Smeg LF66105SS User manual

Free Standing Gas Cooker

Installation and Operating Instructions

LF96105SS

LF66105SS

To avoid the risk of accidents or damage to the Gas Cooker,

it is essential to read these operating instructions

before it is installed or used for the first time.

And please keep this manual for later reference.

P/No.: MFL62060304

http://au.lge.com (Australia)

http://nz.lge.com (New Zealand)

Contents

Introduction ................................................................................. 3

1. Instructions for safe and proper use.......................................3

Instructions for the installer ...................................................... 6

2. Installation of the appliance....................................................6

3. Adaptation to different types of gas ......................................11

4. Final operations....................................................................14

Instructions for the user .......................................................... 17

5. Description of controls..........................................................17

6. Use of the hob ......................................................................19

7. Use of the oven ....................................................................22

8. Electronic programmer (Only on equipped models).............26

9. Available accessories ...........................................................29

10. Cleaning and maintenance.................................................30

11. Extraordinary maintenance.................................................33

These instructions are valid only for the end user countries

whose identification symbols appear on the cover of this

manual.

INSTRUCTIONS FOR THE INSTALLER: these are for the

authorised person who must carry out a suitable check of the gas

system, install the appliance, set it functioning and carry out an

inspection test.

INSTRUCTIONS FOR THE USER: these contain user advice,

description of the commands and the correct procedures for

cleaning and maintenance of the appliance.

1. Instructions for safe and proper use

This manual is an integral part of the appliance and therefore must

be kept in its entirety and in an accessible place for the whole

working life of the cooker. We advise reading this manual and all

the instructions therein before using the cooker. Also keep the

series of nozzles supplied. Installation must be carried out by

qualified personnel in accordance with the regulations in force. This

appliance is intended for domestic uses and conforms to current

regulations in force. The appliance has been built to carry out the

following functions: Cooking and heating-up of food. All other

uses are considered improper.

The manufacturer declines all responsibility for improper use.

Do not leave the packing in the home environment. Separate the

various waste materials and take them to the nearest special

garbage collection centre.

It is compulsory that the appliance be grounded according to the

methods required by safety rules.

The plug to be connected to the power cable and the socket must

be the same type and must conform to current regulations.

The socket must be accessible after the appliance has been built in.

Never unplug by pulling out the cable.

Immediately after installation carry out a brief inspection test of

the appliance, following the instructions below. Should the

appliance not function, disconnect it from the supply and call the

nearest technical assistance centre.

Never attempt to repair the appliance.

DO NOT USE OR STORE FLAMMABLE MATERIALS IN THE

APPLIANCE STORAGE DRAWER OR NEAR THIS

APPLIANCE. 3

Introduction

DO NOT MODIFY THIS APPLIANCE

When not in use, make sure that the control knobs are in the

correct (OFF) position ●●.

Never put inflammable objects in the oven: They could be

accidentally catch fire and burn.

The I.D plate with technical date, serial number and brand name is

positioned visibly in the storage compartment.

The plate must not be removed.

Do not put pans without perfectly smooth and flat bottoms on the

hob grids.

During use the appliance becomes very hot. Take care not to

touch the heating elements inside the oven.

Do not use containers or broilers that extend beyond the outer

perimeter of the hob.

The appliance is designed for use by adults. Do not allow

children to go near or play with it.

When operating the grill all accessible parts could become very hot:

keep out of the way of children.

If the appliance is to be positioned on a platform it must be installed

in such a way as to prevent it from tilting off it.

This appliance is designed for cooking food and it shall not be used

as a space heater.

Do not spray aerosols in the vicinity of this appliance while it is in

operation.

Where this appliance is installed in marine craft or in caravans, it

shall not be used as a space heater.

Do not apply decorative panels to the lower part of the cooker as

they may prevent correct air circulation and cause overheating.

Before the appliance is put into operation, all the labels and

protective films applied inside or outside must be removed.

The manufacturer declines all responsibility for damage to

persons or things caused by non-observance of the above

prescriptions or by interference with any part of the appliance or

by the use of non-original spares.

Instructions for the installer

2. Installation of the appliance

It is the law that all gas appliances are installed by authorised

persons. Clearance around the cooker must comply with the

requirements of AS5601.

The manufacturer declines all responsibility for damage to

persons or things caused by non-observance of the above

prescriptions or by interference with any part of the appliance.

Overall dimensions: location of gas and electrical connection

points (all measures in mm).

A 60

B410

C60

D70

A 60

B410

C100

D150

2.1 Electrical connection

Make sure that the power line voltage matches the specifications

indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

If the appliance is connected to the supply by means of a fixed

connection, install a multipolar cut-out device on the line, with

contact opening distance equal to or greater than 3 mm, located

near the appliance and in an easily reachable position.

Connection to the supply may be fixed or with plug and socket. In

the latter case the plug and socket must be suitable for the cable

employed and conform with the regulations in force.

Regardless of the type of connection, earthing of the appliance is

absolutely obligatory. Before connection make sure that the supply

line is suitably earthed. Avoid the use of reducers, adapters or shunts.

1. For operation on 220-240V~: use a

three-pole H05RR-F or H05V2V2-F cable

having a cross section of 3 x 2.5 mm2

(90 cm wide models) or 3 x 1.5 mm2

(60 cm wide models).

