Avery Dennison Stacker Monarch 932TM User manual

Operating

Instructions

Operating

Instructions

23456

78901

Fishing Tackle

$40.00

23456

78901

Fishing Tackle

$40.00

23456

78901

Fishing Tackle

$40.00

23456

78901

Fishing Tackle

$40.00

Monarch®

932™ Stacker

Each product and program carries a respective written warranty, the only warranty on

which the customer can rely. Paxar Americas reserves the right to make changes in

the product, the programs, and their availability at any time and without notice.

Although Paxar Americas has made every effort to provide complete and accurate

information in this manual, Paxar Americas shall not be liable for any omissions or

inaccuracies. Any update will be incorporated in a later edition of this manual.

No part of this publication may be reproduced, transmitted, stored in a retrieval system,

or translated into any language in any form by any means, without the prior written

permission of Paxar Corporation.

WARNING

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

CANADIAN D.O.C. WARNING

This digital apparatus does not exceed the Class A limits for radio noise emissions from

digital apparatus set out in the Radio Interference Regulations of the Canadian

Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les

limites applicables aux appareils numériques de la classe A prescrites dans le

Réglement sur le brouillage radioélectrique édicte par le ministPre des Communications

du Canada.

Trademarks

Monarch®, 932, 9855, and 9860, are trademarks of Paxar Americas, Inc.

Paxar® is a trademark of Paxar Corporation.

Avery Dennison® is a trademark of Avery Dennison Corporation.

Avery Dennison Printer Systems Division

170 Monarch Lane

Miamisburg, OH 45342

TABLE OF CONTENTS

GETTING STARTED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Unpacking the Stacker. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Installing the Stacker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Step 1 - Installation for the 9860 Printer . . . . . . . . . . . . . . . . . . . . . . . 1-2

Step 2 - Level the Stacker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Step 3 - Connect the Power Cord . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4

Step 4 - Check the Alignment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5

Step 5 - Set the Tag Width. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-7

Step 6 - Set the Belt Speed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-8

HOW TO OPERATE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1

Re-Loading or Changing Supplies. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2

Emptying the Stacker. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2

Stacker Full . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2

Stacker Running . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Clearing a Tag Jam. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Installing Riser Blocks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4

TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1

SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1

Stacker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1

Supplies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2

Minimum Stacked Tag Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2

i Table of Contents

ii Table of Contents

GETTING STARTED 1

The Monarch® 932stacker works with a Monarch® 9860

printer. The stacker supports backfeed mode on the printer. There

is no power ON/OFF switch for the stacker. Once the stacker is

plugged into an outlet, it is on.

Unpacking the Stacker

uImportant: After unpacking the stacker, look through all

packaging material for parts. Keep all packaging material

for future shipping.

Installing the Stacker

Use these instructions when you first install the stacker or when

you need to move the stacker to a different location.

Before installing:

uFind a level work surface at least 52" x 22"

(1321 mm x 559 mm).

The 9860 printer comes with a knife attached.

uTurn off the printer before you install the stacker.

Getting Started 1-1

Step 1 - Installation for the 9860 Printer

1. Locate the screw hole on the stacker mounting plate.

2. Attach the adjusting bracket to the stacker mounting plate

using a flanged screw as shown (do not tighten all the way).

3. Gently lift stacker and center the guide tabs in the knife

opening.

4. Set the stacker locating pins (on bottom of stacker) firmly in

the adjusting bracket locating hole and mounting plate slot.

5. Tighten the adjusting bracket flanged screw.

6. Connect the stacker cable to the knife.

Stacker

Mounting

Plate

Adjusting

Bracket

Flangedscrew

Mounting

Plate

Slot

AdjustingBracket

Locating Hole

Guide Tab

Knife Opening

LocatingPin

1-2 Getting Started

Step 2 - Level the Stacker

1. Check the distance between the rollers and the knife. Make

sure the rollers are not touching the front of the knife or too

far from the knife. If incorrect, follow the steps below. If

correct, skip this step and move on to Step 3 - Connect the

Power Cord.

The ideal position for the stacker is with the

end of tray slightly down.

2. Loosen the locking nuts with a wrench.

3. Make sure the stacker’s feet are flat

on a level surface.

