Potter PFC-6006 User manual
PFC-6006
Conventional Fire Panel
8830038 - REV E • 4/19 PAGE 1 OF 2
Potter Electric Signal Company, LLC • St. Louis, MO • Phone: 800-325-3936 • www.pottersignal.com
Features
• 6 Programmable Initiating Device Circuits
• ClassAorClassBWaterowInitiatingCircuit
• 2 Wire Smoke Detector Compatibility
• 1.0AmpPowerSupply
• 1NoticationCircuitratedat0.5AmpsRegulated
• Strobe Synchronization for Potter/AMSECO, Gentex, System
SensorandCooper/Wheelock
• 0.5AmpAuxiliaryPower,ProgrammableasConstantor
Resettable
• 2x16LCDdisplaywithsystemLEDsforclearsystemstatus
• Keypadforsystemfeatures
• P-LinkforRemoteAnnunciatorConnections
• Capacitytochargeandhouse18AHbatteries
• OnboardDualLineDigitalAlarmCommunicator
• Built-inEthernetConnectionwithlistedIPCommunicator
• AbilitytoE-mailsystemstatus,reportsandsystemconguration
• ServiceReminderE-mails
General Description
ThePFC-6006isalistedsmallconventionalresystemideallysuited
tomonitorasmallresystemsuchasaresprinklersystem.Therst
inputisselectableasaClassAorClassBwaterowinputandtheother
vezonesareselectablefromamenuofoptionsincludingtwo-wire
smokedetection.Thepanelhasa1.0amppowersupplythatpowers
thepanel,chargesthebatteriesandsupplies0.5ampstoanotication
appliancecircuitand0.5ampsofauxiliarypower.Theauxiliarypower
is programmable as constant or resettable.
Thecontrolpanelisinametalcabinetwithakeylockandlexanwindow
forviewingthesystemstatus.Theprintedcircuitassemblyismounted
forquickremovalandinstallationtoallowthecabinettobeinstalledwith
minimaleffort.Thecabinethousesuptotwo12VDC,18AHbatteries.
Thedisplayisathirty-two(32)characterLCDwithsystemstatusLEDs.
Thesystemstatusisclearlydisplayedandthepanelincludesahistory
bufferforpastevents.Thekeypadallowsnavigationintothesystem
menu, limited programming and system control. The condition and
eventsonthepanelareclearlydisplayedtoallowtheuserandinstaller
todeterminethesystemstatus.
Thepanelhasadualtelephonelinedigitalalarmcommunicatortransmitter
(DACT)builton-board.Oneorbothtelephonelinesmaybeenabled
toallowcommunicationtoaremotemonitoringstation.Inaddition,an
updatedpanelcongurationmaybesenttothepanelthroughthetelephone
lines.Thepanelhaslineinandlineouttoallowthepaneltobeinstalled
aheadofothertelephoneequipmentonthepremises.
Thepanelwillsupportuptofour(4)oftheRA-6075remoteannunciators
ontheP-Linkbus.Theseannunciatorsincludeametalenclosurewitha
keylockandprovidefullfunctionalityofthesystem.
Thepanelispre-programmedfromthefactoryformonitoringatypical
wetordryresprinklersystem.Theprogrammingmaybechangedusing
thePotterFirePanelProgrammer(availablefreefromwww.pottersignal.
com)andastandardEthernetcable.Thedefaultprogramisasfollows:
Input1-Waterow
Input2-SmokeDetection(two-wire)
Input3-ManualPullStation
Input4-Non-LatchingSupervisory
Input5-ValveTamper
Input6-ValveTamper
7165-0328:0204 S735
NYC Fire Dept.
Certicateof
Approval
6282
Size(HxWxD) 18-1/2"x14-1/4"x4-3/4"
Enclosure Eighteen (18) gauge sheet steel with hinged,
removablelockeddoor
AC Mains 1.0amp@120VAC60Hz
Battery 105mAStandby
160 mA Alarm
Temperature 32°to120°F,humidity93%non-condensing
Standards/
Approvals
UL-864
NFPA-70,72
Technical Specications
8830038 - REV E • 4/19 PAGE 2 OF 2
Potter Electric Signal Company, LLC • St. Louis, MO • Phone: 800-325-3936 • www.pottersignal.com
PFC-6006
Conventional Fire Panel
Acknowledgements
Gentex ®, Cooper Wheelock ®, and System Sensor ® synchronization
protocols used with permission. Cooper Wheelock Patent Nos. 5,400,009.
Potter Electric Signal Company LLC
PFC-6006
US: POTAL01BSMP
Complies with 47 CFR Part 68.
Made in USA.
