Cognex DataMan 470 Series User manual

DataMan®470 Series

Quick Reference Guide

2020 April14

Revision: 6.1.6SR1.7

Precautions

To reduce the risk of injury or equipment damage, observe the following precautions

when you install the Cognex product:

lThe reader is intended to be supplied by a UL or NRTL listed power supply

with a 24VDC output rated for at least 2A continuous and a maximum short

circuit current rating of less than 8A and a maximum power rating of less

than 100VA and marked Class 2 or Limited Power Source (LPS). Any other

voltage creates a risk of fire or shock and can damage the components.

Applicable national and local wiring standards and rules must be followed.

lRoute cables and wires away from high-current wiring or high-voltage

power sources to reduce the risk of damage or malfunction from the

following causes: over-voltage, line noise, electrostatic discharge (ESD),

power surges, or other irregularities in the power supply.

lDo not install Cognex products where they are exposed to environmental

hazards such as excessive heat, dust, moisture, humidity, impact, vibration,

corrosive substances, flammable substances, or static electricity.

lDo not expose the image sensor to laser light. Image sensors can be

damaged by direct, or reflected, laser light. If your application requires laser

light that might strike the image sensor, use a lens filter at the corresponding

laser wavelength. For suggestions, contact your local integrator or

application engineer.

lChanges or modifications not expressly approved by the party responsible

for regulatory compliance could void the user’s authority to operate the

equipment.

lInclude service loops with cable connections.

lEnsure that the cable bend radius begins at least six inches from the

connector. Cable shielding can be degraded or cables can be damaged or

wear out faster if a service loop or bend radius is tighter than 10X the cable

diameter.

lThisdevice should be used in accordance with the instructions in this

manual.

lAll specifications are for reference purposes only and can change without

notice.

Product Overview

1Lens

2 Illumination LED clusters

3 Mounting holes (M3 x 5mm)

4 Indicator light ring

5 Trigger button

6 Power

7 Train status

8 Read/no-read indicator

9 Network

10 Error

11 Peak meter

12 SD card slot

13 Tuning button

14 Ethernet

15 External light control

16 Power, I/O, and RS-232

DataMan 470 Series Accessories

LENS OPTIONS AND COVERS

Accessory DM474 DM475

12 mm F8 fixed aperture lens LEC-CFF12-F8

16 mm F8 fixed aperture lens LEC-CFF16-F8

25 mm F8 fixed aperture lens LEC-CFF25-F8

35 mm F8 fixed aperture lens LEC-CFF35-F8

40 mm F8 fixed aperture lens LEC-CFF40-F8

50 mm F8 fixed aperture lens LEC-CFF50-F8

Liquid lens module and pre-focused 10.3* mm or

10.3 mm IR** M12 lens with wrench

DM300-LENS-10LL

DM300-LENS-10LL-IR

24 mm F6 liquid lens module* DM360-LENS-24LL

24 mm F6 liquid lens module*** DMLN-C24F06-LL-IR

24 mm F10 liquid lens module* DMLN-C24F10-LL

Accessory DM474 DM475

10 mm F5 autofocus lens* (use with HPIT) DMLN-C10F05-HSLL

10 mm F5 manual focus lens* DMLN-C10F05-MF

16 mm F8 autofocus lens* (use with HPIT) DMLN-C16F08-HSLL

16 mm F8 manual focus lens* DMLN-C16F08-MF

24 mm F6 autofocus lens* (use with HPIT) DMLN-C24F06-HSLL

24 mm F6 manual focus lens* DMLN-C24F06-MF

* With built-in IR blocking filter

** Without built-in IR blocking filter

*** Without built-in IR blocking filter, and with built-in daylight filter

LENSCOVERSANDINTEGRATEDILLUMINATIONS

Accessory DM474 DM475

C-Mount cover for C-Mount lenses DM300-CMCOV

Short C-Mount cover for C-Mount lenses DM300-CMCOV-SH

Extension kit DM300-EXT

DM500 C-Mount cover (use with HPIA) DM500-CMTLC-000

DM500 Lens cover extender DM500-LNSEXT-000

Accessory DM474 DM475

Red LED HPIL, 10.3 mm lens

(RiskGroup Red LED Exempt acc. IEC 62471, RiskGroup

Green LED AimerExempt acc. IEC 62471)

DM360-HPIL-RE

Polarized red LED HPIL, ESD safe, 10.3 mm lens

(RiskGroup Red LED Exempt acc. IEC 62471, RiskGroup

Green LED AimerExempt acc. IEC 62471)

DM360-HPIL-RE-P

White LED HPIL, 10.3 mm lens

(RiskGroup White LED low riskacc. IEC 62471, RiskGroup

Green LED AimerExempt acc. IEC 62471)

DM360-HPIL-WHI

Red LED HPIL, 24 mm liquid lens

(RiskGroup Red LED Exempt acc. IEC 62471, RiskGroup

Green LED AimerExempt acc. IEC 62471)

