Prorack K998 User manual
K998
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 2 x 2 x 4 x 4
x 4 x 4 x 4
Revision No: 3C 1
Fitting Kit K998
MAX kgs (lbs)
W/P WHD
Nissan
NV350 High Roof, 5dr Van 12-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
NV350 High Roof, 5dr Van 12-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
NV350 Low Roof, 5dr Van 12-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
NV350 Low Roof, 5dr Van 12-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K998
X
A B C 1 2 3
NV350 High Roof, 5dr Van 12-+ (AU) 800mm 1650mm - 840mm 840mm -
31 1/2ths" 64 15/16ths" - 33 1/16ths" 33 1/16ths" -
NV350 High Roof, 5dr Van 12-+ (NZ) 800mm 1650mm - 840mm 840mm -
31 1/2ths" 64 15/16ths" - 33 1/16ths" 33 1/16ths" -
NV350 Low Roof, 5dr Van 12-+ (NZ) 800mm 1650mm - 1020mm 1020mm -
31 1/2ths" 64 15/16ths" - 40 3/16ths" 40 3/16ths" -
NV350 Low Roof, 5dr Van 12-+ (AU) 800mm 1650mm - 1020mm 1020mm -
31 1/2ths" 64 15/16ths" - 40 3/16ths" 40 3/16ths" -
3
Fitting Kit EN
K998
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●Use keys to remove covers.
4
Fitting Kit EN
K998
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
●Please check the front of this manual for
information relating specifically to your
vehicle.
5
Fitting Kit EN
K998
●Tighten adjusting screw to 2 Nm (1.5 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
6
Fitting Kit EN
K998
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 267
B = 268
●Note: Pads may be different to that shown.
●Make sure the pad fits into the holes
underneath the foot.
Fitment
●Remove fixed-point cover.
7
Fitting Kit EN
K998
●Use the following grubscrew lengths for
each position:
A = M8 x 80 mm (3 1/8")
●Screw M8 grubscrew into fixed-point,
leaving 60mm (2 3/8") visible.
●Place M8 washer over grubscrew.
●Fit nut to grubscrew.
●Tighten firmly.
8
Fitting Kit EN
K998
●Place crossbar foot over clamp.
●Tighten the plastic knob.
●In the fully tightened position, the knobs
should be parallel with the vehicle.
●Repeat for all positions.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
9
Fitting Kit EN
K998
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Table of contents
Other Prorack Automobile Accessories manuals
Prorack
Prorack WHISPBAR S55 Operation and installation manual
Prorack
Prorack K708 User manual
Prorack
Prorack K488 User manual
Prorack
Prorack K570 User manual
Prorack
Prorack K594 User manual
Prorack
Prorack K412 User manual
Prorack
Prorack K018 User manual
Prorack
Prorack K188 User manual
Prorack
Prorack K448 Operation and installation manual
Prorack
Prorack K890 User manual
Prorack
Prorack PR3077 User manual
Prorack
Prorack K991 User manual
Prorack
Prorack K1027 User manual
Prorack
Prorack PR3104 User manual
Prorack
Prorack K483 User manual
Prorack
Prorack K692 User manual
Prorack
Prorack K382 User manual
Prorack
Prorack K607 User manual
Prorack
Prorack K109 User manual
Prorack
Prorack K603 User manual
