Sony CCB-WD1 User manual
CCB-WD1
4-735-433-11(1)
CCB-WD1
4-735-433-11(1)
C:\4735433111\4735433111CCBWD1CEE\00COV-CCBWD1CEE\000COV.indd
DTP data saved: 2017/11/10 11:17
PDF file created: 2017/11/10 16:40
Camera Control Box
Instruction Manual
CCB-WD1
4-735-433-11(1)
GB
2
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
English
WARNING
To reduce fire or shock hazard,
do not expose the unit to rain or
moisture.
IMPORTANT SAFETY
INSTRUCTIONS
-SAVE THESE
INSTRUCTIONS
DANGER
TO REDUCE THE RISK
OF FIRE OR ELECTRIC
SHOCK, CAREFULLY
FOLLOW THESE
INSTRUCTIONS
If the shape of the plug does
not fit the power outlet, use an
attachment plug adaptor of the
proper configuration for the power
outlet.
Use a nearby wall outlet (wall
socket) when using the AC
Adaptor/Battery Charger. If any
malfunction occurs, disconnect
the plug from the wall outlet (wall
socket) immediately to disconnect
from the power source.
If you use the product with a
charge lamp, note that the product
is not disconnected from the
power source even when the lamp
turns off.
CAUTION
For safety, do not connect the
connector for peripheral device
wiring that might have excessive
voltage to LAN terminal. Follow
the instructions for LAN terminal.
Power Cord
For the customers in the UK,
Ireland, Malta, Cyprus and Saudi
Arabia
Use the power cord (A). For safety
reasons, the power cord (B) is not
intended for above countries/
regions and shall therefore not be
used there.
For the customers in other EU
countries/regions
Use the power cord (B).
(A) (B)
LAN cable
Use a Category 5e or higher
Shielded Twisted Pair (STP) cable
with high shielding performance.
CCB-WD1
4-735-433-11(1)
GB
3
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
For Customers in the U.S.A.
For question regarding your
product or for the Sony Service
Center nearest you, call 1-800-222-
SONY (7669).
Declaration of Conformity
Trade Name: SONY
Model No.: CCB-WD1
Responsible Party: Sony
Electronics Inc.
Address: 16535 Via Esprillo, San
Diego, CA 92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with part
15 of the FCC rules. Operation
is subject to the following two
conditions: (1)This device may not
cause harmful interference, and
(2)this device must accept any
interference received, including
interference that may cause
undesired operation.
For Customers in Canada
CAN ICES-3 B/NMB-3 B
Notes on using
your product
• Refer to the Sony website for the
compatible models.
• Along with this manual, refer to
the Help Guide (page 12) of this
product and the instruction manual
of your camera.
Notes on handling the product
• This product is neither dust-proof,
nor splash-proof, nor water-proof.
• Do not leave the product or
the supplied accessories within
the reach of infants. They may
be accidentally swallowed. If
this occurs, consult a doctor
immediately.
On the data specifications
described in this manual
The data on performance and
specifications are defined under
the following conditions, except
as described in this manual: at an
ordinary ambient temperature of
25ºC (77°F).
CCB-WD1
4-735-433-11(1)
GB
4
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
Notes to avoid access by
unintended third parties
Depending on the environment of
use, unintended third parties may
access your network. Only connect
this product to networked devices
managed by you. Connection
to other networked devices is
performed at your own risk. This
product may be accessed without
authorization and the contents of
communications may be intercepted.
Notes on discarding this product,
transferring it to others, or
returning a rented product
To prevent your data from being
leaked, execute the “Initialize”
function by following the procedure
below before you discard the
product, transfer it to others, or
return a rented product.
1 Connect the product to a
computer (page10).
2 Connect the product to the
AC Adaptor, and then turn the
product on (page11).
3 Launch a web browser on the
computer, and then execute the
“Initialize” function (page12).
• Initialization may take a long time.
Connect the product to a stable
power source so that it does not
turn off partway through.
• Set the MASTER/CLIENT switch
on the product as described on
page9.
Checking the
product and the
supplied items
The number in parentheses
indicates the number of pieces.
•Camera control box (1)
•Multi terminal connecting cable
(S) (1)
•Multi terminal connecting cable
(L) (1)
Two cables with different
lengths are supplied.
•Micro USB cable (1)
•AC Adaptor (1)
The shape of the AC Adaptor
may differ depending on the
country/region.
•Power cord (mains lead) (1)*
(supplied in some countries/
regions)
* Multiple power cords may be
supplied with this equipment.
Use the appropriate one that
matches your country/region.
See page2.
•Cable protector (1)
•Set of printed documentation
CCB-WD1
4-735-433-11(1)
GB
5
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
Identifying parts
ON/OFF (Power) switch
This switch turns the power on
or off.
MASTER/CLIENT (Master/
Client) switch
Set this switch to “MASTER”
for one of the camera control
boxes, and to “CLIENT” for the
others.
