Konica Minolta CF2002 Manual

4581-7777-01 © MINOLTA CO., LTD. Printed in Japan

SETUP INSTRUCTIONS

PRINTER PANEL 1

CF2002/CF3102 Printer

WARNING

• Do not plug in the power cord or turn on this unit until you are instructed to according to this manual.

CAUTION

• Install this machine so that it can quickly be unplugged from the electrical outlet in case of an

emergency. The socket-outlet shall be installed near the machine and shall be easily accessible.

• Keep all packing materials out of the reach of children.

NOTE

• Keep all packing materials in a safe place for later use in case they are needed for transportation.

Printer Panel 1

– 1 –

4581-7777-01

1. Outline of the CF2002/CF3102 System Setup

These Setup Instructions describe the setup for the parts marked in grey in the flowchart

shown below.

When setting up a system consisting of the printer and its various options, perform the

setup according to the procedure described below.

NOTE

•Install and setup each option according to the instructions included with the option.

•For information on adjusting the PF-118, PF-121 and AD-14, refer to the section

“Adjusting the Options”on pages 27 to 31 of these Setup Instructions.

9. Mechanical Counter

7. Duplex Unit AD-14

5. Control Panel

4. Printer

1. Copy Table CT-2

2-C. Copy Desk CD-2M

2-A. Paper Feed Unit PF-118 2-B. Large Capacity Cabinet

PF-121

3-A. Dehumidifying Heater

6. Printer Controller/

Interface kit 10-A. Finisher FN-8 10-B. Finisher FN-116

3-B. Dehumidifying Heater

*: U.S.A and Canada only

4: Printer

Unpack the unit, install it, adjust it using the servicing equipment, and

then calibrate the gradation levels with the X-Rite.

5: Control Panel

Attach the control panel to the printer.

6: Printer Controller/Interface Kit

Attach the printer controller, and then specify the necessary settings.

8. Data Terminal DT-105*

11-A. Punch KIT PK-4 11-B. Option tray JS-100

C4581U019AA

Printer Panel 1

– 2 –

4581-7777-01

1.1 Precautions Concerning the Package Contents (Manuals)

The following manuals for the products listed below are included.

NOTE

Manuals that cannot be used with the printer are also included.

■

■■

■Printer

• User Manual for a copier*

• Setup Instructions for a copier*

■

■■

■Printer Panel 1

• User Manual for a printer (including information on PageScope Light)

• Setup Instructions for a printer (this manual, including information on the printer con-

troller and interface kit)

■

■■

■Interface Kit P

• User Manual for a copier (PageScope Light and Scan mode)*

• Installation Guide for a copier (printer controller and interface kit P)*

■

■■

■Controller

• Controller User Manual

*:Cannot be used with the CF2002/CF3102 printer.

1.2 Precautions Concerning the Installation of the Controller

When installing the printer controller onto a printer that has the duplex unit attached, the

printer memory must have 512 MB.

Printer Panel 1

–3 –

4581-7777-01

2. Unpacking

2.1 Unpacking the Accessories

Remove the accessories from the box, and then check that the following are enclosed.

(1) Imaging units..................................................................................................... 4

(2) Power cord *1.................................................................................................... 1

(3) LED cleaning tool *2.......................................................................................... 1

(4) LED cleaning paper *2 ...................................................................................... 1

(5) Manual holder ................................................................................................... 1

(6) User Manual...................................................................................................... 1

(7) Setup Instructions ............................................................................................. 1

(8) Warranty card *3 ............................................................................................... 1

(9) Power cord instruction *1 .................................................................................. 1

(10) Paper size label................................................................................................. 1

(11) Cable clamp ...................................................................................................... 1

(12) Cap.................................................................................................................... 1

*1 For Particular area only.

*2 The LED cleaning tool and its paper are not used during setup. Since they will be

needed when the transfer belt unit is changed or the printer is cleaned, keep them

in a safe place for later use.

*3 U.S.A. and Canada only.

2.2 Unpacking the Printer

1. Open the printer box, and then remove the box containing the imaging unit.

2. Open the two handle covers, and then pull out the handles.

4025U018AA

3. Grasp the two handles on the right side of

the printer and the two grips on the left (as

shown in the illustration), and then, while

keeping the printer level, remove it from its

box.

NOTE

The printer weighs about 85 kg (187-1/4 lbs.).

The printer must be lifted by at least two peo-

ple.

4025U019AA

Printer Panel 1

–4 –

4581-7777-01

2.3 Removing the Protective Tape and Packing Materials

1. Remove the tape affixed to the outside sur-

face of the printer.

4025U020AA

4025U021AA

Paper take-up

roller

Packing

material

2. Slide out the 1st drawer and remove protec-

tive tape and packing materials from the

inside of the drawer.

3. Close the paper drawer.

C4004U024AA

4. Slide out the 2nd drawer and remove protec-

tive tape and packing materials from the

inside of the drawer.

5. Close the paper drawer.

C4004U026AB

Paper take-up

roller

Packing

material

Ta p e s

Printer Panel 1

–5 –

4581-7777-01

3. Installing the Unit

3.1 Installing the Imaging Unit

1. Open the front door.

2. Pinch the Imaging Unit release lever for Yel-

low and pull it down forward.

C4004U047AA

3. Slide out the protective material.

4025U022AA

4. Take out the Yellow Imaging Unit from the

Imaging Unit carton.

5. Remove the Imaging Unit from its aluminum

package.

6. Remove protective tape and packing mate-

rial.

NOTE

Do not peel off the interference preventive

sheet.

4025U074AC

Protective tape

Interference

preventive sheet

Packing

material

7. Tilt the Imaging Unit to the left and, in that

condition, shake it over a small stroke twice.

Then, tilt the Imaging Unit to the right and, in

that condition, shake it over a small stroke

twice.

