
MiniDigi 2-Channel Digitizer Setup Guide
2 5046262 A
MiniDigi Digitizer Installation
The optional accessory MiniDigi digitizer works with AxoScope Software only. Clampex Software does not
support the MiniDigi digitizer.
To configure the MiniDigi digitizer in AxoScope Software:
1. Run the pCLAMP 10.6 installer before you connect the MiniDigi digitizer to the computer.
2. After pCLAMP has been installed, connect the USB cable to the USB port on the computer and to the
MiniDigi digitizer.
3. In the Windows Found New Hardware Wizard, follow the instructions until Windows has installed the
digitizer.
4. Start AxoScope Software by clicking Start > All Programs > Molecular Devices > pCLAMP 10.6 >
AxoScope 10.6.
5. Open the Configure > Digitizer dialog and click Change.
6. In the Change Digitizer dialog, select MiniDigi from the Digitizer Type field.
7. Click Scan to detect the digitizer. Available is displayed, and OK is enabled.
8. Click OK to exit this dialog.
9. Click Configure to open the Configure MiniDigi dialog.
10. Select the style of filtering to use.
Analog filtering applies a low-pass, anti-aliasing filter with a cutoff frequency one fifth of the
sampling rate.
MinMax filtering takes the minimum and maximum samples in every n samples, where n is
determined by the sampling rate.
11. To calibrate the MiniDigi digitizer, attach a grounding plug to the Channel 0 BNC, and then click Start.
12. Repeat for Channel 1.
13. Click OK to exit this dialog.
The MiniDigi digitizer is now ready to do experiments.
For research use only. Not for use in diagnostic procedures.
The trademarks mentioned herein are the property of Molecular Devices, LLC or their respective owners. These trademarks may not
be used in any type of promotion or advertising without the prior written permission of Molecular Devices, LLC.
Patents: http://www.moleculardevices.com/productpatents
Product manufactured by Molecular Devices, LLC.
1311 Orleans Drive, Sunnyvale, California, United States of America 94089.
Molecular Devices, LLC is ISO 9001 registered.
©2016 Molecular Devices, LLC.
All rights reserved.