more than 125% than setting voltage).
◆Red → Battery is overdischarging. Overdischarging is battery is blow
75% of setting voltage. It means necessary to charge or
replace battery.
④ Date and time: Displaying date and time at present.
⑤ Total voltage and charging current: Indicate total voltage of batteries in
series and charging current through current transformer.
⑥ Set-up: Entering set up mode.
⑦ Firmware version: It shows current version of firmware.
6-2. Setting
TDP-BM-100 is simple and convenience due to apply for touch screen
type of display. You press saw-toothed wheel shape of icon to enter set-up
mode. In the set-up mode, you could set battery capacity, battery voltage,
quantity of battery, rated voltage of current sensor, standard of low battery
alarm, overcharging alarm standard, and number of poor battery alarm. In
addition, current transformer is able to zero adjustment and identify data
with diagram for status of battery.
[Pic3] SET-UP mode
① Rated capacity: To set capacity base on usable battery specification.
② Nominal Voltage: To set voltage based on battery specification.
③ Total unit count: To set number of batteries in series.
④ Rated current transformer(CT): To set rate for current sensor to check
charging and discharging current.
⑤ Low voltage level: To set low voltage level. When battery voltage is
lower than low voltage level, alarm signal will output.
⑥ Over voltage level: To set over voltage level. When battery voltage is
higher than over voltage level, alarm signal will output.
⑦ Bad count for warning: To set number of poor battery for alarm. This
device detects each battery voltage to determine poor battery or not. If
poor battery is more than setting quantity, alarm signal will output.
