Sper scientific 300058 User manual
Waterproof Digital
Refractometer
300058, 300059,
300060, 300062,
300063, 300064
& 300065
Instruction Manual
2
Waterproof Digital Refractometer
Copyright ©2017 by Sper Scientic
ALL RIGHTS RESERVED
Printed in the USA
The contents of this manual may not be reproduced
or transmitted in any form or by any means electronic,
mechanical, or other means that do not yet exist or may
be developed, including photocopying, recording, or
any information storage and retrieval system without the
express permission from Sper Scientic.
3
TABLE OF CONTENTS
1. INTRODUCTION . . . . . . . . . . . . . . . . . 4
2. MATERIALS SUPPLIED . . . . . . . . . . . . . 5
3. FEATURES . . . . . . . . . . . . . . . . . . . . 5
4. POWER SUPPLY . . . . . . . . . . . . . . . . . 6
5. FRONT PANEL DESCRIPTION . . . . . . . . . . 7
6. LCD DESCRIPTION. . . . . . . . . . . . . . . . 7
7. CALIBRATION. . . . . . . . . . . . . . . . . . . 8
8. MEASUREMENT PROCEDURES . . . . . . . . 9
9. ERROR CODES. . . . . . . . . . . . . . . . . . 10
10. SCALE INFORMATION . . . . . . . . . . . . .10
11. SPECIFICATIONS . . . . . . . . . . . . . . . . 12
12. WARRANTY . . . . . . . . . . . . . . . . . . . 16
4
INTRODUCTION
Housed in a protective rubberized IP65 Waterproof case
to safeguard the electronics from wet environments and
makes for easy clean ups Model 300058 features a
scratchproof sapphire lens.Measure samples as small
as 1 ml, in the eld with laboratory accuracy. Sample
temperature is initially displayed on the large LCD
followed by the measurement results. The sophisticated
microprocessor provides automatic calibration, automatic
temperature compensation and automatic shuto.
Powered by a rechargeable, long-life, Li (Lithium Ion)
battery providing 50,000 tests on a single charge.Simple
one-button calibration using distilled water ensures
accurate readings.
5
MATERIALS SUPPLIED
• Refractometer
• One lithium-Ion battery
• DC Power Adapter
• Distilled Water
• Transfer pipet
• Instruction Manual
• Carrying Case
FEATURES
• Displays sample temperature followed by
measurement result
• IP65 Waterproof, rugged exterior
• Rechargeable battery
• Low battery indicator
• DC power adapter
• Automatic shuto
6
POWER SUPPLY
The meter is powered by one rechargeable lithium-ion
battery. An icon in the upper-right corner of the LCD
indicates the level of battery power available:
75%-100% power
40%-75% power
15%-40% power
Less than 15% power. (This icon will ash)
The DC adapter included plugs into the port on the left
side of the meter. This both provides an alternate power
supply and recharges the battery.
Automatic Shuto
The power will automatically shut o if the meter is not
used for 3 minutes.
7
FRONT PANEL DESCRIPTION
1. POWER - Power on/o
2. READ - Read measurements /select scale
3. CAL - Calibrate meter
4. LENS COVER
LCD DISPLAY
1. S 1 - Current scale number
2. BATTERY ICON -
Battery power level
3. DISPLAY - Displays temperature
and readings
1 2 3 4
8
CALIBRATION
Use distilled water (refractive index 1.3330 to 1.3340)
to calibrate the meter.
1. With the meter turned o, place a few drops of
distilled water on the lens.
2. Close the lid to cover the lens.
3. Press POWER to turn the meter on.
4. The temperature of the distilled water appears
on the LCD.
5. Press and hold CAL for 2 seconds to enter
Calibration Mode. “CAL” will be displayed to indicate
that calibration is occurring.
6. When calibration is nished the meter returns to
Measurement Mode and “ - - - ” is displayed on
the LCD.
Note…
For best results, calibrate the meter at 20°C.
Measurements can be taken at other temperatures, but
the calibration should be done at 20°C.
9
MEASUREMENT PROCEDURES
After calibration you can remove the distilled water from
the lens and begin measurement.
Note…
Use a clean, lint-free cloth or tissue to remove solutions
from the lens.
1. With the meter turned o, place a few drops of the
solution being measured on the lens.
2. Press POWER to turn the meter on.
3. The temperature of the solution appears on the LCD.
4. Close the lid to cover the lens.
5. Press Read to view the measurement on the LCD.
6. To change scales, press and hold Read for 2 seconds
until the scale number changes. Repeat to cycle
through the available scales. (see page 10)
7. Press Read if desired to repeat the measurement.
10
MEASUREMENT ERRORS
Certain conditions can cause an error code to
appear on the LCD:
Error Code & Cause
HHH The measurement is above the upper limit
LLL The measurement is below the lower limit
SCALE INFORMATION
Scale Indicator & Name - 300058
S1 Brix
S2 Refractive Index
S3 Dextran
S4 Fructose
S5 Glucose
S6 Lactose
S7 Maltose
Scale Indicator & Name - 300059
S1 Brix
S2 Refractive Index
Scale Indicator & Name - 300060
S1 Brix
S2 Refractive Index
Other manuals for 300058
1
This manual suits for next models
6
Table of contents
Other Sper scientific Measuring Instrument manuals
Sper scientific
Sper scientific AquaShock 850034K User manual
Sper scientific
Sper scientific 850097 User manual
Sper scientific
Sper scientific 860040 Guide
Sper scientific
Sper scientific 850007 User manual
Sper scientific
Sper scientific 300100 User manual
Sper scientific
Sper scientific 840021 User manual
Sper scientific
Sper scientific DS-2013SD User manual
Sper scientific
Sper scientific 840003 User manual
Sper scientific
Sper scientific AquaShock Bluetooth pH Kit 850057K User manual
Sper scientific
Sper scientific 850048 User manual
Sper scientific
Sper scientific 850020 User manual
Sper scientific
Sper scientific 850001E User manual
Sper scientific
Sper scientific 850026 User manual
Sper scientific
Sper scientific 300079 User manual
Sper scientific
Sper scientific 300037 User manual
Sper scientific
Sper scientific 840020 User manual
Sper scientific
Sper scientific 850019 User manual
Sper scientific
Sper scientific 850050 User manual
Sper scientific
Sper scientific 850069 User manual
Sper scientific
Sper scientific 840063 User manual
