Kramer TP-789R User manual

TP-789R Quick Start (P/N: 2900-300966QS REV 1)

P/N:

2 9 0 0 - 3 0 0 9 6 6 QS

Rev:

Scan for full manual

TP-789R Quick Start Guide

This guide helps you install and use your TP-789R for the first time.

Go to www.kramerav.com/downloads/TP-789R to download the latest user manual and check if firmware

upgrades are available.

Step 1: Check what’s in the box

TP-789R HDMI Line Receiver

4 Rubber feet

1 Quick start guide

1 Power adapter and cord

1 Bracket set

Step 2: Get to know your TP-789R

Feature

Function

SETUP DIP-switches

Set the operation DIP-switches.

IN LED

Lights green when an active far-end source device input signal is

detected.

OUT LED

Lights green when an active sink (acceptor) output signal is detected

via the HDBT link.

LINK LED

Lights green when an HDBT link is established with the HDBaseT

transmitter.

POE FEEDER LED

Lights green when the device is feeding PoE power to the HDBT

connected transmitter.

ON LED

Lights green when the device receives power either from the power

supply unit or by PoE.

HDBT IN RJ-45 Connector

Connect to the RJ-45 HDBT OUT connector on a transmitter (for

example, WP-20, TP-780T).

HDMI® OUT Connector

Connect to an HDMI acceptor.

IR 3.5mm Mini Jack Connector

Connect to an external infrared emitter / sensor.

RS-232 (G, Rx, Tx) 3-pin Terminal Block Connector

Connects to an RS-232 port for serial link extension to a transmitter.

48V DC Power Terminal Block Connector

If TP-789R provides PoE, connect it to the Kramer power adapter.

If it accepts PoE, no power connection is needed.

The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Step 3: Install TP-789R

Install TP-789R using one of the following methods:

• Attach the rubber feet and place the unit on a flat surface.

• Fasten a bracket (included) on each side of the unit and attach it to a flat surface.

For more information go to

www.kramerav.com/downloads/TP-789R.

• Mount the unit in a rack using the recommended rack adapter

(see www.kramerav.com/product/TP-789R).

Step 4: Connect the inputs and outputs

Always switch OFF the power on each device before connecting it to your TP-789R. For best results, we recommend that you

always use Kramer high-performance cables to connect AV equipment to TP-789R.

Connecting TP-789R as a power provider:

Connecting TP-789R as a power acceptor:

RJ-45 Pinout:

DIP-Switch Settings

For the Ethernet connector, see the wiring diagram

below:

All DIP-switches are set to OFF (up) by default.

Changes to DIP-switch 4 only take effect after

rebooting the device.

PIN EIA /TIA 568B

Wire Color

Feature

Dip-switch Settings

Orange / White

Reserved

For future use.

Orange

Reserved

For future use. Set to OFF (up).

Green / White

Frequency

OFF (up) – IR frequency is 38kHz.

ON (down) – Wide-range modulated IR frequency.

Blue

Blue / White

Set to OFF for backward compatibility

with 38kHz IR extension.

Green

Brown / White

Upgrade

OFF – Normal operation mode.

ON – HDBT FW upgrade mode.

Brown

For optimum range and performance use the

recommended Kramer cables available at

www.kramerav.com/product/TP-789R.

When set to ON device operation is

disabled.

Step 5: Connect the power

When used as a PoE provider, connect the 48V DC power supply to TP-789R and plug it into the mains electricity (to also provide

power to a transmitter).

When accepting power from an HDBT transmitter via PoE there is no need to connect the 48V DC power supply.

Safety Instructions

Caution:

There are no operator serviceable parts inside the unit.

Warning:

Use only the Kramer Electronics power adapter that is provided with the unit.

Warning:

Disconnect the power and unplug the unit from the wall before installing.

See www.KramerAV.com for updated safety information.

Step 6: Upgrade the firmware

Upgrade the firmware by:

• Setting the DIP-switches.

• Loading the new firmware via

the RS-232 port on the

TP-789R.

RS-232 Pass-through Data

Baud Rate:

115,200

Data Bits:

Stop Bits:

Parity:

None

Command Format:

ASCII

Technical Specifications

Input

HDBT

On an RJ-45 connector

Output

HDMI

On a female HDMI connector

Ports

RS-232

On a 3-pin terminal block connector for serial link extension

On a 3.5mm mini-jack connector for IR link extension

Video

Max Bandwidth

10.2Gbps

Max Resolution

4K@60 (4:2:0)

Compliance

HDMI 2.0 and HDCP 2.2

Extension Range

4k@60 (4:2:0)

Up to 40m (130ft)

Full HD (1080p@60Hz)

Up to 70m (230ft)

Extended RS-232

Baud Rate

300 to 115200 baud

Extended IR

Frequency

20kHz to 100kHz

Direction

Bidirectional (IR sensor or emitter)

Controls

Front Panel

IN, OUT, LINK, POE FEEDER and ON LED indicators

Rear Panel

DIP-switches

Power

Consumption

48V DC, 350mA

Source

48V DC, 1.36A

Environmental

Conditions

Operating Temperature

0° to +40°C (32° to 104°F)

Storage Temperature

-40° to +70°C (-40° to 158°F)

Humidity

10% to 90%, RHL non-condensing

Regulatory

Compliance

Safety

Environmental

RoHs, WEEE

Enclosure

Size

Tool

Type

Aluminum

Cooling

Convection ventilation

General

Net Dimensions (W, D, H), each

12cm x 7.2cm x 2.4cm

(4.7" x 2.8" x 0.94")

Shipping Dimensions (W, D, H)

15.7cm x 12cm x 8.7cm

(6.2" x 4.7" x 3.4")

Net Weight, each

0.2kg (0.44bs) approx.

Shipping Weight

0.72kg (1.6lbs) approx.

Accessories

Included

1 Power adapter, 1 power cord and 1 bracket set per device

Specifications are subject to change without notice at www.kramerav.com

Table of contents

Other Kramer Receiver manuals

Popular Receiver manuals by other brands

Garmin

Garmin GA 23 Owner's manual and reference guide

Aiphone

Aiphone PS-12F instructions

IMES

IMES TCS-01CA-PMI Original Operating Instruction

BWI Eagle

BWI Eagle AIR-EAGLE SR Product information bulletin

AMIMON

AMIMON AMN12310 WHDI datasheet

Dual

Dual DMCPA79BT Installation & owner's manual

Sound Associates

Sound Associates SA652P Operation manual

Sherwood

Sherwood NewCastle R-772 Service manual

Audio

Audio A10-RX Series user guide

AllSee

AllSee PushShare PSRV1.1 user manual

DEMAG

DEMAG DRC-DR D2 operating instructions

Teleco

Teleco TVRCL868A02 manual

Bosch

Bosch RF3222E installation instructions

Xpress

Xpress xmc10 installation guide

JVC

JVC KD-MR1BTS instruction manual

Omega Engineering

Omega Engineering UWTC-REC3 user guide

e-survey

e-survey E300 Pro user manual

Dish Network

Dish Network Satellite Television user guide