Logger start / land threshold defines altitude change needed for
takeoff/landing detection (in ±1m steps). Long press middle button
when FTime widget is highlighted to manual start/stop flight time
stopwatch.
Logger timeout is count down time used for landing detection if
altitude stays within defined interval (in seconds).
Logger suppress audio checkbox mutes the device when waiting
for takeoff, so launch area is not saturated by random mix of
annoying sounds generated by many waiting varios.
GPS enable checkbox enables/disables onboard GPS receiver
(significant for battery power).
GPS status shows ratio of fixed/available satellites.
GPS time shows actual GMT time obtained from GPS receiver.
GPS date shows actual date obtained from GPS receiver.
GPS speed units, used for ground speed widget GSpd, can be
chosen from –m/s, km/h, mph or knots.
GPS format of coordinates can be chosen from –DD.dddddd, DDº
MM.mmmʹ or DDº MMʹ SSʺ.
Bluetooth module shows used type onboard.
Bluetooth enabled checkbox enables/disables bluetooth function
(using this function significant for battery power).
Bluetooth protocol selection changes devices communication
between protocols (apps) –DigiFly (XCSoar), LK8EX1 (XCtrack),
BlueFly (FlyMe) or SkyBean. SkyDrop SPP Bluetooth device must
be chosen when pairing with your phone or tablet.
Bluetooth forward GPS checkbox will enable forwarding GPS
coordinates to connected device, so there is possibility to turn off its
internal GPS receiver to save power.
Time item in settings menu allow adjust on-board clock.
Date item in settings menu allow adjust on-board date.
Time zone entry is useful with GMT time obtained from GPS
receiver to set correct local time.
DST checkbox means daylight saving time option if applicable.
Sync with GPS checkbox allows to get accurate time from GPS.
Display contrast adjustment tunes LCD screen contrast.
