Samsung MWR-WE10N User manual

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGGY[ YWXZTWYTWXGGG㝘䟸G]aZ[aXY

Wired remote controller

MWR-WE10N

Air Conditioner

installation manual

imagine the possibilities

Thank you for purchasing this Samsung product.

This manual is made with 100% recycled paper.

EN PT

ES DE

FR EL

DB68-03716A(1)

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGGY\ YWXZTWYTWXGGG㝘䟸G]aZ[aXZ

Safety Information

WARNING

Contact a service center for installation.

XPotential risk of malfunction, water leak, electric shock and re.

Install the product with proper power supply.

XPotential risk of re or product damage.

Consult the place of purchase or a contact center to disassemble or repair the product.

XPotential risk of malfunction, electric shock, or re.

The electric work must be done by qualied person according to national wiring regulations and installation guide.

XIf an unauthorized person performs the installation, any resulting defects can cause malfunctions,

electrical shocks, or re accidents.

Install the product on a hard and even place that can support its weight.

XIf the place cannot support its weight, the product may fall down and it may cause product damage.

Do not move or reinstall the product on your discretion.

XPotential risk of electric shock or re.

Check if the installation work is done correctly according to the installation manual.

XIncorrect installation may cause electric shock or re.

When you want to dispose your Wired Remote Controller, ask the service center.

This installation manual explains how to install a Wired Remote Controller connected to the indoor unit of

your Trane system air conditioner.

Please read this manual thoroughly before installing the product.

(Please refer to appropriate installation for any optional product installation.)

WARNING Hazards or unsafe practices that may result in severe personal injury or death.

CAUTION

Hazards or unsafe practices that may result in minor personal injury or property damage.

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGGY YWXZTWYTWXGGG㝘䟸G]aZ[aW\

ENGLISH

CAUTION

Do not install the product where there’s combustible gas.

XPotential risk of re and explosion.

Ensure no water gets into the Wired Remote Controller.

XPotential risk of electric shock or re.

Install the air conditioner away from direct exposure to sunlight, in room temperature range of 0°C(32°F)~39°C(102°F).

XPotential risk of electric shock or malfunction.

Do not handle the product with sharp objects.

XPotential risk of electric shock or product damage.

Do not install the product in areas exposed to oil or vapor.

XPotential risk of product damage or malfunction.

Do not put undue stress on the power cable.

XPotential risk of broken cable and re.

Do not install the product in areas with frequent use of acid or alkali spray.

XPotential risk of electric shock or product malfunction

Do not connect power cable to a communication terminal.

XPotential risk of re.

Be cautious not to interfere any other electrical devices if the product is installed in a place such as hospital.

XPotential risk of product malfunction.

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGGZ YWXZTWYTWXGGG㝘䟸G]aZ[aW]

Wired Remote Controller Installation

Optional accessories

External Dimensions

• The Wired Remote Controller should be installed by an installation expert.

• Check and conrm the power is o before installing your Wired Remote Controller.

• Install the Wired Remote Controller cables in accordance with the electrical wiring rules, and allow it to pass

through the inner area of the wall so that other people can’t reach it.

120.0(4.72)

124.0(4.88)

63.8(2.51)

19.5(0.76)

[Unit : mm(inch)]

Wired Remote

Controller (1) Cable Tie (2) Cable Clamp(3) M4X16Screw (5) User Manual (1) Installation

Manual (1) U Terminal (4)

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGG[ YWXZTWYTWXGGG㝘䟸G]aZ[aW]

ENGLISH

Wired Remote Controller Installation

KPush the two hooks at the same time.

1. Push the two hooks at the bottom of your Wired Remote Controller at the same time, and then pull up the

front cover to separate it from the rear cover.

2. Arrange the power cable and the communication cable so that they t in the housing along the edges of the

rear cover.

• Insert a at head screwdriver into the square groove in the upper area of the

hook to disassemble it easily.

15cm(6inch)

10cm(4inch)

If you need more space for the

wiring work, you can take it off.

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGG\ YWXZTWYTWXGGG㝘䟸G]aZ[aW]

Wired Remote Controller Installation

4. Reassemble your Wired Remote Controller.

Wired Remote Controller Installation

• Align the controller with the upper groove rst, and insert it by turning it downward as

shown in the gure.

After assembly, check and conrm that no wires are stuck in the gap between the rear and

front cover.

•

When installing a Wired Remote Controller by using a cable longer than 10m(32.80 ft), you must install the

communication cable and the power cable separately. (Electrical interference can cause your Wired Remote Controller

to malfunction.)

• When installing your Wired Remote Controller on the wall, consider the size of the wire hole, and select a wire with

a proper thickness.

• Wire that is connectable to Wired Remote Controller PCB.

- If you install the Wired Remote Controller by reclaiming, install it according to U-terminal cable specication.

- If you install the Wired Remote Controller by using two pieces of PVC wire, remove the 30cm(12inch) of the

sheath of the cable and install it only with the two pieces of wires. (Recommended specication: AWG21)

• The following are the specs of the compression ring terminal connected to your Wired Remote Controller PCB.

Stud D

Range of Permitted Wires Rated

Size

Stud

Size Basic Size

[mm (inch)]

AWG mm

(inch

)

(inch

)

(inch) tøDG E F WL

22~16

0.25~1.65

(0.0003 ~

0.0025)

1.5

(0.0023)

(0.1181)

0.7

(0.0275)

3.8

(0.1496)

10.0

(0.3937)

4.5

(0.1771)

6.5

(0.2559)

6.0

(0.2362)

21.2

(0.8346)

KMaximum distance for connecting communication and

power cable: 100 m(3.280 ft)

•

Screws on the PCB terminal must be tightened with less than 6N-cm tightening torque. If the tightening torque is

greater, it may damage the screw thread.

