3. Splice Feature
Press PROGRAM and or to enter the Stop and
Hold menu. Press . Enter the Splice Time.
The splice feature provides a splice input signal (TB3-
18) and a splice time for changing rolls. The splice time
is entered in seconds. Upon a momentary contact
closure betweenTB3.18 and TB3.15, the diameter value
is forced to the core diameter for the duration of the
splice time. The normal diameter display is returned
when the splice time expires.
4. Set the Dancer Position
Press PROGRAM, to enter the Dynamic Tuning menu.
While holding the dancer arm in the desired running position, press +and - until the display says OK.
Press .
5. Tuning
The screen to the right is the Tuning screen.
Pressing or when in this screen chooses CORE,
FULL, or EXIT. Pressing or adjusts the dancer
position (if necessary). Pressing +or –adjusts the
tuning (+will normally increase the stability and –will
increase the responsiveness.)
In the following steps, the words +(FULL) means to press +when FULL is selected, -(FULL) means
to press –while FULL is selected, etc. When asked to “STABLIZE” an oscillation, perform one of the
following steps:
1. If the dancer is oscillating rapidly (faster than several seconds per cycle), press + until the
oscillation stops. OR
2. If the dancer is oscillating slowly (several seconds per cycle), press –until the oscillation stops.
NOTE: The next step requires that the machine be running near full roll. If this is a rewind, a
preliminary adjustment can be made at core with final tuning done at full roll. If the dancer
position oscillates during winding, use the appropriate method above to stop the oscillation.
With a full roll mounted, run the machine at a low speed.
If the dancer position is oscillating stabilize the dancer. If necessary, adjust the dancer position using
or .
If the dancer position is not oscillating, press –(FULL) until the dancer position begins to oscillate.
