10
The M60 is washdown rated and features easily removable components. With the
exception of the motor and control panel, the M60 can be washed, cleaned, and wiped
down with normal detergents, degreasers, and disinfectants.
The door, rotor, screen, and hopper can all be removed to facilitate cleaning. The door can
be removed by simply lifting it off the hinges. To remove the rotor, lift up and hold the
pin on the spring plunger while sliding the rotor off of the shaft. To remove the hopper,
unfasten both hopper screws.
If necessary, the door gasket can also be removed for cleaning. The gasket is pressed by
hand into the groove around the circumference of the door.
Take care to not spray water directly onto the control panel.
The M60 is largely maintenance-free. The door gasket is the only wear component within
the M60. The condition of the door gasket should be inspected prior to each use. A faulty
or worn door gasket will not affect the operation of the machine, however it is necessary
for dust mitigation.
This User Guide does not include instructions for machine repair. For your safety, repairs
must be completed by ETEROS TECHNOLOGIES or an authorized service technician.
1. Ensure the power switch is in the off position, the power cord is unplugged, and the
emergency stop has been pressed.
2. Tilt the machine onto its back.
3.
Twist the fuse holder cap protruding from the bottom of the electrical box
counterclockwise. The cap will have white lettering that says “FUSE.”
4. Remove and safely discard the expended fuse. Insert the new fuse into the cap.
5.
Insert the new fuse and cap back into the electrical box and twist clockwise to secure.
Should the need arise, the 3A fuse can be replaced without any tools. To replace the fuse:
CLEANING THE MOBIUS M60
FUSE REPLACEMENT
PREVENTATIVE MAINTENANCE
CLEANING &
MAINTENANCE