You can raise or lower the feet

by turning them.

4. Evenly adjust both feet.

If the stacker is

utouching the knife case, lower the feet.

utoo far from the knife, raise the feet.

5. Tighten the locking nuts.

Rollers

Knife

Locking

Nuts

Getting Started 1-3

Step 3 - Connect the Power Cord

1. Plug the power cord into the stacker’s AC inlet.

2. Plug the other end of the power cord into a grounded outlet.

Once the power cord is attached to an outlet, the stacker is

on. There is no power ON/OFF switch for the stacker.

ACInlet

1-4 Getting Started

Step 4 - Check the Alignment

1. Load supply in the printer. For more information about

loading supply, refer to the printer’s Operator’s Handbook or

Quick Reference.

2. Set aside the tag weight.

3. Widen the guide rails to maximum width by pulling and

extending the guide rails out of the grooves at the bottom of

the tray.

4. Slide the rod ends of guide rails by using both hands to the

outer position.

GuideRails

Grooves

Getting Started 1-5

5. Move tag stop up and down by using your thumb to pull out

slightly on the release tab and lift up until it stops.

Adjust the tag stop to the length of the tags.

6. Make sure the transport lock handle is in the locked position.

7. Make sure supply is loaded and the printer is turned on.

8. Press the Feed or Cut button on the printer or keyboard

several times.

The supply should feed through the knife and tags should be

cut and placed in the stacker tray.

TagStop

TransportLock

1-6 Getting Started

This manual suits for next models

Table of contents

Other Avery Dennison Printer manuals

Avery Dennison

Avery Dennison 686 HT User manual

Avery Dennison

Avery Dennison Monarch ADTP1 Service manual

Avery Dennison

Avery Dennison Monarch Service manual

Avery Dennison

Avery Dennison M09416 TTXLI User manual

Avery Dennison

Avery Dennison M09416 XLI User manual

Avery Dennison

Avery Dennison Monarch 9419 Service manual

Avery Dennison

Avery Dennison Monarch 9485 User manual

Avery Dennison

Avery Dennison MONARCH 9416 XL Technical Document

Avery Dennison

Avery Dennison Pathfinder 6059 Service manual

Avery Dennison

Avery Dennison FRESHMARX 9415 Service manual

Avery Dennison

Avery Dennison Monarch 9493 SNP Use and care manual

Avery Dennison

Avery Dennison Monarch Pathfinder Ultra Silver 6032 Service manual

Avery Dennison

Avery Dennison Monarch 9485 User manual

Avery Dennison

Avery Dennison AP5.4 User manual

Avery Dennison

Avery Dennison MONARCH 9416 XL User manual

Avery Dennison

Avery Dennison Monarch 9864 User manual

Avery Dennison

Avery Dennison Pathfinder 6140 User manual

Avery Dennison

Avery Dennison AP7.t User manual

Avery Dennison

Avery Dennison AP4.4 User manual

Avery Dennison

Avery Dennison TTX 207 User manual

Avery Dennison

Avery Dennison Pathfinder6057 Operating and maintenance manual

Avery Dennison

Avery Dennison TrafficJet User manual

Avery Dennison

Avery Dennison Monarch ADTP1 User manual

Avery Dennison

Avery Dennison 9486 User manual

Popular Printer manuals by other brands

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series quick start guide

Evolis

Evolis Elypso user guide

Kyocera

Kyocera FS-9530DN specification

Canon

Canon LASER SHOT LBP-1210 Specifications

Samsung

Samsung BIXOLON SRP-350plusF user manual

Canon

Canon PIXMA PRO-1 Series Getting started

Canon

Canon PIXMA G3560 Online manual

Dell

Dell Color Laser Printer 2130cn user guide

Tektronix

Tektronix Phaser 840 user guide

Epson

Epson ET-7750 Programming guide

Canon

Canon CLBR 460ps Service manual

Eltron

Eltron P210 Guide manual

Ricoh

Ricoh MD-P1 Service manual

Epson

Epson SC-F7100 series user guide

Epson

Epson Stylus C40UX Service manual

Canon

Canon imagePASS-A2 Service guide

Canon

Canon S820D user guide