Page 9
808-P2 Manual
CHAPTER 4 - UNIQUE FEATURES
The SeeLeveL gauge has been designed for maximum ease of installation
and servicing, and for best operational features. The anchor at the
sender bar replacement. If the new sender bar is cut to the same length as
the old, no re-calibration is required.
esthetic appearance, and high durability due to the “give” in the plastic.
material to enhance reliability. The use of a digital rather than analog
sensing technique lowers power consumption to permit battery operation,
and ensures high accuracy with no drift or degradation. To accommodate
cut end sealed with a cap to prevent moisture or product contamination.
maximum height is less than 5 inches above the top of the tank so that it
will not protrude above the spillway.
be disconnected at both ends. There is approximately 10 times as much
into the display, no explosion hazard can exist.
The 808-P2 display enclosure used is waterproof and the internal circuitry
is also protected against moisture by an internal panel and a coating on
the circuit board. By being battery operated and not requiring truck power
reliability enhanced. The small size of the display box also makes it easy
that the gauge display is always visible, regardless of ambient lighting
conditions.
The use of an on-site programmer eliminates downtime waiting for factory
calibration parts, and allows easy reprogramming should the need arise.
The entire display, including decimal point, is completely programmable
to whatever units are desired. In addition to numbers, the letters F, U, L,
and E can be programmed to provide displays such as FULL, E, etc. The
alarm uses a transistor rather than a relay to increase current capability,
eliminate sparking, and eliminate gauge battery power drain.
