XU-5 Open Frame Board Holder with X-Y micrometer
Bokar International www.bokar.com www.bomir.com Page 3
II. SAFETY
The purpose of this "SAFETY" section is to inform the users of the heading guidelines used in
this manual to indicate special Notes, Cautions, Warnings or Dangers. Also included are
precautions, which must be observed when operating or servicing this product.
These "NOTES", "CAUTIONS", "WARNINGS" and "DANGERS" are inserted in this manual
whenever deemed necessary. They appear in a blocked off form with outline and a shaded
background to highlight the information as shown below.
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
NOTE
Used to indicate a statement of company recommendation or policy. The message may relate
directly or indirectly to the safety of personnel or protection of property. NOTE is not associated
directly with a hazard or hazardous situation and is not used in place of "CAUTION",
"WARNING" or "DANGER".
CAUTION
Used to indicate a hazardous situation, which may result in minor or moderate injury. May also
be used to alert personnel to conditions, procedures and practices which, if not observed, could
result in damage to or destruction of the product or other equipment.
WARNING
Used to define additional information, that if not closely followed may result in serious damage
to equipment and represent a potential for serious personnel injury.
DANGER
Defines additional information, that if not closely followed may result in severe personnel injury
or death. Danger is not used for property damage unless personal injury risk is present.
PRECAUTIONS
The following are general safety precautions, which personnel must understand and follow
when using or servicing this product. These precautions may or may not be included elsewhere
in this manual.
CAUTIONS
1. Utilize all standard electrical safety precautions when using this or any other electrical
equipment.
2. Always use this system in a well-ventilated area. A fume extraction system (such as
those available from X-KAR) is highly recommended to protect personnel from solder flux
fumes.
3. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the
Material Safety Data Sheet (MSDS) supplied with each chemical and adhere to all safety
precautions recommended by the manufacturer.
DANGER
POTENTIAL SHOCK HAZARD – All repairs made on this product should be performed by a
qualified service personnel only. Line voltage parts will be exposed when equipment is
disassembled. Service personnel must avoid contact with these parts when troubleshooting.
NOTES
To insure continued peak performance, use genuine X-KAR replacement parts.
