Installation Instruction
34606 Vibrator Kit
for Models: BL240/BL400
INSTALLATION INSTRUCTIONS
A. Place Vibrator mounting plate (7) inside hopper and align to measurements shown. Using the mounting plate as a guide mark
and drill four 3/8” holes thru the hopper. See figure 1.
B. Fasten vibrator mounting plate (7) on inside of hopper and Vibrator (2) on outside of hopper using 3/8-16 x 1-1/2” Bolt (3),
3/8” Flatwasher (5) and 3/8-16 Locknut (4).
C. Install Vibrator Controller (1) inside cab. Connect blue wire on the vibrator controller (1) to a 12VDC keyed ignition
accessory. Connect Green wire on the vibrator controller (1) to the white wire of the vibrator harness (6). Connect
black wire on vibrator harness (6) to ground. Connnect Black wire on vibrator controller (1) to ground. Connect
White wire on vibrator controller (1) to the positive post of the motor. Connect red wire on vibrator controller (1) to
the positive post of the battery. See figure 2.
OPERATING INSTRUCTIONS
The Meyer 34405 Speed Controller is an electronic module powered off the switched ignition circuit +12Vdc
and supplying the heavy motor current from the +12Vdc battery circuit. The controller will only function with
the ignition key in the ON state. The controller is connected to the spinner motor and vibration motors via a
custom wire harness that is designed to handle the high motor currents. The controller can be mounted under
the vehicle dash using mounting hardware that is provided in the kit. The controller is weatherproof and can be
mounted in areas where it will get wet. The controller includes 5 wires as follows:
1) Ignition wire Blue (power to the controller through switched ignition).
2) Power wire Red (power to the controller directly from 12V battery).
3) Output wire White (connects to the spreader motor positive post).
4) Output wire Green (connects to the vibrator motor).
5) Ground wire Black (provides ground for the controller).
After all the above connections been made and ignition switch is at on position. When the controller On/Off
button located on the front display panel is momentarily depressed once, the LED above the On/Off button will
illuminate and the spreader motor will automatically be activated with 5 full power Blasts and then stop, the On/
Off LED will remain steady on. The spreader unit is now activated. The spreader unit will be deactivated if the
controller On/Off switch is momentarily depressed a second time. The vibrate motor will start and stop when
the vibrate button is depressed only when the unit is activated. LED above the vibrate button will be illuminated
when the vibrator motor is activated. Once the ignition is turned off and then turned back on the spreader
controller will need to be turned back on for spreader operation.
Item Part No. Qty. Description
34606 Sand Vibrator Kit
1 34405 1 • Controller Vibrator
2 38070 1 • Vibrator
34607 1 • Hardware Bag
3 20051 4 •• Bolt 3/8-16 x 1-1/2”
4 20314 4 •• Locknut 3/8-16
5 22230 8 •• Flawasher 3/8”
6 38051 1 • Vibrator Harness 20’
7 38053 1 • Vibrator Plate
Parts List
Parts indented are included in the assembly under which they are indented.
Meyer Products reserves the right, under its continuing product improvement program, to change construction or design details,
specifications and prices without notice or without incurring any obligation.
Form 1-1034
December 2011
