3Activation
3.1 2G/GPRS
To activate the sensor, hold the supplied magnet to the
hot spot, a beep will be heard to indicate correct
placement of magnet.
Keep the magnet held to the hot spot until a second
beep is heard, remove magnet from hot spot once this
has been achieved.
A series of beeps will now be heard. This indicates the
GPRS is registering onto the GSM network.
Upon successful registration to the GSM network the sensor will attempt to
initiate a GPRS connection to the myTecalemit server. This is indicated by
higher pitched beeping.
The successful activation of the sensor is indicated by two successive short
beeps two seconds apart. This will wake the sensor from dormant mode and
activate it to make a join-request to the server.
It is recommended to log in to myTecalemit to check whether the sensor
readings are received on the server and whether the readings are OK before
leaving the installation site.
3.2 4G/LTE
To activate the sensor, hold the supplied magnet to the
hot spot which can be found directly below the LED.
As the magnet is held to the hot spot, the LED will first
flash Green then flash Red, after this the Red LED will
light continuously, remove magnet from hot spot once
this has been achieved.
A series of beeps will be heard while this Red LED remains illuminated. This
indicates the GSM/GPRS is registering onto the cellular network.
After successful registration in the cellular network, the sensor attempts to
establish a connection to the myTecalemit server.
After successful activation of the sensor, the green LED lights up and a double
beep pattern sounds. This will wake the sensor from dormant mode and
activate it to make a join-request to the server.
It is recommended to log in to myTecalemit to check whether the sensor
readings are received on the server and whether the readings are OK before
leaving the installation site.
