RCbenchmark 1580 Series User manual
Dynamometer Series 1580/1585
Assembly Manual 1.15
For the latest version
of the manual and
extra tutorials, please visit
RCbenchmark.com
1Install 5kg load cell
Note: for added safety, you may use removable (blue) thread-
locking fluid to secure the screws. Do not use permanent (red) fluid.
Wires out on
this side
2x M4
5kg
Lower structural
part
Install 2kg load cell and
upper structural part
⚠
2
2x 2kg
load cell
Wires pointing
inside for both load
cells
4x M5
Do not
tighten
yet.
2x M5
Upper
structural
part
Attach hinges to motor mounting part
2x Hinge
4x M4 5mm
Motor mounting part
3
2x Spacer
2x M4 Washer
2x M4 12mm
4x M4 5mm
Do not tighten yet
Data
acquisition
board
⚠
Assemble data
acquisition board,
motor mounting part,
and lower structural part
4
Top view
Position 2kg load cells parallel to each other and
tighten
Parallel
Tighten 4x
Tighten 4x
5
6
Connect in the following order: the load
cells, the power cables, and the USB cable
Secure the 3 wires
along the edge
using 4 tie-wraps
Positive input (+)
(red wire to
power supply)
Bottom view
3x Connect load
cells under circuit*
USB cable
*Load cell connector
orientation is not important
Ground input (-)
(black wire to
power supply)
Software installation
Press "Connect"
7
1) Go to docs.rcbenchmark.com/en/dynamometer/
software/dynamometer-software-download.html
to install the app.
2) Launch the application from your computer.
3) Connect the device to a computer using the USB cable.
4) Press the "Connect" button in the app as seen below.
Follow the instructions provided in the app to calibrate your
device. Recalibrate the device if it has been disassembled, if
the wires have been moved, or every 2 months.
1) Go to the "Utilities" tab.
2) Calibrate the thrust.
3) Calibrate the torque
and the weight.
Calibration
8
Other manuals for 1580 Series
2
This manual suits for next models
1
Table of contents
Other RCbenchmark Measuring Instrument manuals
