Amcor SF 10000E User manual

PORTABLE AIR CONDITIONER

SF 10000E 12000E

Portable air conditioner

3 4

1 Extendable window guide(inner/outer part)

2 Screw, washer, nut

3 Flexile exhaust hose 4 Adapter (for exhaust hose)

Remote Control5

POSITIONING

Installing Exhaust Hose to Window Slide Bar

Note: The window kit is only designed to be installed with sliding windows or doors.

The window kit is not designed or to be used with casement style windows.

Step 1:

Measure your window kit according to the dimensions of your sliding window. If in case the unit is larger than

your required dimensions, it can be cut using a saw or power tool of the sort. If the unit is too short for your

opening, you can order an additional window kit from our online store to extend it.

Step 2:

Screw slide bar connector into exhaust hose rst (Figure A) , then spin the exhaust hose into the air outlet located

at the rear of the unit (counter-clockwise) (Figure B).

Step 3:

Insert slide bar connector into adjustable slide bar (Figure C). Extend the Slide Bar length to match the

width of the window (vertically or horizontally), and then tighten the screw to hold the length of the slide bar

(Figure D). Make sure the adjustable slide bar ts snug in your window and stays in place.

Proceed to close and lock your window on the Slide Bar to secure in place (Figure E).

IMPORTANT

The exible exhaust hose can be extended from 10.25" to 58.5" for mounting.

We recommend that you keep the hose as short as possible to minimize possible loss back in the room.

This length has been designed especially according to the speci cations of the air conditioner.

Do not use an extension or exchange for a different hose as that may lead to malfunctioning.

The exhaust air must low freely. Any blockage can lead to overheating of the air conditioner.

Handle with care to prevent any kink or bend in the exhaust hose.

This unit can easily be moved from one room to another. In doing, so keep this in mind:

• The air conditioner must stand upright on an even surface.

•Do not position near bath, sink, or other permanent, wet or damp area.

• Keep unit at least 18" from wall, curtains, draperies, or heat sources to insure adequate air circulation.

18"

45cm

18"

45cm

Exhaust

Hose

Exhaust

Hose

Slide Bar

Connector

Slide Bar

Connector

Window

Adjustable

Slide Bar

Adjustable

Slide Bar

Fasten

one screw

Air Outlet

Figure A

Figure B

Figure C

Figure E

Figure D

OPERATION

Cooling Mode

·After machine turns on, default value is cooling mode with 22ºC and low fan speed.

·Press “MODE” to select cooling mode, cooling mode indictor turns on .

·Press “UP” or “DOWN” to adjust temperature (from 16ºC to 31ºC).

·Press “FAN” to select fan speed (low, high)

Fan Mode

·Press “MODE” to select fan mode, fan mode indicator turns on .

·Press “FAN” to select fan speed (low, high)

·Temperature and sleeping function cannot be setup.

Timer Mode

·Under standby mode, press “TIMER” to setup the power-on time,

press “TIMER” to adjust the timer (from 1 to 24 hours). Timer indicator turns on.

·Under power-on mode, press “TIMER” to setup power-off timer.

Press “TIMER” to adjust the timer (from 1 to 24 hours). Timer indicator turns on.

Sleeping Mode

·Press key “SLEEP” enter into sleeping mode, default value of fan speed is low.

·When sleeping mode turns on , under cooling mode, the one hour later, setting temperature will go up

1ºC, the second one hour later, setting temperature will go up another 1ºC, and then keep the same;

·Sleeping mode is invalid under dehumidifying and fan mode.

Under water full, machine standby and mode conversion, sleeping mode will be cancelled .

Compressor Protection

·Three minutes later after power on / restart, compressor starts to run.

On/Off

Press “POWER” to switch the unit On or Off

Remote control

The air conditioner responds to all signals that are sent by the remote

control. Two AAA-batteries are required to use the remote control.

Note: the air flow direction can not be adjusted with the remote control.

