Amcor 10KE-410 User manual

PORTABLE AIR CONDITIONER

AMC

7KE-410

10KE-410

12KE-410

Portable air conditioner

1. Control panel

2. Air outlet

3. Handle

4. Casters

5. Air filter

6. Air inlet

7. Exhaust air outlet

8. Cord hanger

9. Water stopper (plug inside)

10. Foam extension

11. Foam with hole

12. Water tray

13. Hose adapter

14. Window/wall adapter

15. Cap

16. Exhaust hose

17. Water tube

18. Remote control

PARTS

SAFETY INSTRUCTIONS

Thank you for choosing this innovative Amcor air conditioner. We suggest that you

keep this manual in a safe place for future reference. It describes the many benefits

and advanced features this unique product has to offer. Before you use your air

conditioner you should carefully read these instructions to maximise this product’s

performance.

For over 50 years Amcor has specialised in complete indoor environmental control,

manufacturing and marketing; dehumidifiers, portable air conditioners, coolers, air

purifiers, ionisers and aroma therapy scent diffusers. These world class products

incorporate the latest technological developments.

THANK YOU

IMPORTANT!

• The unit is designed for indoor operation.

• Rating: This unit must be connected to a 220-240 V / 50 Hz earthed outlet.

• The installation must be in accordance with regulations of the country where the

unit is used.

If you are in any doubt about the electrical installation, have it checked and if

necessary modified by a qualified electrician.

• The air conditioner is safe. However, as with other electrical appliances, use it

with care.

• Keep out of the reach of children.

• Do not clean the unit by spraying it or immersing it in water.

• Do not insert any object into the openings of the unit.

• Disconnect it from the mains before cleaning the unit or any of its components.

• Never connect the unit to an electrical outlet using an extension cord. If an outlet

is not available, one should be installed by a licensed electrician.

POSITIONING

This unit is portable and can easily be moved from one room to another. In doing

so keep this in mind:

• The air conditioner must stand upright on an even surface.

• Position not (near) bath, douche or other wet or damp area.

• Keep for free air circulation at least 50 cm free from any obstacle or curtains.

• Never operate this appliance if it has a damaged cord or plug. Do not lead the

cord over sharp edges.

• A damaged supply cord should be replaced by the manufacturer, its service agent

or a qualified person in order to avoid a hazard.

• Any service other than regular cleaning or wick replacement should be performed

by an authorized service representative. Failure to do so could result in a loss of

warranty.

WARNING

• Put the exhaust hose into the round side of the exhaust hose adapter (13) (fig. 1).

• Put the wall/window adapter (14) onto the exhaust hose (fig. 2).

• Connect the hose with the rectangular end to the air conditioner (fig. 4).

Using the foam.

Place the foam with the hole (11), if needed together with the foam extension (10),

in the window and close this as far as possible to refrain the warm air from re-

entering the room (fig. 5). Depending on how the window opens, horizontally

(fig. 3a) or vertically (fig. 3b).

Pass the hose through the opening in the foam (11).

Permanent hole in glass or wall.

Place the wall/window connector (14) in the hole with diameter 130 millimetre

(fig. 6). Connect the hose with the rectangular end to the air conditioner (fig. 4).

Use the cap (15) to close the opening when the air conditioner is not used.

Important

The flexible exhaust hose can be extended from 300 to 1500 mm for mounting.

This length has been designed especially according to the specifications of the air

conditioner. Do not use an extension or exchange for a different hose as that may

lead to malfunctioning.

The exhaust air must flow freely, any blockage can lead to overheating of the air

conditioner. Take care to prevent any bow or bend in the exhaust hose.

1 2 3a 3b

456

16 16

OPERATION

1. ON/OFF

Press the ON/OFF-button to switch the unit on or off. The unit selects the

operating mode depending on the room temperature:

- with an ambient temperature higher than 23 °C, cooling mode is selected

- is the ambient temperature between 20 °C and 23 °C, then will fan mode be active.

2. Timer button

Use this button to set a working time between 1 and 12 hours. The TIMER LED will

be on. The unit switches off when the set time has run down.

3. Mode switch

Select with this button the required operating mode: automatic, cooling or fan.

The corresponding LED will lit: AUTO, COOL or FAN.

4. Fan speed

Select with this button the fan speed, the corresponding LED will lit: LO - low ,

HI - high.

5. Temperature selection

Set the temperature that must be maintained (in the range from 18 °C to 32 °C) with

the buttons TEMP.UP and TEMP.DOWN. The display will show the setting.

Digital display

When the unit is ON the display shows the room temperature, RT LED is on. Press

button TEMP.UP or TEMP.DOWN to see the set temperature, the ST LED is then

on. After a few of seconds the room temperature will be displayed and the RT LED

will be on again.

