Dato DTK801 User manual
DaTo Version G0113
MULTI-VOLTAGE
USER MANUAL
GLOW PLUG ANALYSER (DTK801)
DaTo Version G0113
CALIBRATION
It is advisable to calibrate the DTK801 before using.
Use the red test probe to touch the black alligator clip before powering on. Power on the unit by
pressing and releasing the Glow Plug button.
Long press the button while the boot-up screen is still on until reaching the end of the Auto-zero
countdowns.
Press to power on.
DaTo Version G0113
The glow plugs can now be tested accurately.
TO OPERATE
button.
itive” end of the glow plug with the tip of the red test probe.
DTK801 will take a reading every few seconds and the results are displayed on the LCD
as follow:
LCD Display
Perimeters
Indication
Beep Alarm
0.00Ω to 0.06Ω
Shorted
(cont. beep x20)
0.07Ω to 2.50Ω
OK
(no sound)
2.51Ω to 5.50Ω
High Resistance
(2 beeps x 5)
5.51Ω to 25.0 Ω
Bad Resistance
(cont. beep x20)
Open or 25.0 Ω
above
Open Circuit
(cont. beep x20)
Low Battery
warning –Cut OFF
at 2.0V
DaTo Version G0113
INTERNAL BATTERY
Use AAA batteries (X2).
AUTO SWITCH OFF
Auto switch off if the tool is not being used, to conserve battery life.
TORCH LIGHT
To light-up dim surroundings for finding the glow plug or other car electrical problem.
FRIENDLY ADVICE
Clean threads of all rust, dirt, oil or paint with solvent and a rag.
WARNINGS
This tool is not designed to test current (Amps.) To do so will damage the device. NEVER apply
voltage to this device!
Other Dato Measuring Instrument manuals
