Amana NED7200T User manual

Table of contents

Popular Dryer manuals by other brands

Bosch

Bosch WTA79200GB Installation and operating instructions

Miele

Miele TWH 780 WP operating instructions

Asko

Asko T760 user guide

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Original instructions

Bosch

Bosch Logixx 10 WTB76556GB Instruction manual and installation instructions

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Operation and installation

Electrolux

Electrolux EW2H328R2 user manual

Beko

Beko DS8433RX1M user manual

Dawlance

Dawlance Spinner DS 6000 C owner's manual

Electrolux

Electrolux TP5080TW user manual

AEG

AEG TR838P4OB user manual

Indesit

Indesit IDV 75 instruction manual

Infiniton

Infiniton SD-DG85C manual

BOMANN

BOMANN WT 5019 instruction manual

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Installation

Asko

Asko T793C operating instructions

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer installation instructions

Frigidaire

Frigidaire CAQE7077KW0 use & care

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

RECESSED AREA AND CLOSET INSTALLATION

EXHAUST VENTING

NED7200T

Electrical: A four-wire or three-wire, single phase,

120/240-volt, 60 Hz, AC-only, electrical supply (or

120/208-volt electrical supply, if specified on the

serial/rating plate) is required on a separate 30-amp

circuit, fused on both sides of the line.

Exhaust venting: Exhaust your dryer to the

outside. 4" (10.2 cm) diameter vent is required.

Heavy metal exhaust vent must be used. Do not use

plastic or metal foil vent. Exhaust outlet hood must

be at least 12" (30.5 cm) from the ground or any

object that may be in the path of the exhaust.

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Ref. W10161760

09-05-08

Electric Dryer

A. Overall height: 38" (96.5 cm)

B. Width: 27" (68.6 cm)

C. Depth with door open 90°: 46-7/16" (123.0 cm)

D. Depth: 28" (71.0 cm)

E. Bottom vent location from back to center of hole: 7-1/2" (19 cm)

Side vent hole from back to center of hole: 8-1/2" (21.6 cm)

Select the route that will provide the straightest

and most direct path outdoors. Plan the

installation to use the fewest number of elbows

and turns. Avoid making 90° turns.

Do not use vent runs longer than specified in vent

length chart.

Determine the number of elbows you will need.

NOTE: Side and bottom exhaust installations

have a 90° turn inside the dryer. To determine

maximum exhaust length, add one 90° turn to the

chart.

®

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:

2" (5.1 cm) front, 0" (0 cm) top, 0" (0 cm) either side and 2-3/8" (6.0 cm) rear.

• Closet front must have two unobstructed air openings combined total area 72"2 (464.5 cm2),

located 3" (7.6 cm) minimum from trop and bottom.

Louvered door with equivalent air opening is acceptable.

• An appliance installed in a closet shall have no other fuel-burning appliance installed in the

same closet.

33' (10.1 m)

29' (8.8 m)

25' (7.6 m)

21' (6.5 m)

80' (24.4 m)

68' (20.7 m)

57' (17.4 m)

47' (14.3m)

0

1

2

3

74' (22.6 m)

62' (18.9 m)

51' (15.5 m)

41' (12.5 m)

41' (12.4 m)

37 ' (11.2 m)

33' (10.1 m)

29' (9.0 m)

ELECTRIC AND GAS DRYER

Weather Hood Type

Recommended

Metallic Flexible* Metallic Flexible*

Rigid

Rigid

* Do not use non metallic flexible duct.

No. of 90°

elbows

4" (10.2 cm)

Use only for short run installation

2-1/2" (6.4 cm)

NOTE: The height of the dryer from top to floor is 38" (96.5 cm) with the leveling leg screwed

all the way in. The customer can unscrew the leg out an additional 7/8" (2.2 cm) for a total

overall height of 38-7/8" (98.7 cm).