meter will go to manual ranging & display and hold the maximum or
minimum reading and will update only when a new “max or min”
occurs.
4.5.2. Press the MAX/MIN key again and a blinking “MAX MIN” will
appear. The meter will display the MAX-MIN reading, To exit
MAX/MIN mode press and hold the MAX/MIN key for 2 seconds.
4.6 Backlight button (fig.6b)
4.6.1 Press the BACKLIGHT button to turn the backlighting ON.
4.6.2 Press the BACKLIGHT button again to turn the backlighting
OFF.
5.1 DC/AC Voltage
5.1.1 Select the “V ” range with the rotary switch, and press
the FUNC. button to select DCV or ACV.
5.1.2 The meter will automatically select the best voltage range.
5.1.3 Insert Black lead in COM terminal.
5.1.4 Insert Red lead in V-Ω-RPM terminal
5.1.5 Touch the Black probe to ground or to the negative (-) circuit
5.1.6 Touch the Red probe to the circuit coming from the power
source.
IMPORTANT: Voltage must be measured in parallel (Red
probe measuring circuit from power source).
WARNING: When measuring voltage, be sure the Red test
lead is in the terminal marked “V”. If the test lead is in an Amp
(A) or Milliampere (mA) terminal, you may be injured or the
meter damaged.
5.2 Resistance (Ω)
IMPORTANT: If you are testing an application that has capacitors in
the circuit, be sure to turn the power OFF on the test circuit and
discharge all capacitors. Accurate measurement is not possible if
external or residual voltage is present.
5.2.1 Select the Resistance “Ω” range with the rotary switch and
