Dell PowerEdge 400SC Manual

www.dell.com | support.dell.com

Dell™ Systems

Processor Upgrade

Installation Guide

Notes, Notices, and Cautions

NOTE: A NOTE indicates important information that helps you make better use of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you

how to avoid the problem.

CAUTION: A CAUTION indicates a potential for property damage, personal injury,

or death.

____________________

Information in this document is subject to change without notice.

Reproductioninanymannerwhatsoever without the written permissionofDellComputerCorporationisstrictlyforbidden.

Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Computer Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and

names or their products. Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names

other than its own.

June 2003 P/N Y1336 Rev. A00

Processor Upgrade Installation Guide 1-1

You can upgrade your processor to take advantage of future options in speed and

functionality. Each processor and its associated cache memory are contained in a pin-grid

array (PGA) package that is installed in a ZIF socket on the system board.

Replacing the Processor

CAUTION: See your System Information Guide for complete information about

safety precautions, working inside the computer, and protecting against

electrostatic discharge.

CAUTION: The processor and heat sink can get very hot during normal operation.

Ensure that they have had sufficient time to cool before you touch them.

1Turn off the system and attached peripherals, and disconnect the system from the

electrical outlet.

2Press the power button to ground the system board.

3If you have installed a padlock through the padlock ring on the back panel, remove

the padlock.

4Lay the system on its side as shown in Figure 1-1.

NOTICE: Ensure that sufficient space exists to accommodate the open cover—at least 30 cm

(1 ft) of desktop space.

5Open the system by pushing the buttons on both ends and lifting the cover open.

See Figure 1-1.

1-2 Processor Upgrade Installation Guide

www.dell.com | support.dell.com

Figure 1-1. Opening the System

6Rotate the processor cooling shroud up to access the processor and heat sink.

See Figure 1-2.

buttons (2)

(one on each side

of the system)

padlock ring

security cable slot

Processor Upgrade Installation Guide 1-3

Figure 1-2. Rotating the Processor Cooling Shroud

7Remove the processor heat sink. See Figure 1-3.

aRemove one retention module clip by pressing the tab on the clip and lifting

the retention module clip up.

bWhile pulling the retention module tab out, lift the heat sink away from

the processor.

cooling shroud

1-4 Processor Upgrade Installation Guide

www.dell.com | support.dell.com

Figure 1-3. Removing the Heat Sink

8Pull the processor socket release lever straight up until the processor is released.

See Figure 1-4.

Figure 1-4. Removing the Processor

heat sink

retention module clip

retention module tab

cooling pipes

ease

ever

processor

socket

Processor Upgrade Installation Guide 1-5

NOTICE: Be careful not to bend any of the pins when you remove the processor from

the socket. Bending the pins can permanently damage the processor.

9Remove the processor from the socket and leave the release lever in the release

position so that the socket is ready for the new processor.

10 Align pin 1 (the imprinted corner) of the processor and pin 1 of the socket.

See Figure 1-5.

NOTICE: Processor pins are delicate. To avoid damage, ensure that the processor aligns

properly with the socket, and do not use excessive force when you install the processor.

11 Carefully set the processor in the socket and press it down lightly to seat it.

12 Rotate the release lever back toward the system board until it snaps into place,

securing the processor.

Figure 1-5. Installing the Processor

13 Remove the thermal grease protective cover from the heat sink.

NOTICE: If your heat sink has cooling pipes, orient the heat sink so that the cooling pipes are

toward the memory modules to prevent damage to system board components.

release lever

processor

socket

socket pin-1 indicator

processor pin-1 indicator

1-6 Processor Upgrade Installation Guide

www.dell.com | support.dell.com

14 Place one end of the heat sink under the retention module tab on the side opposite

the removed clip, and lower the heat sink onto the processor until the heat sink snaps

securely in the retention module. See Figure 1-3.

15 Replace the retention module clip by pressing in on the tab and lowering that end

of the clip into the retention module. See Figure 1-3.

16 Rotate the processor cooling shroud down. See Figure 1-2.

17 Close the system cover:

aPivot the cover down and into position. See Figure 1-1.

bPress down on the cover to close it.

18 If you are using a padlock to secure your system, install the padlock.

19 Reconnect the system to the electrical outlet, and turn on the system and attached

peripherals.

www.dell.com | support.ap.dell.com/china

Dell™ 系统

处理器升级安装指南

注、注意和警告

注：注表示可以帮助您更好地使用计算机的重要信息。

注意：注意表示可能会损坏硬件或导数据丢失，并告诉您如何避免此类问题。

警告：警告表示存在可能导致财产损失、人身伤害或死亡的潜在危险。

____________________

本文中的信息如有更改，恕不另行通知。

未经 Dell Computer Corporation 的书面许可，严禁任何方式进行复制。

本文中使用的商标： Dell 和Dell 徽标是 Dell Computer Corporation 的商标。

本文述及的其它商标和产品名称是指拥有相应商标和名称的公司或其制造的产品。

Dell Computer Corporation 对其它公司的商标和产品名称不拥有任何专利权。

2003 年6 月P/N Y1336 Rev. A00

Other manuals for PowerEdge 400SC

Table of contents

Languages:

Other Dell Server manuals

Dell

Dell EMC PowerEdge MX750c Manual

Dell

Dell PowerEdge C5125 User manual

Dell

Dell PowerEdge NX182 User manual

Dell

Dell PowerEdge C8000 User manual

Dell

Dell PowerEdge R420 User manual

Dell

Dell DSS 1510 User manual

Dell

Dell PowerEdge R810 User manual

Dell

Dell PowerEdge systems 6300 User manual

Dell

Dell PowerEdge 4600 User manual

Dell

Dell EMC PowerEdge M640 Manual

Dell

Dell PowerEdge T620 Quick start guide

Dell

Dell PowerEdge 2410 User manual

Dell

Dell PowerEdge M620 User manual

Dell

Dell EMC VxFlex Ready Node 14G User manual

Dell

Dell DX6004S User manual

Dell

Dell PowerEdge T110 User manual

Dell

Dell PowerEdge R415 User manual

Dell

Dell VxRail P670F Manual

Dell

Dell Wyse C10LE Service manual

Dell

Dell POWEREDGE 1900 User manual

Dell

Dell PowerEdge HS5620 Manual

Dell

Dell PowerEdge UPS 500T User manual

Dell

Dell PowerEdge FX2 Quick reference guide

Dell

Dell PowerConnect M8428-k Technical manual

Popular Server manuals by other brands

HP AlphaServer ES47 Cli reference manual

PowerNAS

PowerNAS CMA quick start guide

Supero

Supero FatTwin F617R3-FT user manual

MSI

MSI P1-109N-L70 user manual

EtroVISION

EtroVISION EV3151 user manual

NEC

NEC Express5800/T110j System configuration guide

HP ProLiant Gen9 user guide

Compaq

Compaq ProLiant 3000 Maintenance and service guide

iRobo

iRobo IPC2U user manual

Nortel

Nortel 1000 Con?guration guide user manual

Asus

Asus AP7500 Hardware reference guide

Avid Technology

Avid Technology AirSpeed 5000 manual

HP Integrity rx2600 overview

Milestone

Milestone Husky IVO 350T Getting started

Planet

Planet NAS-7410 user manual

Lenovo

Lenovo ThinkSystem SR635 V3 user guide

Fujitsu

Fujitsu PRIMERGY BX900 quick start guide

Asus

Asus RS700DA-E6 PS4 user manual