The cable end to be connected to the appliance must be provided

with ground wire (yellow-green) at least 20 mm longer.

Instructions for the installer

2.2 Gas connection

Use pipe-joint compound made for use with Natural and U.L.P. gas.

This appliance is suitable for installation with Natural

Gas or ULPG (propane). Refer to page 12 for the

relevant burner pressure and appropriate injector

sizes. When the appliance is to be connected to

Natural Gas then the pressure regulator supplied must

be fitted to the gas inlet. A test point (for checking the

gas pressure) is supplied either with the regulator or

as a separate fitting in the case of ULPG (propane) appliances.

Connection of the appliance to the gas supply must be in

accordance with the requirements of AS5601. A 1/2” BSP connector

at the inlet is recommended and the gas supply line to the

appliance must be of adequate length to allow sufficient withdrawal

of appliance for service or disconnection and be:

1. annealed copper pipe or;

2. flexible hose according to AS/NZ1869 & be at least Class

“B”, 10 mm diameter.

The cooker must be installed with provision to allow the gas to be

turned off and disconnected for servicing and removal of the

appliance as required from the gas supply. Before the cooker is

operated make certain all relevant parts are placed in the correct

position.

When the installation is completed the installation connections of

cooker will require to be leak tested, the burner operating pressure

and flame checked and adjusted.

Warranty service calls do not cover these adjustments!

To check the operating pressure of the appliance it is recommended

at least 2 large size burners are used. Ensure appliance is secured

to wall when installation is completed.

N.G. The regulator supplied must be fitted to the 1/2” BSP thread at

the rear of the appliance. An approved manual shut-off valve must

be installed. The N.G. regulator must be checked and adjusted to

1.0kPa after installation.

U.L.P.G: Can be connected to the inlet fitting directly.

The pressure must be checked to ensure it is operating

at 2.75kPa. A separate test point fitting must be installed

between the piping & the appliance for the pressure to

be checked to ensure it is operating at 2.75kPa.

Make the connection to the gas mains using a continuous

wall flexible steel pipe whose specifications comply with

the current regulations. Carefully screw the connector 3 to the gas

connector 1 of the appliance, placing the seal 2 between them.

Apply a suitable sealing substance to the thread of the connector 3

and then tighten the flexible steel pipe 4 to the connector 3.

2.3 Combustion gas discharge

Combustion gases may be discharged by means of hoods

connected to a natural draught chimney or a fan extraction system.

An efficient extraction system requires precise planning by an

authorised specialist and must comply with the distances and

positions indicated by the regulations. After installation, the

specialist must issue a certificate of compliance.

2.4 Room ventilation

Caution – This cooker may only be installed and operated in rooms

permanently ventilated in accordance with current regulations. For

proper operation of a gas appliance it is essential for the air

necessary for combustion of the gas to be able to flow naturally into

the room. Air must flow directly into the room through openings in

its outside walls. This (these) opening (s) must have a free passage

cross-section of at least 100 cm2, or 200 cm2for appliances not

equipped with gas safety device. These openings must be

constructed so that they cannot be obstructed indoors or outdoors,

and should preferably be close to the floor on the side opposite to

the combustion gas discharge point. If it is not possible to make the

openings in the room where the cooker is installed, the necessary

air may be taken from an adjoining room, provided it is not a

bedroom or a room with fire risk.

Instructions for the installer

2.5 Clearance above and around domestic cookers

Extract from AS5601

REQUIREMENTS

1. Overhead clearances – (Measurement A)

Range hoods and exhaust fans shall be installed in accordance

with the manufacturer’s instructions. However, in no case shall

the clearance between the highest part of the hob of the cooking

appliance and a range hood be less than 600 mm or, for an

overhead exhaust fan, 750 mm.

Any other downward facing combustible surface less than 600

mm above the highest part of the hob shall be protected for the

full width and depth of the cooking surface area in accordance

with Clause 5.12.1.2. However, in no case shall this clearance to

any surface be less than 450 mm.

2. Side clearances – (Measurements B & C)

Where B, measured from the periphery of the nearest burner to

any vertical combustible surface, is less than 200 mm, the

surface shall be protected in accordance with Clause 5.12.1.2 to

This manual suits for next models

Table of contents

Popular Cooker manuals by other brands

Modena

Modena FC 7645 SGM User manual book

Electrolux

Electrolux Insight EKG6049 user manual

Stanley

Stanley Donard 60 Installation and operating instructions

Bartscher

Bartscher 201TC manual

Parkinson Cowan

Parkinson Cowan 50 GR/BU installation instructions

Siemens

Siemens HK9P00020U instruction manual

Creda

Creda S150E Installation and user instructions

Creda

Creda HB48309 instructions

Bosch

Bosch HCE743220F instruction manual

Tricity Bendix

Tricity Bendix SE545P manual

NEFF

NEFF E1461A2/01 Instructions for use

Zanussi

Zanussi ZCM 700 X Instruction booklet

RiverGrille

RiverGrille TF2002501-RG Assembly instruction

Vollrath

Vollrath 69504F Operator's manual

Tricity Bendix

Tricity Bendix CSIE500 Operating and installation instructions

AEG

AEG Competence 5731 V Instruction book

Euromaid

Euromaid ES60 Installation and operation manual

Hotpoint

Hotpoint HUI 62 TP Instructions for installation and use