DSE DSE4200 Installation and maintenance instructions
DSE4200 Quick-guide for use and start up
Congratulaons with your microwave-based moisture meter for balers, The DSE4200.
This guide is intended as a simple and straighorward guide how to get started using the DSE4200 with a few steps
aer installing it.
If your moisture meter is installed and prepared by
the dealer, you can always go through the menu
under the dierent menu items and change sengs
or repeat e.g. Zero Adjustment.
To start the menu, hold down the right-hand buon
for 3 seconds. Another opon is to press “Restore
factory sengs”, which will bring you through all
the sengs shown in this Quick Guide.
When power is applied to the display for the rst
me, the unit will perform a "system check" and try
to contact the RX and TX units.
If successful, the system will automacally proceed
to the "First me use" dialog. If this fails, there are
faults and shortcomings in the cabling. See user
manual.
Step 1. System Check
Step 2. First me use
Select Ok or Skip using the buons below the
display screen.
Step 3. Language
Select language by using the up/down arrow keys.
Final selecon is made with the arrow poinng to
the right. To get to the next point, press the "Door
buon".
Quickguide UK Version 1.00.00
NB! Density associated with microwave-based moisture meters is always DRY WEIGHT DENSITY.
The density is calculated as: (the weight of the bale in kg ÷ the moisture content of the bale in kg) / (the volume
of the bale in mᶾ)
The factory seng is 145 kg/mᶾ. This seng ts classic Heston presses (120 x 127 x 240 cm). If the moisture
meter is to be used for high-density Balers HD in midi format (120 x 90 x 240 cm), experience shows that it can
be advantageous to start with the seng 200 kg/mᶾ.
Step 5. Bale width
Set the desired density with the +/- keys and then
select Ok.
Step 4. Bale density
Use the arrow keys to select the correct bale width
and select Ok.
Step 7. Set and ready to use
If the press is empty, you select Yes. This is answered with Ok and the DSE4200 moisture
meter is now set and ready for use.
Visit www.dse4200.com for further info.
NB! Zero adjustment is a very important process that must be carried out, when the moisture meters are to be
used for the rst me and if they have not been in use for a longer period. Zero adjustment can only be done
correctly if the baler is empty.
If sudden incomprehensible measurements are experienced, it may be a good idea to repeat the zero adjustment
process.
Step 6. Zero adjust
Other manuals for DSE4200
1
Other DSE Measuring Instrument manuals