Access lamp
Micro USB connector
Use this connector to connect
the product to the AC Adaptor
(supplied).
Multi terminal
Use this terminal to connect
the product to a camera.
Tripod socket hole
Use a tripod with a screw less
than 5.5mm (7/32inches)
long. Otherwise, you cannot
firmly secure the product, and
damage to the product may
occur.
Power lamp
LAN terminal
Use this terminal to connect
the product to a computer or a
switching hub.
CCB-WD1
4-735-433-11(1)
GB
6
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
Connecting to a camera and a computer
Connect this product to a camera and a computer to operate the camera
from the computer.
You can operate multiple cameras at once from a single computer by
connecting them as illustrated below.
Set the MASTER/CLIENT switch on one of the products (camera control
boxes) to “MASTER.” Then, set the MASTER/CLIENT switches on the others
to “CLIENT.”
Conceptual diagram
DSC-RX0 Camera control box
Switching hub Computer
Note
• You can connect one camera to this product. To use multiple cameras, you
must connect each camera to a separate camera control box.
• It is recommended that you use 1000BASE-T switching hubs and LAN cables
rated as category 5e or higher.
CCB-WD1
4-735-433-11(1)
GB
7
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
Cable protector
Use the cable protector to prevent the cables from being disconnected.
Run all the cables through the cable protector, and then connect the
cables to the product.
Attach the cable protector
to the product so that it
aligns with the shape of the
connector compartment,
and then secure the cable
protector by tightening the
two attachment screws.
Attachment screws
Secure the cables with the
fixing dial.
Fixing dial
CCB-WD1
4-735-433-11(1)
GB
8
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
Connecting the product to a camera
Connect the product to the camera using the multi terminal connecting
cable (supplied).
• On the camera, set MENU (Setup) [USB Connection] to
[PC Remote] before you connect it.
• On the camera, set MENU (Setup) [PC Remote Settings]
[Still Img. Save Dest.] to [PC+Camera].
• Insert a memory card into the camera.
• If you will be using the camera for a long period of time, it is
recommended that you set MENU (Setup)
[Auto Pwr OFF Temp.] to [High] on the camera.
1 Connect the multi terminal on the product with the Multi/
Micro USB Terminal on the camera using the multi terminal
connecting cable (supplied).
• You cannot connect the camera to the micro USB connector on the
product.
DSC-RX0
Camera control box
Hint
• Two cables with different lengths are supplied. Use the appropriate one for
the installation environment.
CCB-WD1
4-735-433-11(1)
GB
9
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
Setting the MASTER/CLIENT (Master/Client) switch
Set the MASTER/CLIENT switch to
“MASTER” if you will be using one
camera.
To use multiple cameras at once,
set the switch on one of the camera
control boxes to “MASTER.” Then,
set the switches on the others to
“CLIENT.”
MASTER/CLIENT switch
When you change the setting
Set the ON/OFF (Power) switch to “OFF” to turn off the product before
changing the setting of the MASTER/CLIENT switch.
CCB-WD1
4-735-433-11(1)
GB
10
C:\4735433111\4735433111CCBWD1CEE\01GB-CCBWD1CEE\01GB.indd
DTP data saved: 2017/11/29 16:03
PDF file created: 2017/11/29 16:09
Connecting the product to a computer or switching hub
Connect the product to a computer or switching hub using a commercially
available LAN cable.
1 Connect the LAN terminal on the product with the LAN port on
the computer or switching hub using a LAN cable.
• You cannot connect the computer or switching hub to the micro USB
connector or multi terminal on the product.
To the LAN port on the
computer or switching hub
• If you connect this product to a switching hub, connect your
computer to the same network.
Note
• Use a device without a router function or a device whose router function is
disabled as the switching hub to which you connect this product.
Other manuals for CCB-WD1
1
Table of contents
Other Sony IP Camera manuals
Sony
Sony FCB-EX2700P User manual
Sony
Sony SNC-ZB550 User manual
Sony
Sony HDC1500R User manual
Sony
Sony SRG120DH User manual
Sony
Sony SNCEM602R User manual
Sony
Sony FDR-X3000 Instruction sheet
Sony
Sony BRCSDP16 User manual
Sony
Sony URZ0146 User manual
Sony
Sony HDC-X310 User manual
Sony
Sony High Contrast License Plate Capture Camera User manual
Sony
Sony HXC-100 User manual
Sony
Sony 3-AXIS INDOOR DOME CAMERA User manual
Sony
Sony HDC-X300 User manual
Sony
Sony IMX035 User manual
Sony
Sony IPELA PCSA-CXA55 User manual
Sony
Sony Ipela SNC-CH135 User manual
Sony
Sony HDC2580 User manual
Sony
Sony Ipela User guide
Sony
Sony Effio-V User manual
Sony
Sony HSC300RF User manual
