
Replace a Quick-Release Recorder on an Amigo II Amigo II™
2000765_A © 2007, Rimage Corporation 2
ne cables are not being pinched. Pull the recorder out,
4. Connect
or
at www.rimage.com/support.html. Navigate:
Producer Family > Support – Amigo II > Documents Tab.
Install the Recorder
1. From the front of the system, connect the cables to the replacement recorder.
•Power cable
•FireWire cable
-Important! Make sure that you tighten the tie wrap to secure the FireWire cable.
2. Insert the recorder into the system until it clicks into place.
Caution! If you feel resistance, make sure that th
straighten the cables, and reinsert the recorder.3. Close the front door.
the power cord to the power outlet.
Tip: You should not need to align the new recorder unless you are experiencing disc picking problems. F
instructions, refer to the Align a Recorder document found
Support information
Europe When you contact Rimage Services, please provide:
ope:
ml tion of the problem.
•Exact error message received.
Contact Rimage Services Eur
www.rimage.com/support.ht
Tel: +49-(0) 6074-8521-0
•Unit serial number and software version.
•Functional and technical descrip
US, Asia/Pacific, Mexico/Latin America
ort_form.cfm
Asia/Pacific, Mexico/ Latin America: 952-946-0004
Contact Rimage Services:
www.rimage.com/support.html
Email: http://www.rimage.com/supp
Tel: North America: 800-553-8312
Rimage Corporation reserves the right to make improvements to the
equipment and software described in this document at any time without
any prior notice. Rimage Corporation reserves the right to revise this
publication and to make changes from time to time in the content hereof
without obligation of Rimage Corporation to notify any person or
organization of such revisions or changes.