Securitytronix ST-D600VP3.6-B-W User manual

v1.0 12/20/11

INSTALLATION MANUAL

ST-D600VP3.6-B-W

Vandalproof Dome Color Camera

v1.0 12/20/11

PACKAGE CONTENTS

This package contains:

One ST-D600VP3.6 vandalproof color camera

Mounting hardware

One installation manual

Note: The ST-D600VP3.6 requires a minimum12VDC 150mA power supply such as the

ST-PS12VDC1A or ST-PS12VDC2A.

PRODUCT DESCRIPTION

The ST-D600VP3.6 is a vandalproof dome color camera designed around a 1/3” Pixel Plus Color

CMOS sensor with 600TVL of resolution. The camera’s 3.6mm lens provides an optimal field of

view. The ST-D600VP3.6 size and packaging allow it to be easily and discretely installed. Its rich

color, high definition and stability make it attractive for CCTV security applications.

SPECIFICATIONS

ST-D600VP3.6

Specifications (Typical)

1. Image Sensor

1/3” Pixel Plus Color CMOS Sensor

2. Pixels (HxV)

728 x 488

3. Scanning System

NTSC

4. Horizontal Resolution

600TV Lines

5. Synchronization

Internal, Negative Sync

6. Minimum Illumination

0.1Lux

7. Scanning System

2 :1 interlace

8. Auto Electronic Shutter

1/60s ~ 1/100,000s

9. Gain Control

Automatic

10. Lens

3.6mm F2.0 Board Lens

11. S/N Ratio

>48dB

12. Video Output

1.0Vp-p/75

13. Operation Temperature, Relative Humidity

14F - 113F, 95% maximum

14. Power Requirements

DC12V 150mA

15. Dimensions

3.7”x2.7”

16. Weight

12.3 oz

17. Environmental rating

IP65

v1.0 12/20/11

INSTALLATION AND OPERATION

CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this

unit. No user serviceable parts are inside.

CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than

specified power source.

1. UNPACKING and HANDLING

Each unit is shipped assembled and factory tested.

Ensure that all accessories are removed from the container before discarding packing material

2. MECHANICAL INSPECTION

Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is

clean, and no connectors are broken, damaged, or loose. If equipment appears to be damaged

or defective please contact your distributor or Securitytronix at 1-610-429-1511 for assistance.

3. SPECIAL ATTENTION

a. The installer must comply with electrical safety standards. There must be sufficient

space between the camera’s power supply and video line and any high voltage

equipment and/or cables.

b. To help ensure the camera’s life and proper operation do not point the camera towards

the sun or strong light.

c. Do not install the camera in an environment where the temperature is above 113F.

d. Do not install the camera near a magnetic field or a high-power motor.

e. Do not mount the camera near a radiator or heater.

f. Only use a dry cloth to clean the camera. If there is dirt that is difficult to remove wipe

gently with a mild detergent. Never use strong or abrasive detergents.

g. A minimum 12VDC 150mA power supply must be used. AC power cannot be applied.

Using an AC or other incorrect power supply will damage the camera.

h. Only qualified installers are allowed to install, test and disassemble the camera.

i. The camera is a low voltage product. If installed outdoors proper safety and lightening

grounding are required.

This symbol is intended to alert the user to the presence of important operating and

maintenance (servicing) instructions.

This symbol is intended to alert the user to the presence of un-insulated “dangerous

voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a

risk of electrical shock.

v1.0 12/20/11

4. WIRING CONNECTIONS

a. Connect the power supply’s DC plug to the camera’s power port.

b. Connect the camera to the monitor with a 75coaxial video cable.

c. Connect power supply’s AC plug to a suitable AC power outlet.

d. Adjust the lens direction according to the required surveillance area and environment.

5. TROUBLESHOOTING

a. No picture after applying power –(i) check all plugs and cables are securely connected

to the proper connectors; (ii) ensure your power supply is providing the correct voltage

and current.

b. The picture has ripples –(i) check to see if the power supply is experiencing AC ripple,

if so a filter may be required; (ii) determine if the monitor is faulty; (iii) determine if other

peripheral equipment is causing ripple and if so make the necessary adjustments.

c. The picture background continuously changes color –a fluorescent lamp’s magnetic

field may cause color roll, therefore, reduce the number of fluorescent lamps or

increase the distance between the camera and the lamps.

d. The picture appears smeared –(i) the power supply voltage level may be unstable,

therefore, try another power supply; (ii) ensure the cables are correctly connected

and/or the cables are of the correct impedance.

e. Other interference may require a Securitytronix ground loop isolation filter.

f. Additional troubleshooting assistance can be found on-line at www.securitytronix.com

in addition to support from Securitytronix sales engineers at 1-610-429-1511.

Table of contents

Other Securitytronix Security Camera manuals

Securitytronix

Securitytronix ST-DWD600IRVP2812-B User manual

Securitytronix

Securitytronix ST-HDC2FB User manual

Securitytronix

Securitytronix ST-HD-BT3.6-1MP User manual

Securitytronix

Securitytronix ST-BTLI540IRVFDV User manual

Securitytronix

Securitytronix ST-D600DN2812 User manual

Securitytronix

Securitytronix ST-D540IRVP49-S User manual

Securitytronix

Securitytronix ST-DWD650IRVP2812-B/W User manual

Securitytronix

Securitytronix ST-DWDVF2812-720B/W User manual

Securitytronix

Securitytronix ST-WD600PTZMINI-IR User manual

Securitytronix

Securitytronix ST-DWD700-3.6-B User manual

Securitytronix

Securitytronix ST-DWD650IR-B User manual

Securitytronix

Securitytronix ST-BT540IR20-B User manual

Securitytronix

Securitytronix ST-D600IR2812 User manual

Securitytronix

Securitytronix ST-IP4VFD-MZL User manual

Securitytronix

Securitytronix ST-BT540IR30 User manual

Securitytronix

Securitytronix ST-DLI420IR6-B User manual

Securitytronix

Securitytronix TVI-AC344-MB User manual

Securitytronix

Securitytronix ST-HD-BT2812M-2MP User manual

Securitytronix

Securitytronix ST-IP-BT3.6-1 User manual

Securitytronix

Securitytronix ST-IP2FTD User manual

Securitytronix

Securitytronix ST-BT1000IR2812-G User manual

Securitytronix

Securitytronix ST-PTZMINI-540W User manual

Securitytronix

Securitytronix ST-D420IR6-B User manual

Securitytronix

Securitytronix HD-CoaxinatorTVI ST-HDC2VFB-MZ User manual

Popular Security Camera manuals by other brands

Okina USA

Okina USA SIR36-870VF650LP user manual

Divio

Divio NDR155PA user manual

Canon

Canon VB-C500D Specifications

Easy Access

Easy Access EasyGuard user manual

Vivotek

Vivotek FD9389-EHV-v2 Quick installation guide

TUYA

TUYA COSMO W2 manual

Eusso

Eusso UNC7500-IR Advanced installation guide

urmet domus

urmet domus 1096/204 user manual

VC VC20 series operating manual

Axis

Axis Q1614 installation guide

ieGeek

ieGeek DD201 manual

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Installation and user guide

Vicon

Vicon V662-D-1 Installation and operation guide

Grundig

Grundig GCH-K0274P owner's manual

Lorex

Lorex VANTAGE LBC7032 quick start guide

4xem

4xem WPT Specifications

Samsung

Samsung SCV-3082 Specifications

Vitek

Vitek VTC-C544 Specifications