Knightsbridge LWALL1A Instruction Manual

INSTALLATION & MAINTENANCE MANUAL

LWALL1A / LWALL2A / LWALL3A

These instructions should be read carefully and retained after installation by the

end user for future reference and maintenance.

These instructions should be used to aid installation of the following products:

LWALL1A / LWALL2A / LWALL3A

GENERAL INSTRUCTIONS

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring

Regulations (BS7671) and current Building Regulations. If in any doubt, consult a

qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is ﬁtted) does not exceed

the rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this luminaire when deciding the location

for installation

• This product is Class I and must be earthed

• This product series is IP65 rated

INSTALLATION

Note - If this luminaire is being used in conjunction with an external PIR or sensor, please

conﬁrm with the manufacturer of the sensors that they are compatible with LED luminaires

• Provide power to the required point of installation (refer to BS7671 for correct cabling

methods). Suitable IP rated junction boxes should be used where required

• Round cable should be used for the mains supply. The use of ﬂat cable will cause water

ingress to the ﬁtting

• Remove the baseplate from the luminaire by loosening the screws on the side

• Using the baseplate as a template, mark the location for, and drill the ﬁxing holes ensuring

not to infringe with any gas/water pipes or electrical cables

• Feed the mains cable through the

rubber grommet to retain IP rating,

and secure the baseplate to the

surface. Rubber washers or sealant

should be applied around the

screw heads to prevent water

ingress (see Fig. 1)

Fig. 1

5678

• Connect the luminaire to the mains supply ensuring the correct polarity is observed: Live

(brown), Earth (green/yellow), Neutral (blue) (see Fig. 2)

• Reﬁt the luminaire to the baseplate and tighten

• Switch on and check for correct operation

Fig. 2

•Connect the luminaire to the mains supply ensuring the correct polarity is observed: Live (brown),

Earth (green/yellow), Neutral (blue) (see Fig. 2)

Fig. 2

•Refit the luminaire to the baseplate and tighten

•Switch on and check for correct operation

WARNING

This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

The LED lamps fitted in this product are non-replaceable. The product should be recycled in the correct manner

when it reaches the end of its life. Check local authorities for where facilities exist.

Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not

use aggressive cleaning products or solvents which may damage the product.

Do not use any source of high-pressure washers to maintain or clean this luminaire.

This product is not suitable for installation in or near a coastal or marine environment.

This product is non-dimmable.

WARRANTY

This product has a warranty of 2 years from date of purchase. Failure to install this product in accordance with

the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will

invalidate the warranty. If this product should fail within its warranty period it should be returned to the place of

purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve

the right to alter product specification without prior notice.

AVAUG20_V1

WARNING

WARRANTY

GENERAL

This product must be disconnected from the circuit if subjected to any high voltage or

insulation resistance testing. Irreparable damage will occur if this instruction is not followed.

This product is not suitable for installation in or near a coastal or marine environment.

This product has a warranty of 2 years from date of purchase. Failure to install this product

in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper

use, or removal of the batch code will invalidate the warranty. If this product should fail

within its warranty period, it should be returned to the place of purchase for a free of

charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML

Accessories reserve the right to alter product speciﬁcation without prior notice.

The light source of this luminaire is not replaceable; when the light source reaches its end of

life the whole luminaire should be replaced.

Clean the external surfaces with a damp cloth using a mild solution of detergent and warm

water only, do not use aggressive cleaning products or solvents which may damage the

product.

Do not use any source of high-pressure washers to maintain or clean this luminaire.

This product is non-dimmable.

This product should be recycled in the correct manner when it reaches the end of its life.

Check local authorities for where facilities exist.

AVOCT21_V2

-25

~35 °C

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

This manual suits for next models

Table of contents

Other Knightsbridge Lighting Equipment manuals

Knightsbridge

Knightsbridge BATC Series Instruction Manual

Knightsbridge

Knightsbridge TRLED 1 Series Instruction Manual

Knightsbridge

Knightsbridge BLED5BW Instruction Manual

Knightsbridge

Knightsbridge SPIKE5S Instruction Manual

Knightsbridge

Knightsbridge EMSWING Instruction Manual

Knightsbridge

Knightsbridge VFR7EM Instruction Manual

Knightsbridge

Knightsbridge UCLCT4 Instruction Manual

Knightsbridge

Knightsbridge TNXQUADMWW Instruction Manual

Knightsbridge

Knightsbridge EMRNST Instruction Manual

Knightsbridge

Knightsbridge HBN Series Instruction Manual

Knightsbridge

Knightsbridge LED Series Instruction Manual

Knightsbridge

Knightsbridge SHE P Series Instruction Manual

Knightsbridge

Knightsbridge BT14CTEM Instruction Manual

Knightsbridge

Knightsbridge SLIGHT2 Instruction Manual

Knightsbridge

Knightsbridge 24DCIP60 Instruction Manual

Knightsbridge

Knightsbridge LEDBATW Series Instruction Manual

Knightsbridge

Knightsbridge EMGUKIT1 Instruction Manual

Knightsbridge

Knightsbridge KIT4B Instruction Manual

Knightsbridge

Knightsbridge SPIKE5A Instruction Manual

Knightsbridge

Knightsbridge TNXQUADW Instruction Manual

Knightsbridge

Knightsbridge SHE S Series Instruction Manual

Knightsbridge

Knightsbridge BT9EMS Instruction Manual

Knightsbridge

Knightsbridge GDL2 Instruction Manual

Knightsbridge

Knightsbridge TNXQUADMWEMW Instruction Manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions