Flybox ALT57 User manual
Digital altimeter
ALT57
Revision#2.0, 18/11/2014
For firmware version 1.7
Flybox
®
Page intentionally left blank
MECHANICAL INSTALLATION
SECTIONS
ELECTRICAL INSTALLATION
USE OF THE INSTRUMENT
INSTRUMENT SETTINGS
TECHNICAL SPECIFICATIONS
FLYBOX
ALT57 - User’s manual
Rev. 2.0
®
Introduction
Thank you for purchasing a Flybox®product. We
hope it fully satisfy you and makes your flights
pleasant and secure.
Developing ALT57, our intent was to create a compact
and lightweight digital altimeter, easy to install and
quick to consult.
SYMBOLS USED IN THE MANUAL
NOTE: Used to highlight important informations.
CAUTION: Used to warn the user and indicate a potentially
hazardous situation or improper use of the product.
WARNING: Used to indicate a dangerous situation that can
cause personal injury or death if the instruction is
disregarded.
ALT57 -User’s manual
FLYBOX
Rev. 2.0
®
Important notices & warnings
NOTE: Keep this manual in the aircraft.
This document must accompany the instrument in the event
of change of ownership.
NOTE: This device is intended for installation onto non type
certified aircraft only, because it has no aviation certifications.
Refer to your local aviation authorities to check if this device
may be installed in your aircraft.
CAUTION: Read entirely this manual before installing the
instrument in your aircraft, and follow the installation and
operating instructions described here.
CAUTION: Using this instrument over the maximum
allowable ranges can cause malfunction or wrong indications.
CAUTION: Microel s.r.l. reserves the right to change or
improve its products. Information in this document is subject
to changes without notice.
FLYBOX
ALT57 - User’s manual
Rev. 2.0
®
Index
INDEX
SECTION 1 - Mechanical installation
1.1 - Mechanical installation ………………………………….. 7
1.2 - Dimensions …….…….…………...….………………….. 8
SECTION 2 - Electrical installation
2.1 - Electrical installation ……….……..………………….….. 10
SECTION 3 - Use of the instrument
3.1 - Use of the instrument ……….…..………….……………. 12
3.2 - Altimeter alert .….….….…..….….……..….……………. 14
SECTION 4 - Instrument settings
4.1 - Instrument settings …...…………………….……………. 16
SECTION 5 - Technical specifications …………..……………. 18
Warranty …….…………………………..……….……………. 19
ALT57 -User’s manual
FLYBOX
7
Rev. 2.0
®
Mechanical installation
SECTION 1
1.1 MECHANICAL INSTALLATION
The ALT57 fits in a standard 2 1/4” (57mm) panel cutout.1)
It's recommended to choose a position that permits optimal
display visibility.
2)
Connect the pipe fitting on the back of the instrument to a
static air pressure lines; the furnished pipe fitting is suitable
for pipe with internal diameter of 5 mm.
PRESSURE PORT CONNECTION:
FLYBOX
ALT57 - User’s manual
8
Rev. 2.0
®
Dimensions
1.2 DIMENSIONS
Front view
Dimensions in millimeters
ALT57 -User’s manual
FLYBOX
9
Rev. 2.0
®
Dimensions
Side view
Dimensions in millimeters
FLYBOX
ALT57 - User’s manual
10
Rev. 2.0
®
Electrical installation
SECTION 2
2.1 ELECTRICAL INSTALLATION
On the backpanel of the ALT57 there's a four-pole
connector (faston 6.3 mm); the connections are:
Table of contents
Other Flybox Measuring Instrument manuals
Flybox
Flybox EngiMaster User manual
Flybox
Flybox Omnia57 CHT-EGT User manual
Flybox
Flybox Omnia57 Series Product manual
Flybox
Flybox Omnia57-80 Series User manual
Flybox
Flybox Omnia57 G-METER User manual
Flybox
Flybox Omnia57-80 Series User manual
Flybox
Flybox Omnia57-80 Series User manual
Flybox
Flybox Omnia57-80 Series User manual
Flybox
Flybox Omnia57 MAP User manual
Flybox
Flybox EngiMaster User manual