4025U024AA

8. Support the Imaging Unit with both hands

and hold it levelly.

4025U026AC

Printer Panel 1

–6 –

4581-7777-01

9. Keeping the Imaging Unit in the level posi-

tion, insert the Imaging Unit into the mount-

ing position on the printer until its leading

edge is stopped.

Make sure that the interference preventive

sheet is left attached to the Imaging Unit

when the Imaging Unit is inserted into the

printer.

NOTE

Make sure the protective sheet is rolled up into

the Imaging Unit, then insert Imaging Unit into

the Printer.

4025U027AA

10. Check that the Imaging Unit is inserted posi-

tively in position.

NOTE

The positioning rib at the leading edge of the

Imaging Unit cover should be fitted positively

in the hole in the mounting position on the

printer.

4025U028AC

11. Supporting the underside of the Imaging

Unit with your left hand, hold the portion of

the unit shown in the illustration with your

right hand and gently push it into position

until a click is heard.

4025U029AB

12. Pull out the empty Imaging Unit cover.

4025U030AB

13. Push the Imaging Unit release lever of Yel-

low all the way until a click is heard.

14. Using the same procedure, install all Imag-

ing Units.

4025U031AA

Printer Panel 1

–7 –

4581-7777-01

3.2 Installing the Toner Cartridge and the Filter

NOTE

Toner does not come with the printer. Purchase toner cartridges (of different colors) sep-

arately available.

1. Open the front door.

2. Holding the toner cartridge firmly, shake it

well vertically and horizontally to agitate

toner.

C4025O220AB

3. Remove the protective tape.

C4025O221AB

4. Swing the fixing lever downward.

5. Load the toner cartridge in position.

(Make sure that the gear is on the rear side.)

4025U038AA

6. Swing the fixing lever upward to fix the toner

cartridges in position.

* Make sure that the fixing lever is positively

swung into position.

7. Using the same procedure, install the toner

cartridges for other colors of toner.

4025U039AA

8. Take out the filter and install it in position.

NOTE

The filter is packed in the box of a black toner

cartridges.

C4025U001AA

Printer Panel 1

–8 –

4581-7777-01

4. Affixing the Label 5. Installing the Manual Holder

Label 1. Affix the label on the right side of the top of

the front door.

NOTE

Affix the label that corresponds with the

installed options.

C4004U589AA

1. Insert the tab on the bottom of the manual

holder into the slot in the printer as shown in

the illustration.

C4004U553AA

2. Insert the tabs on the left and right sides of

the manual holder into the corresponding

slots in the printer.

C4004U554AA

NOTE

If the optional finisher is used, attach the man-

ual holder to the back of the finisher at the

position shown, using the same procedure

described above.

C4004U098AA

Printer Panel 1

–9 –

4581-7777-01

6. Connecting the Cables

1. Make sure that the printer power cord is not

plugged into the electrical outlet, and then

insert the plug on the end of the power cord

into the power cord connector on the printer.

C4581U021AA

2. Insert the plug on the other end of the power

cord into an electrical outlet.

C4004U139CA

This manual suits for next models

Table of contents

Other Konica Minolta Printer manuals

Konica Minolta

Konica Minolta bizhub 43 User manual

Konica Minolta

Konica Minolta A0VD011 Original instructions

Konica Minolta

Konica Minolta AccurioPress C3080 User manual

Konica Minolta

Konica Minolta Magicolor 2350 EN User manual

Konica Minolta

Konica Minolta BIZHUB C353P User manual

Konica Minolta

Konica Minolta Magicolor 24 0 Series User manual

Konica Minolta

Konica Minolta AccurioPress 6136 User manual

Konica Minolta

Konica Minolta bizhub 552 Manual

Konica Minolta

Konica Minolta BIZHUB PRO C6500 User manual

Konica Minolta

Konica Minolta PagePro 1380 MF User manual

Konica Minolta

Konica Minolta magicolor 1650EN User manual

Konica Minolta

Konica Minolta accuriopress c6100 User manual

Konica Minolta

Konica Minolta PAGEPRO 4650EN User manual

Konica Minolta

Konica Minolta Magicolor 6100 User manual

Konica Minolta

Konica Minolta DRYPRO 771 User manual

Konica Minolta

Konica Minolta Magicolor 5550 User manual

Konica Minolta

Konica Minolta magicolor 7450 User manual

Konica Minolta

Konica Minolta AccurioPrint 2100 User manual

Konica Minolta

Konica Minolta bizhub 3301P User manual

Konica Minolta

Konica Minolta magicolor 2550DN A00V014 User manual

Konica Minolta

Konica Minolta bizhub press c1060 User manual

Konica Minolta

Konica Minolta PagePro 1400W User manual

Konica Minolta

Konica Minolta magicolor 1600W User manual

Konica Minolta

Konica Minolta bizhub 20 User manual

Popular Printer manuals by other brands

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series quick start guide

Evolis

Evolis Elypso user guide

Kyocera

Kyocera FS-9530DN specification

Canon

Canon LASER SHOT LBP-1210 Specifications

Samsung

Samsung BIXOLON SRP-350plusF user manual

Canon

Canon PIXMA PRO-1 Series Getting started

Canon

Canon PIXMA G3560 Online manual

Dell

Dell Color Laser Printer 2130cn user guide

Tektronix

Tektronix Phaser 840 user guide

Epson

Epson ET-7750 Programming guide

Canon

Canon CLBR 460ps Service manual

Eltron

Eltron P210 Guide manual

Ricoh

Ricoh MD-P1 Service manual

Epson

Epson SC-F7100 series user guide

Epson

Epson Stylus C40UX Service manual

Canon

Canon imagePASS-A2 Service guide

Canon

Canon S820D user guide