3. Using more than two screws, rmly ax the rear cover of the remote controller to the wall, and then connect

the communication & power cable[(F3,F4) or (3, 4)], making sure these cables have reasonable length,

to the terminal at the back of the cover.

10mm(0.4inch) or more

10mm(0.4inch)

or more

50mm(2inch) or more

10mm(0.4inch) or more

Screw hole

Rear cover

Front cover

PCB terminal

Wire (not supplied)

KBefore fixing the rear cover, secure at least

10mm(0.4inch) space of upper side, left side,

right side, and 50mm(2inch) space

of bottom side.

KYou must fit the screws into

the screw holes.

Indoor unit

Wired Remote

Controller

KDo not tighten the screws on the

PCB terminal with excessive force.

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGG] YWXZTWYTWXGGG㝘䟸G]aZ[aW^

ENGLISH

Tracking Your Indoor Unit from the Wired Remote Controller

1. Tracking of your Wired Remote Controller will automatically start when you turn on the power after installation.

2. If you want to perform tracking again after installation, then press the Esc and Delete buttons at the same time

for more than ve seconds.

X

The system will reset, and tracking will start again.

3. During tracking, the total number of currently searched indoor units and ventilator(ERV) will be displayed.

4. It may take about 5 minutes at initial installation or when you re-set the Master setting.

• If you want to perform tracking again after installation, then press the Esc and Delete buttons at the same time

for more than ve seconds.

Displays the total number

of units searched

Indicates tracking

in progress

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGG^ YWXZTWYTWXGGG㝘䟸G]aZ[aW^

COM2(F3, F4) COM2(F3, F4) COM2(F3, F4)

COM1(F1, F2) COM1(F1, F2)

Ventilator(ERV) Ventilator(ERV) Ventilator(ERV)

Wired Remote

Controller

Wired Remote

Controller

Wired Remote

Controller

Master ventilator(ERV)

Individual Control with Your Wired Remote Controller

X

Individual control means that you are using one remote controller to control one indoor unit or ventilator(ERV).

Wired Remote Controller Installation

When Connected to an Indoor Unit Only

When Connected to an ventilator(ERV) Only

Outdoor Unit

Indoor Unit

COM1(F1,F2)

COM2(F3,F4)

COM1(F1,F2)

COM2(F3, F 4) COM2(F3,F4)

Wired Remote

Controller

Wired Remote

Controller

Wired Remote

Controller

Indoor Unit Indoor Unit

• Regardless of the indoor group address (RMC address) or the ventilator(ERV) group address, only the indoor unit

connected to COM2is individually controlled.

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGG_ YWXZTWYTWXGGG㝘䟸G]aZ[aW_

ENGLISH

Outdoor Unit

Indoor Unit

Wired Remote

Controller

Outdoor Unit

Indoor Unit

COM1(F1, F2)

COM2(F3, F4)

COM1(F1, F2)

COM2(F3, F4)

Outdoor Unit

COM1(F1, F2) COM1(F1, F2)

Wired Remote

Controller

COM2(F3, F4) COM2(F3, F4)

COM1(F1, F2)

Indoor Unit Indoor Unit Indoor Unit

Group Control with Your Wired Remote Controller

X

Group control means that you are using one Wired Remote Controller to control two or more indoor units and

ventilator(ERV) at the same time.

When Connected to an Indoor Unit Only

• Regardless of the indoor unit’s group address (RMC address), only the indoor units connected to COM2are

controlled in group.

• Regardless of your outdoor units, you can control a maximum of 16indoor units as a group.

(1) Using One Wired Remote Controller to control three indoor Units

(2) Using One Wired Remote Controller to control indoor units connected to dierent outdoor unit

uhzh~GyGjt~yT~lXWuluptWZ^X]hOXPUGGG` YWXZTWYTWXGGG㝘䟸G]aZ[aW_

Other manuals for MWR-WE10N

Table of contents

Other Samsung Air Conditioner manuals

Samsung

Samsung AW07F0(1)(3)NAA/AB/BA/BB/BC/CA/DA/DB/EA/EB/EC Setup guide

Samsung

Samsung mini DVM Series User manual

Samsung

Samsung FH18BTA(X) User manual

Samsung

Samsung AQ NS Series User manual

Samsung

Samsung AC035MNADKH/EU User manual

Samsung

Samsung APH-2807ERX User manual

Samsung

Samsung DH105CAV User manual

Samsung

Samsung AEX160EDEHA User manual

Samsung

Samsung AQV18VBAAQV24VBAAQV18VBC User manual

Samsung

Samsung APV48Q0AN User manual

Samsung

Samsung AW0503B User manual

Samsung

Samsung HT-Z410 User manual

Samsung

Samsung Am NN1 Series User manual

Samsung

Samsung SH07APG User manual

Samsung

Samsung AM FNLD Series User manual

Samsung

Samsung AQ07ACVE User manual

Samsung

Samsung AWT18WBHDE User manual

Samsung

Samsung AS30C2BC User manual

Samsung

Samsung AR NXFH Series User manual

Samsung

Samsung ACH1800E User manual

Samsung

Samsung AC TN4PKC Series User manual

Samsung

Samsung AC036JB1DEC User manual

Samsung

Samsung MR-AH01 User manual

Samsung

Samsung DH094EAM User manual

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual

Webasto

Webasto Frigo Top 25 DS Instructions for use

Frigidaire

Frigidaire FAZ12ES2A installation instructions