WIFI led indication, if you push the setting button last 5s, the WIFI led will flash 1s
inte val ,its means mete ente into the status of waiting fo WIFI dist ibution netwo k . if WIFI
led light on 5s , light off 0.1s ,it means mete connect the WIFI successfully.
Impulse led indication: it will flash with diffe ent speed acco ding the cu ent load of the
mete
Relay led indication: the led light off means elay switch on, the led on means elay
switch off .
Down bond: you can push this button to check the diffe ent data display , it will
eset the esettable active ene gy to ze o when you push this button last 5s ,but total active ene gy
will not eset.
Setting button: if you push the setting button last 5s ,mete will ente into the status of
waiting fo WIFI dist ibution netwo k .if you want to eset status of WIFI dist ibution netwo k,
you also can push the setting button last 5s.
6.1 Connection diag am
Terminal 1 and 2 is for
RS485 port , 2A and 1 B ,Impusle 6+ 5-
6.2 Installation
The mete can be installed on a 35 mm DIN ail
6.2.1 The mete can not installed and used until it is checked goods and sealed befo e delive y
6.2.2 The mete should be install in the wate p oof box indoo o outdoo . the mete ’s box should
be fixed on st ong and flame- esistant wall with a ecommended height of about 1.8 m , whe e
the e is no co osive gas a ound .
6.2.3 The mete should be install fully in acco dance with connection diag am on the te minal
cove , it is bette to use coppe as the leading wi e fo connection. All sc ews should be tightened.
