Kitronik 5628 Manual
INTERFACE BOARD
FOR USE WITH
SERVO:LITE BOARD
Lay your Servo:Lite board on
a flat surface and proceed to
remove all 5 screws holding
the micro:bit in place.
BUILD INSTRUCTIONS
1
NOTE: Make sure to hold the components in place
as this will make the next step easier.
Place the Interface board
on top of the micro:bit
as shown, lining up the
contacts on the rear of
the board with the pads on
the micro:bit and insert the
longer M3x10mm screws
provided.
2
Once the Interface board has been fitted to the
Servo:Lite board, it can be installed into the :MOVE
mini. Connect the servos and slot the lower tab of
the Interface board into the slot in the base of the
:MOVE mini and push backwards to snap into place.
1
GET CODING!
Visit kitronik.co.uk/5628
for help.
2
USE WITH :MOVE MINI
For more information on RoHs and CE please visit kitronik.co.uk/
rohs-ce. Children assembling this product should be supervised by
a competent adult. The product contains small parts so should be
kept out of reach of children under 3 years old.
:
TOOLS REQUIRED:
- Small Phillips Screwdriver
STOCK CODE
5628
Other Kitronik Motherboard manuals