DMLT-HPIL-RE

Polarized red LED HPIL, ESD safe, 24 mm liquid

lens

(RiskGroup White LED low riskacc. IEC 62471, RiskGroup

Green LED AimerExempt acc. IEC 62471)

DMLT-HPIL-RE-P

White LED HPIL, 24 mm liquid lens

(RiskGroup White LED low riskacc. IEC 62471, RiskGroup

Green LED AimerExempt acc. IEC 62471)

DMLT-HPIL-WHI

Red LED HPIL, ESDsafe, 10.3 & 24 mm liquid

lens

(RiskGroup Red LED Exempt acc. IEC 62471, RiskGroup

Green LED AimerExempt acc. IEC 62471)

DMLT-HPIL-IR-W

EXTERNAL LIGHTS ANDHIGHPOWERILLUMINATIONS

Accessory DM474 DM475

Ring Light CLRR-R7030G1CLR

Back light CLRB-F100100G1

Coaxial (DOAL) light CLRO-K5050G1

Spot light CLRS-P14G1

Accessory DM474 DM475

Dark-field light CLRD-D120G1

Brick light, narrow blue IVSL-ODDM-S75-470

Brick light, narrow red IVSL-ODDM-S75-625

Brick light, narrow white IVSL-ODDM-S75-WHI

Bar light, wide red IVSL-YLW2X-625

Bar light, narrow red, linear polarizer IVSL-YLW2X-625P

Bar light, narrow infrared IVSL-YLW2X-850

Bar light, narrow blue IVSL-YLW2X-470

Bar light, wide red IVSL-YLW2X-625-W

Bar light, narrow white IVSL-YLW2X-WHI

Bar light, wide white IVSL-YLW2X-WHI-W

Bar light, wide white, linear polarizer IVSL-YLW2X-WHIP-W

Bar light, blue IVSL-LX520-470

Bar light, red IVSL-LX520-625

LX280-series light, blue IVSL-LX280-470

LX280-series light, red IVSL-LX280-625

Linear Polarizer Kit Case DM30X-HPIA3-LP

Accessory DM474 DM475

HPIA, Red narrow DM30X-HPIA3-625

HPIA, Red wide DM30X-HPIA3-625-W

HPIA, White narrow

(RiskGroup White LED low riskacc. IEC 62471)

DM30X-HPIA3-WHI

HPIA,White wide

(RiskGroup White LED low riskacc. IEC 62471)

DM30X-HPIA3-WHI-W

HPIA, Blue narrow

(RiskGroup White LED low riskacc. IEC 62471)

DM30X-HPIA3-470

HPIA, Blue wide

(RiskGroup White LED low riskacc. IEC 62471)

DM30X-HPIA3-470-W

HPIA, Infrared narrow

(RiskGroup White LED low riskacc. IEC 62471)

DM30X-HPIA3-IR

HPIA, Infrared wide

(RiskGroup White LED low riskacc. IEC 62471)

DM30X-HPIA3-IR-W

HPIT, Red, wide, 10 and 16 mm lens

(RiskGroup Red LED exempt riskacc. IEC 62471)

DMLT-HPIT-RE-W

HPIT, Red, standard, 24 mm lens

(RiskGroup Red LED exempt riskacc. IEC 62471)

DMLT-HPIT-RE-S

HPIT, White, wide, 10 and 16 mm lens

(RiskGroup White LED low riskacc. IEC 62471)

DMLT-HPIT-WHI-W

HPIT, White, standard, 24 mm lens

(RiskGroup White LED low riskacc. IEC 62471)

DMLT-HPIT-WHI-S

Polarized front cover DMLA-HPIT-PLCOV

Clear front cover DMLA-HPIT-CLCOV

Diffuse front cover DMLA-HPIT-DLCOV

Adapter (includes PCB light port adapter) DMLA-HPIT-ADAP470

FIELDOFVIEWEXPANDERS

Accessory DM474 DM475

Field of view expander with mount DMA-XPAND-100

Field of view expander DMA-XPAND-150

Field of view expander DMA-XPAND-250

Field of view expander DMA-XPAND-300

OTHER

Accessory DM474 DM475

Connection cable RS-232 CCB-M12xDB9Y-05

Connection cable 24V, I/O, RS-232 (y

straight/angled, xx specifies length)

CCB-M12x12Fy-xx

Connection cable 24V, I/O, RS-232 CCBL-05-01

Power and I/O breakout cable, M12-12,

straight, xx specifies length: 5m, 10m, 15m,

angled, xx specifies length: 5m, 10m, 15m

CCB-PWRIO-xx

CCB-PWRIO-xxR

Power cable for multiple bar lights (use in

combination with IVSL-5PM12-5)

CCB-FOV25-MAL-012

X-Coded to A-Coded Ethernet cable adapter,

0.5m

CCB-M12X8MS-XCAC

X-Coded to RJ45 Ethernet Cable (xx

specifies length: 2, 5, 15, 30m)

CCB-84901-2001-xx

Other manuals for DataMan 470 Series

This manual suits for next models

Table of contents

Cognex DataMan 470 Series User manual

Popular Barcode Reader manuals by other brands