Polimerizator AQUAMAT GB 7
WAY OF USE
Put an object in the device. Pour as much liquid as needed to fill the chamber up to 2 cm below the
upper edge. Close the lid till it reaches the stopper. Start the process by pressing the button .
The process can be discontinued at any time by pressing the button again.
After starting the program, you must press the button for draining of the liquid, the relevant LED
flashes and the liquid will be drained automatically in the end of the process.
In case you need to drain the liquid manually this can be done when the device is not in mode for
program execution. For this purpose, the button should be pressed. Having emptied the device
you must press the same button again so that the electromagnet valve will close.
To start a working cycle while the difference between set temperature and temperature in the bowl
is less than 10°С, you must press and hold the button for several seconds. The unit will start after
issuing a beep.
This unit can work without heating. You can start the different working mode by pressing the two
arrow buttons and simultaneously.
This way pressured air will enter into the chamber and will stay there for preliminary adjusted time.
This mode is useful for preliminary dry pressing of some objects.
WARRNING!
Do not open the lid of the device before the temperature drops under 100°C because then
the water will boil and there will be risk of burns.
Take care of the red silicone sealing ring that is under the hood. If it is dry, wet it with water
before closing the lid to protect it from accidental damage.
THERMAL PROTECTION
This device is equipped with thermal protection. If the temperature in the chamber exceeds 150°С a
special component will stop the heating.
To restore normal function, you need to:
•unplug the device from the socket;
•remove the left side cover;
•resume normal work by pressing the red button which is on the thermal protection component;
