More, very useful, digital info can be readout when pushing the “OK” button in this
mode.
The following display will be shown on the LCD
CH = The selected channel (measured at) and frequency.
Demodulation type 16 QAM , 64 QAM or QPSK
Transmission: 2K or 8K
Guard ratio: 1/4, 1/8 , 1/16, 1/32
Hi-priority code rate: 1/2, 2/3, 3/4, 5/6, 7/8
Low-priority code rate 1/2, 2/3, 3/4, 5/6, 7/8
MER (Modulation Error Rate) Between 20 dB and >31dB
2.3 Multi channel-mode (view six channels)
In this mode the meter measure the signal strength of six individually selected
channels. DIGIAIR Pro can be set up with five such pages of six channels (5x6
channels). The page number is indicated in the top-right corner. To scroll through
the pages use the UP/DOWN buttons. To show/hide the channel numbers use the
OK button. The max-peak values are reset when changing page.
2.4 Spectrum-mode (view spectrum)
In this mode the meter shows all the channels between 45 MHz to 860 MHz.
One pixel-line represents one channel.
Move the cursor (the animated dotted line) with the UP and DOWN buttons and
place it over a “peak” (channel).
The signal-strength of the chosen channel is shown in the LCD (in dBuV).
3. Menu
The following menu is shown on the display when pressing down the MENU button:
This is the main menu. Use the “UP”/”DOWN” buttons to scroll up and down in the
menu system. Use the “OK” button to enable the selected function.
6