532

Remote control

The air conditioner can be operated with the remote control. Two AAA-

batteries are required to use the remote control. Point the remote control

hand set towards the control panel of the unit and press the relevant button,

the red LED on the hand set will flash whenever a button is pressed.

Air flow

a.Turn the roller to control the air flow direction of the vertical louvres.

b.Move the air vent directly to adjust the air flow direction of the horizontal louvres.

Notices:

• The compressor has been set so that it starts functioning three minutes after the

(re)start of the air conditioner.

• The cooling will switch off when the room temperature is lower than the set

one. Ventilation will however continue to work on the set level. When the room

temperature rises above the selected value, the cooling will work again.

When the water container is full, the compressor and

the ventilator stop functioning, the POWER LED will

flash.

Switch off the unit and remove the plug from the

mains.

• Place the water tray flat on the floor under the drain.

• Remove the drain knob.

• Remove the rubber plug and fill the water tray then replace the plug to stop

the water flow. Empty the tray and repeat this process until all water has been

removed.

• Replace the rubber plug and the drain knob, plug the unit in and switch on. The

POWER LED should not flash any longer.

EMPTYING THE INTERNAL WATER CONTAINER

a b

Rubber plug Water tray

Drain knob

Switch off the unit and remove the plug from the mains.

• Remove the drain knob and the rubber plug.

• Connect the correct water tube onto the water outlet.

• Place the other end in a normal drain.

• Make sure that the tube is free from twists and bends.

The tube must incline over its entire length.

Dehumidification

If the unit will be used mainly as dehumidification, do not connect the exhaust hose

and let the warm air return in the room. Continuous drainage is then convenient

and more efficient.

First of all switch off the unit and pull the plug.

Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol,

detergents or other cleansing solutions.

Filter

The single layer screen filter cleans the circulated air. The filter needs to be cleaned

regularly with a vacuum cleaner to avoid blocking the air flow.

Notice! Never use the air conditioner without filter.

CLEANING

PERMANENT DRAINAGE

STORAGE

See the instructions "Emptying the water container" on page 7.

• Drain the condensed water completely.

• Clean (or replace) the filter.

• Put the unit on a sunny day in fan mode for a couple of

hours to ensure that the inside becomes completely dry.

• Store the power cable as shown, protect the unit against

dust and store in a dry place not accessible for children. Cable storage

Never try to repair or dismantle the air condition yourself. Incompetent repairs result in loss of warranty

and can endanger the user and the property.

Problem Cause Solution

The air

conditioner does

not function.

No power supply. Connect to a functioning outlet and switch on.

Is the LCD light ﬂashing. Empty the internal water container.

Timer function is active. Deactivate TIMER function.

The air

conditioner does

not seem to

perform.

In direct sunlight. Close curtains.

Windows or doors open, many

people or a heat source in the room.

Close doors and windows, place an extra air

conditioner.

Dirty filter. Clean or replace the ﬁlter(s).

Air inlet or air outlet blocked. Remove the blockage.

Room temperature lower than the

selected value.

Change temperature selection.

The unit is noisy. Unit stands uneven. Place on an even, solid surface (less

vibrations).

The compressor

does not work.

The overheat protection is probably

activated.

Wait 3 minutes until the temperature has

decreased, then turn on the unit again.

The remote

control does not

function.

Distance too great. Make sure the remote control is correctly

aimed at the control panel.

Remote control signal not detected

by the control panel.

The batteries are drained. Replace the batteries.

To correct problems that have not been described in the table and/or if the recommended solutions fail

to solve the problem, contact an authorized service centre.

TROUBLE SHOOTING

Model AMC

7KE-410

AMC

10KE-410

AMC

12KE-410

Cooling capacity BTU/h 6500 8300 9600

kW 1.9 2.4 2.8

Mains 220–240 V / 50 Hz / 1Ph

Power consumption W 690 830 1030

Current A 3 3.7 4.5

Dehumidification L/24h 24 28.8 36

Air delivery m3/h 300 350 350

Recommended room size m212 18 24

Refrigerant R410A

Compressor rotary

Fan speeds 2

Thermostat °C 18 – 32

Timer h 1 – 12

Dimensions (W x H x D) mm 377 x 750 x 400

Weight kg 29 30 32

Subject to modifications without prior notice.

Please refer to the rating label for greater precision.

TECHNICAL DATA

Reminder:

Waste electrical products must not be disposed of with household waste.

This product should be taken to your local recycling centre for safe treatment.

This manual suits for next models

Table of contents

Other Amcor Air Conditioner manuals

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual