Prorack Q19 User manual
Q19
Track System
EN Fitting Instructions for Basic Carrier
x 2 x 2 x 2 x 4
x 1 x 1 x 1 x 1
x 18 x 18 x 18
Revision No: 1A 1
Track System EN
Q19
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●Front end plug.
2
Track System EN
Q19
●Rear end plug.
●Assemble front and rear plugs to tracks.
Note: Rear plug shown in picture.
●NOTE: There is a left hand track and right
hand track. The end plugs should be fitted
accordingly.
3
Track System EN
Q19
●Carefully select position on vehicle roof
making sure that your crossbar lengths will
match selected positions for the tracks.
●Apply long lengths of masking tape to
vehicle roof in both positions.
●Repeat for all four positions.
●Make sure there is no interference between
what you intend to carry with aerials,
sunroof or tailgate.
●Tracks can be fitted either parallel or
tapered to match vehicle roof shape.
●Parallel Tracks:
A1 & A2 are equal
B1 & B2 are equal
C1 & C2 are equal
D1 & D2 are equal
●Tapered Tracks:
A1 & A2 are different
B1 & B2 are equal
C1 & С2 are equal
D1 & D2 are equal
●With help from another person, carefully lay
tracks over the masking tape and mark
hole positions with a pencil or pen.
●Take care not to move the tracks until the
holes are marked out.
4
Track System EN
Q19
●Use drill bit supplied, to drill holes in
marked positions.
●Remove masking tape and apply non-
acetic silicon sealant around drilled holes.
●Sit tracks on roof and line up tracks with
drilled holes.
●Insert all cap screws through the drilled
holes.
●With assistance, fit washer and nut loosely
onto each of the cap screws from inside the
canopy.
●Use a spanner to tighten the nuts onto the
cap screws to 3Nm (2.2 ft lb) using the
provided 3mm provided hex key.
5
Track System EN
Q19
●If the position of the roof racks need to be
adjusted along the tracks, use the 3mm
(1/8") hex key to hold the T-bolt stationary,
and using the 10mm (3/8") spanner
supplied loosen both of the nuts slightly on
all the mounting points to be adjusted.
●Adjust the position of the mounting points
along the tracks as required.
●Use the 3mm (1/8") Hex Key to hold the T-
bolt in a stationary position and ensure the
T-bolt has correct engagement.
●Using the 10mm (3/8") spanner supplied,
tighten the nut to 5Nm (3.7 ft lb).
●Use keys to remove covers.
6
Track System EN
Q19
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Remove both pins from each leg. Use
tapered end of spanner located inside left
hand cover to assist.
●Detach foot from leg. Store loose parts in a
safe place.
●Repeat for all legs.
7
Track System EN
Q19
●Assemble foot from kit into leg.
●Insert pins through foot into leg.
●Repeat for all legs.
●Select plastic internal block (from fitting kit)
and insert into foot.
8
Track System EN
Q19
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Set bars to length so that the mounting
holes will line up (refer to the crossbar
instructions for crossbar adjustment).
9
Track System EN
Q19
●Place crossbars over mounting assembly
on tracks.
●Tighten the plastic knob.
●Ensure the plastic knob is in the position
shown when fully tightened.
●Repeat for all four positions.
10
Table of contents
Other Prorack Automobile Accessories manuals
Prorack
Prorack K453 User manual
Prorack
Prorack K730 User manual
Prorack
Prorack K823 User manual
Prorack
Prorack K926 Operation and installation manual
Prorack
Prorack EXP360 User manual
Prorack
Prorack K163 User manual
Prorack
Prorack K198 Operation and installation manual
Prorack
Prorack K138 User manual
Prorack
Prorack PR3104 User manual
Prorack
Prorack PR3075 User manual
Prorack
Prorack K120 User manual
Prorack
Prorack K624 Operation and installation manual
Prorack
Prorack K358 User manual
Prorack
Prorack K800 User manual
Prorack
Prorack K1074 User manual
Prorack
Prorack K508 User manual
Prorack
Prorack K564 User manual
Prorack
Prorack K127 User manual
Prorack
Prorack K671 User manual
Prorack
Prorack K805 User manual
