controller at the REMOTE SENSOR located on the main

unit.

•The function of the button is the same as the corresponding control on the

main unit.

•When there is a strong ambient light source, the performance of the

infrared REMOTE SENSOR may be degraded causing unreliable operation.

•The recommended effective distance for remote operation is about 5

meters.

English - 5

23.BATTERY DOOR

Slide open the BATTERY DOOR, then insert two “AAA” size or UM-4

batteries according to the polarity diagram inside the battery

compartment.

24. POWER BUTTON

a)While the main unit is in operation, press the

POWER BUTTON once, the unit will go to Standby

Mode and STANDBY LED INDICATOR on the main

unit will light-up.

b) Press the POWER BUTTON again and it will

resume to normal play function.

25. PLAY/PAUSE BUTTON

Press to start play or pause temporarily in CD

Mode.

26. STOP BUTTON

Press to stop CD play.

27+28. SKIP/SEARCH “/ ”

Skip or Search backward / forward for the desired

track or passage in CD mode.

29. MUTE BUTTON

Press to silence the sound output.

30. REPEAT BUTTON

Press to play one or all tracks repeatedly.

31. VOLUME (Up or Down )

Press to adjust the volume

32. INFRARED TRANSMITTER.

NOTE :

If the Remote Controller is not to be used for a long time, remove the

batteries to prevent possible damage through battery.

Do not mix different types of battery or old batteries with new ones.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE APPLIANCE TO

RAIN OR MOISTURE. NO USER SERVICEABLE PARTS INSIDE. REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL.

English - 6

INSTRUCTIONS ON ENVIRONMENT PROTECTION

Do not dispose this product into usual household garbage at the

end of its lifecycle; hand it over to a collection centre for

recycling the electrical and electronic appliances.

By recycling, some of the materials can be reused. You are

making an important contribution to protect our environment.

Please inquire your community administration for the authorized

disposal centre.

English - 7

www.denver-electronics.com

Table of contents

Popular Stereo System manuals by other brands

LG CM3330B owner's manual

Sony

Sony SS-CEP50 Service manual

Cetacea Sound

Cetacea Sound CVS-II user guide

Aiwa

Aiwa XR-H66MD operating instructions

Denon

Denon UCD-250 Service manual

Sanyo

Sanyo DC-MX41i instruction manual

Sharp

Sharp CD-ES600V Service manual

Exibel

Exibel BDX600-UK user manual

Sanyo

Sanyo DC-F320 Service manual

Philips

Philips FWM583X Specifications

Sharp

Sharp CD-C462 Service manual

Onkyo

Onkyo CBX 300 - CD / MP3 Clock Radio instruction manual

Aiwa

Aiwa XR-EM70 Service manual

Cyrus

Cyrus Lyric user guide

Philips

Philips MCM159/98 quick start guide

Philips/Magnavox

Philips/Magnavox Magnavox FW 62C owner's manual

RCA

RCA RS3965SB user manual

Sharp

Sharp XL-UH240 Operation manual