See board for Serial #.
PFC-6006
Sprinkler Monitoring Panel
Primary AC
120VAC, 60Hz, .75 AMP
Min Low AC Detect 98VAC
Battery Charging
All Circuit Impedance Values
27.3VDC @ .5A
Low Battery Detect @20.4VDC
Short Circuit: 0 Ohms
Open Circuit: >10K
Earth Fault to any terminal: 0 Ohms
Main Fuse Specication
1.6A-250VAC
Batt. Fuse Specication
2.5A-250VAC
F.C.C.
CAUTION:
De-Energize Unit Prior to Servicing
Requirements
System must be fully tested after installation.
Intended for indoor use in dry locations only.
Separation of power limited wiring from non-power limited wiring must be at
least 1/4".
Install in accordance with installation manual Part Number 5403559 - ___,
and Operating instructions - Part #5406282 - ___.
NFPA Commercial Protected Premises Control Unit for UL Installations:
See Smoke Detector Compatibility Identifer “A”
13, 70, and NFPA 72.
Alarm activation requiring activation of two or more automatic detection
devices shall not utilize any time delay.
P/N 5406280 (4/1/2019)
This device has been veried to comply with FCC Rules Part 15,
Class A Operation is subject to the following conditions:
1. This device may not cause radio interference.
2. This device must accept any interference received including any
that may cause undesired operation.
Battery connection (non-power limited).
Use two (2) 12V batteries connected in series.
Service Use for UL Installations:
- Local
- Remote Station
- Proprietary
- Central Station
E.O.L.E.O.L.
BATTERY
- +
PLINK
A- A+
- + - + - + A B
AUXNAC
Programming
Connection
6 Conventional Inputs, fully programmable
& support 2-wire smoke detector
POTS DACT CONNECTION
ALARM SIGNAL ACTIVATION
PRESS LEFT & RIGHT
ARROW KEYS AT SAME
TIME TO TRIGGER ALARM
SIGNAL ACTIVATION.
LAMP TEST: PRESS [ENTER], [5],
PASSWORD, [6]. PRESS THE [ESC] KEY
WHEN DONE.
GROUND
F
U
S
E
BLACK
WHITE
120VAC 60Hz
Connect to separate
unswitched AC circuit
Use 14 AWG or heavier gauge
wire with 600V insulation
E.O.L.E.O.L.E.O.L.E.O.L.E.O.L.
INPUT3
- + B- B+
INPUT4 INPUT5INPUT6
- + - + - +
INPUT2INPUT1
- +
Line2 In Line2 Out Line1 In Line1 Out
Tip Ring Tip Ring Tip Ring Tip Ring
FUSE
Battery -
Battery +
ONLY DETECTORS THAT ARE SHOWN IN
THE COMPAT IBILITY LIST ARE TO BE USED.
12 3
45 6
78
0ESC
ENTER
POWER ON
EARTH FAULT
ALARM
ALARM SIGNAL ACTIVATION
PRESS LEFT + RIGHT ARROWS
SUPERVISORY
TROUBLESILENCED
FIRE
DRILL
ACK
NOWLEDGE
SIGNAL
SILENCE RESET
9
NYC Fire Dept. Certicate of Approval #6159 & 6184
FIRE ALARM
EQUIPMENT
3PDS
SIGNAL SYSTEM CONTROL UNIT
___________OF___________
Inthestandardprogram,Input1isdefaultedasaWaterowzone.Input1istheonlyClassA/ClassBzone.Thepanelwillautomaticallydetermine
ClassAorBbasedonwiringandthepresenceoftheendoflineresistor.AlloftheinputsmaybeprogrammedforGeneralAlarm,Waterow,Two-
WireSmokeDetector,HeatDetector,ManualPullStation,Non-latchingSupervisory,LatchingSupervisory,orValveTamper.
TheNACislistedforstrobesynchronizationandthepanelislistedwithPotter/AMSECO,Gentex,SystemSensor,andCooperWheelocksignals.
PleaserefertothePotterNoticationCompatibilityDocumentforthemaximumnumberofstrobedevicesthatmaybeconnected.Themaximum
outputis0.5amps.
TheEthernetconnectionmaybeconnectedtoabuildingnetworkwithInternettoprovidee-mailnoticationsofsystemstatus,reports,orsystem
conguration.Inaddition,theEthernetconnectionislistedforIPreportingtoamonitoringstation.
Ordering Information
Model Description Stock No.
PFC-6006 Conventional Fire Panel 3992334
Replacement Board 3992346
Other manuals for PFC-6006
1
This manual suits for next models
1
Other Potter Measuring Instrument manuals