Important:

• The compressor will start approximately 3 minutes after the unit is turned on

(this will help prolong the life of the compressor). After switching the unit off,

please wait at least 3 minutes before turning the unit back on.

• The cooling will switch off when the room temperature is lower than the set one.

Ventilation will however continue to work at the set level. When the ambient

temperature rises above the chosen value, the cooling will resume.

Power

Timer

Down

Mode

Fan

Sleeping

EMPTYING THE WATER CONTAINER

In case of the WATER FULL (W.F.) LED alert, the unit is required to be

drained. At the end of AC Season, this unit should be drained prior

to storage. In both situations, we recommend that you take the

following steps.

Switch off the unit and remove the plug from the outlet.

•Position a at container or dish on the oor under

the drain hole. Use container only for temporary

draining of the unit, do not allow the water to drip

continuously into the container, as it might easily

over ow.

•Remove the drain knob.

•Remove the rubber plug, the water will ow in the

container. When this is nearly full, replace the plug

to stop the water flow and empty it. Repeat this

process until all water has been removed.

•For seasonal storage purposes, put the unit ON in fan mode on a warm, dry day for

a couple of hours to ensure that the inside can dry out completely. We also recom-

mend allowing the unit to air dry for a period of 24 hours without the drain plug and

cap in place.

•Insert the rubber plug into the drain hole rmly,

the WATER FULL LED (W.F.) should not ash any longer.

• Screw on the drain knob.

Additional maintenance/tasks prior to storage.

•Clean the filters.

•Store the power cable as shown, protect the unit against dust (put back into its

original carton) and store in a dry place not accessible for children.

•To protect the unit against dust, store in a dry place not accessible by children

•Do not stock heavy objects on top of the unit

Rubber Plug Drain Knob

CLEANING

Always unplug the unit from the power supply (wall outlet) before beginning the

cleaning.

Housing

Use a soft, damp cloth to wipe the body clean. Never use strong chemicals, oil-

based products, detergents, chemically treated cloths or other cleaning solutions.

These could possibly damage the housing.

Filter

Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from

the filters and then rinse only the dust filter thoroughly under running water (not

warmer than 31 °C). Dry thoroughly before replacing.

Notice! Never operate the air conditioner without the filters.

Never try to repair or dismantle the air condition yourself. Incompetent repairs result in loss of warranty

and can endanger the user and the property.

noituloSesuaCmelborP

The air

conditioner does

not function.

No power supply. Connect to a functioning outlet and switch on.

Is the power light ﬂashing? Empty the drain pan.

Timer function is active. Deactivate the TIMER function.

The air

conditioner does

not seem to

perform.

The unit is in direct sunlight. Close curtains.

Windows or doors open, many

people or a heat source in the room.

Close doors and windows, place an extra air

conditioner.

The filter is dirty. Clean or replace the ﬁlter.

Air inlet or air outlet blocked. Remove the blockage.

Room temperature lower than the

selected value.

Change temperature selection. Set at the

lowest possible setting: 16°C.

The unit is noisy. Unit stands uneven. Place on an even, solid surface (less

vibrations).

The compressor

does not work.

The overheat protection is probably

activated.

Wait 3 minutes until the temperature has

decreased, then turn on the unit again.

The remote

control does not

function.

Distance too great. Make sure the remote control is correctly

aimed at the control panel.

Remote control signal not detected

by the control panel.

The batteries are drained. Replace the batteries.

To correct problems that have not been described in the table and/or if the recommended solutions fail

to solve the problem, contact an authorized service centre.

TROUBLE SHOOTING

STORAGE

See the instructions "Emptying the water container".

• Drain the condensed water completely.

• Clean or change the filter.

• Put the unit on a warm day in fan mode for a couple of hours to ensure that the

inside can dry out completely.

• Store the power cable as shown, protect the unit against dust (put back into its

original carton) and store in a dry place not accessible for children.

-• Do not stock heavy objects on top of the unit.

This manual suits for next models

Table of contents

Other Amcor Air Conditioner manuals

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual