Changing IR Settings
If you want to change the IR settings, please remove the rear cover.
There are two Resistors with phillips head knobs, refer to the picture below.
Resistor A: Controls the intensity of the IR LEDs
Turning (Clockwise) will increase intensity
Turning (Counter-Clockwise) will decrease intensity
Resistor B: Controls the lux threshold needed for triggering the IR LEDs
Turning (Clockwise) will increase lux threshold
Turning (Counter-Clockwise) will decrease lux threshold
Lens Adjustment:
Refer to the diagram below for optimum viewing angle.
①Use the hex shape Wrench to loosen the two screws on the left side
of camera housing, then you can open the sun shield.
②Remove the foam covering the box camera, and move forward the
box camera into the hole of IR board.
③Adjust the lens till the image is perfect, and then tighten the two
screws on the plastic plate.
④Re-screw the sun-shield.
